STM32F7xx devices need faster clock for flash programming
over JTAG transport. Using reset default 16 MHz clock
resulted in lot of DAP WAITs and substantial decrease
of flashing performance.
Adapted to the restructured dap support
(see 2231da8ec4).
Change-Id: Ida6915331dd924c9c0d08822fd94c04ad408cdc5
Signed-off-by: Tomas Vanek <vanekt@fbl.cz>
Reviewed-on: http://openocd.zylin.com/4464
Tested-by: jenkins
Reviewed-by: Christopher Head <chead@zaber.com>
Prerequisites:
The users of OpenOCD as well as computer programs interacting with OpenOCD are expecting that certain commands
do the same thing across all the targets.
Rules to follow when writing scripts:
1. The configuration script should be defined such as , for example, the following sequences are working:
reset
flash info <bank>
and
reset
flash erase_address <start> <len>
and
reset init
load
In most cases this can be accomplished by specifying the default startup mode as reset_init (target command
in the configuration file).
2. If the target is correctly configured, flash must be writable without any other helper commands. It is
assumed that all write-protect mechanisms should be disabled.
3. The configuration scripts should be defined such as the binary that was written to flash verifies
(turn off remapping, checksums, etc...)
flash write_image [file] <parameters>
verify_image [file] <parameters>
4. adapter_khz sets the maximum speed (or alternatively RCLK). If invoked
multiple times only the last setting is used.
interface/xxx.cfg files are always executed *before* target/xxx.cfg
files, so any adapter_khz in interface/xxx.cfg will be overridden by
target/xxx.cfg. adapter_khz in interface/xxx.cfg would then, effectively,
set the default JTAG speed.
Note that a target/xxx.cfg file can invoke another target/yyy.cfg file,
so one can create target subtype configurations where e.g. only
amount of DRAM, oscillator speeds differ and having a single
config file for the default/common settings.
20d18d415d