The LBLCR entries should use svc->af, not dest->af.
Needed to support svc->af != dest->af.
Signed-off-by: Julian Anastasov <ja@ssi.bg>
Signed-off-by: Alex Gartrell <agartrell@fb.com>
Signed-off-by: Simon Horman <horms@verge.net.au>
The LBLC entries should use svc->af, not dest->af.
Needed to support svc->af != dest->af.
Signed-off-by: Julian Anastasov <ja@ssi.bg>
Signed-off-by: Alex Gartrell <agartrell@fb.com>
Signed-off-by: Simon Horman <horms@verge.net.au>
Pull the common logic for preparing an skb to prepend the header into a
single function and then set fields such that they can be used in either
case (generalize tos and tclass to dscp, hop_limit and ttl to ttl, etc)
Signed-off-by: Alex Gartrell <agartrell@fb.com>
Acked-by: Julian Anastasov <ja@ssi.bg>
Signed-off-by: Simon Horman <horms@verge.net.au>
The out_rt functions check to see if the mtu is large enough for the packet
and, if not, send icmp messages (TOOBIG or DEST_UNREACH) to the source and
bail out. We needed the ability to send ICMP from the out_rt_v6 function
and DEST_UNREACH from the out_rt function, so we just pulled it out into a
common function.
Signed-off-by: Alex Gartrell <agartrell@fb.com>
Acked-by: Julian Anastasov <ja@ssi.bg>
Signed-off-by: Simon Horman <horms@verge.net.au>
Another step toward heterogeneous pools, this removes another piece of
functionality currently specific to each address family type.
Signed-off-by: Alex Gartrell <agartrell@fb.com>
Acked-by: Julian Anastasov <ja@ssi.bg>
Signed-off-by: Simon Horman <horms@verge.net.au>
This logic is repeated in both out_rt functions so it was redundant.
Additionally, we'll need to be able to do checks to route v4 to v6 and vice
versa in order to deal with heterogeneous pools.
This patch also updates the callsites to add an additional parameter to the
out route functions.
Signed-off-by: Alex Gartrell <agartrell@fb.com>
Acked-by: Julian Anastasov <ja@ssi.bg>
Signed-off-by: Simon Horman <horms@verge.net.au>
The synchronization protocol is not compatible with heterogeneous pools, so
we need to verify that we're not turning both on at the same time.
Signed-off-by: Alex Gartrell <agartrell@fb.com>
Acked-by: Julian Anastasov <ja@ssi.bg>
Signed-off-by: Simon Horman <horms@verge.net.au>
The assumption that dest af is equal to service af is now unreliable, so we
must specify it manually so as not to copy just the first 4 bytes of a v6
address or doing an illegal read of 16 butes on a v6 address.
We "lie" in two places: for synchronization (which we will explicitly
disallow from happening when we have heterogeneous pools) and for black
hole addresses where there's no real dest.
Signed-off-by: Alex Gartrell <agartrell@fb.com>
Acked-by: Julian Anastasov <ja@ssi.bg>
Signed-off-by: Simon Horman <horms@verge.net.au>
Part of a series of diffs to tease out destination family from virtual
family. This diff just adds a parameter to ip_vs_trash_get and then uses
it for comparison rather than svc->af.
Signed-off-by: Alex Gartrell <agartrell@fb.com>
Acked-by: Julian Anastasov <ja@ssi.bg>
Signed-off-by: Simon Horman <horms@verge.net.au>
We need to remove the assumption that virtual address family is the same as
real address family in order to support heterogeneous services (that is,
services with v4 vips and v6 backends or the opposite).
Signed-off-by: Alex Gartrell <agartrell@fb.com>
Acked-by: Julian Anastasov <ja@ssi.bg>
Signed-off-by: Simon Horman <horms@verge.net.au>
This is necessary to support heterogeneous pools. For example, if you have
an ipv6 addressed network, you'll want to be able to forward ipv4 traffic
into it.
This patch enforces that destination address family is the same as service
family, as none of the forwarding mechanisms support anything else.
For the old setsockopt mechanism, we simply set the dest address family to
AF_INET as we do with the service.
Signed-off-by: Alex Gartrell <agartrell@fb.com>
Acked-by: Julian Anastasov <ja@ssi.bg>
Signed-off-by: Simon Horman <horms@verge.net.au>
Add simple weighted IPVS failover support to the Linux kernel. All
other scheduling modules implement some form of load balancing, while
this offers a simple failover solution. Connections are directed to
the appropriate server based solely on highest weight value and server
availability. Tested functionality with keepalived.
