Input: add support for the DRV2667 haptic driver

Adding support for the DRV2667 haptic driver.  This device has the ability
to store vibration patterns in RAM and execute them once the GO bit is set.

The initial driver sets a basic waveform in the first waveform sequence and
will play the waveform when the GO bit is set and will continously play the
waveform until the GO bit is unset.

Data sheet is here: http://www.ti.com/product/drv2667

Signed-off-by: Dan Murphy <dmurphy@ti.com>
Signed-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com>

Documentation/devicetree/bindings/input/ti,drv2667.txt

@@ -0,0 +1,17 @@
+* Texas Instruments - drv2667 Haptics driver
+
+Required properties:
+	- compatible - "ti,drv2667" - DRV2667
+	- reg -  I2C slave address
+	- vbat-supply - Required supply regulator
+
+Example:
+
+haptics: haptics@59 {
+	compatible = "ti,drv2667";
+	reg = <0x59>;
+	vbat-supply = <&vbat>;
+};
+
+For more product information please see the link below:
+http://www.ti.com/product/drv2667

drivers/input/misc/Kconfig

@@ -687,4 +687,15 @@ config INPUT_DRV260X_HAPTICS
 	  To compile this driver as a module, choose M here: the
 	  module will be called drv260x-haptics.
 
+config INPUT_DRV2667_HAPTICS
+	tristate "TI DRV2667 haptics support"
+	depends on INPUT && I2C
+	select INPUT_FF_MEMLESS
+	select REGMAP_I2C
+	help
+	  Say Y to enable support for the TI DRV2667 haptics driver.
+
+	  To compile this driver as a module, choose M here: the
+	  module will be called drv260x-haptics.
+
 endif

drivers/input/misc/Makefile

@@ -27,6 +27,7 @@ obj-$(CONFIG_INPUT_DA9052_ONKEY)	+= da9052_onkey.o
 obj-$(CONFIG_INPUT_DA9055_ONKEY)	+= da9055_onkey.o
 obj-$(CONFIG_INPUT_DM355EVM)		+= dm355evm_keys.o
 obj-$(CONFIG_INPUT_DRV260X_HAPTICS)	+= drv260x.o
+obj-$(CONFIG_INPUT_DRV2667_HAPTICS)	+= drv2667.o
 obj-$(CONFIG_INPUT_GP2A)		+= gp2ap002a00f.o
 obj-$(CONFIG_INPUT_GPIO_BEEPER)		+= gpio-beeper.o
 obj-$(CONFIG_INPUT_GPIO_TILT_POLLED)	+= gpio_tilt_polled.o