Signed-off-by: Kenny Mathis <kmathis@chokepoint.net>
Acked-by: Julian Anastasov <ja@ssi.bg>
Signed-off-by: Simon Horman <horms@verge.net.au>
Users are starting to test nf_tables with no x_tables support. Therefore,
masquerading needs to be indenpendent of it from Kconfig.
Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>
Now that we have masquerading support in nf_tables, the NAT chain can
be use with it, not only for SNAT/DNAT. So make this chain type
independent of it.
While at it, move it inside the scope of 'if NF_NAT_IPV*' to simplify
dependencies.
Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>
CONFIG_NF_NAT_MASQUERADE_IPV6=m
# CONFIG_IP6_NF_TARGET_MASQUERADE is not set
results in:
net/ipv6/netfilter/nf_nat_masquerade_ipv6.c: In function ‘nf_nat_masquerade_ipv6’:
net/ipv6/netfilter/nf_nat_masquerade_ipv6.c:41:14: error: ‘struct nf_conn_nat’ has no member named ‘masq_index’
nfct_nat(ct)->masq_index = out->ifindex;
^
net/ipv6/netfilter/nf_nat_masquerade_ipv6.c: In function ‘device_cmp’:
net/ipv6/netfilter/nf_nat_masquerade_ipv6.c:61:12: error: ‘const struct nf_conn_nat’ has no member named ‘masq_index’
return nat->masq_index == (int)(long)ifindex;
^
net/ipv6/netfilter/nf_nat_masquerade_ipv6.c:62:1: warning: control
reaches end of non-void function [-Wreturn-type]
}
^
make[3]: *** [net/ipv6/netfilter/nf_nat_masquerade_ipv6.o] Error 1
Fix this by using the new NF_NAT_MASQUERADE_IPV4 and _IPV6 symbols
in include/net/netfilter/nf_nat.h.
Reported-by: Jim Davis <jim.epost@gmail.com>
Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>
Since BPF JIT depends on the availability of module_alloc() and
module_free() helpers (HAVE_BPF_JIT and MODULES), we better build
that code only in case we have BPF_JIT in our config enabled, just
like with other JIT code. Fixes builds for arm/marzen_defconfig
and sh/rsk7269_defconfig.
====================
kernel/built-in.o: In function `bpf_jit_binary_alloc':
/home/cwang/linux/kernel/bpf/core.c:144: undefined reference to `module_alloc'
kernel/built-in.o: In function `bpf_jit_binary_free':
/home/cwang/linux/kernel/bpf/core.c:164: undefined reference to `module_free'
make: *** [vmlinux] Error 1
====================
Reported-by: Fengguang Wu <fengguang.wu@intel.com>
Fixes: 738cbe72ad ("net: bpf: consolidate JIT binary allocator")
Signed-off-by: Daniel Borkmann <dborkman@redhat.com>
Acked-by: Alexei Starovoitov <ast@plumgrid.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Hariprasad Shenai says:
====================
cxgb4: Allow FW size upto 1MB, support for S25FL032P flash and misc. fixes
This patch series adds support to allow FW size upto 1MB, support for S25FL032P
flash. Fix t4_flash_erase_sectors to throw an error, when erase sector aren't in
the flash and also warning message when adapters have flashes less than 2Mb.
Adds device id of new adapter and removes device id of debug adapter.
The patches series is created against 'net-next' tree.
And includes patches on cxgb4 driver and cxgb4vf driver.
We have included all the maintainers of respective drivers. Kindly review the
change and let us know in case of any review comments.
====================
Signed-off-by: David S. Miller <davem@davemloft.net>
Add support for Spansion S25FL032P flash
Based on original work by Dimitris Michailidis
Signed-off-by: Hariprasad Shenai <hariprasad@chelsio.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
This fixes the following sparse warnings:
sparse: symbol 'tipc_update_nametbl' was not declared. Should it be static?
Also, the function is changed to return bool upon success, rather than a
potentially freed pointer.
Signed-off-by: Erik Hugne <erik.hugne@ericsson.com>
Reported-by: Dan Carpenter <dan.carpenter@oracle.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Free resources before being disconnected from phy and calling core driver is
wrong and should not happen. It avoids a delay of 4-5s caused by the timeout of
phy_disconnect().
Signed-off-by: Romain Perier <romain.perier@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Julian Anastasov
Alex Gartrell
Kenny Mathis
Pablo Neira Ayuso
Daniel Borkmann
David S. Miller
Hariprasad Shenai
Erik Hugne
Romain Perier