arm11
--- Added burst memory transfer mode
This does not explicitly query command execution but rather uses a small
delay produced by the FT2232 on certain TAP commands.
A potential failure of this process is detected afterwards and the
program terminates with an error.
'arm11 memwrite burst disable'
can be used to switch this feature off.
'arm11 memwrite error_fatal disable'
can be used to prevent the program to exit on an memory write error
--- Added support for interrupt breaking via VCR register
Use 'arm11 vcr' command to set.
--- Cleaned up the handling of
halt/resume/step/poll, target->state, target->debug_reason,
target_call_event_callbacks() at least as far as I could guess the
intended behaviour from other targets.
Did some overall positive tests with GDB.
--- Added support for breakpoints
Hardware breakpoints only. All breakpoints will be treated as hardware
breakpoints.
All ARM11's seem to have at least 6 hardware breakpoints.
--- Stepping over BKPT added
Modification to PC without touching the target.
--- Stepping over a B or BL to self will do nothing
git-svn-id: svn://svn.berlios.de/openocd/trunk@385 b42882b7-edfa-0310-969c-e2dbd0fdcd60
- fix indentation of multi-level commands
- make help command work with multi-level commands
git-svn-id: svn://svn.berlios.de/openocd/trunk@384 b42882b7-edfa-0310-969c-e2dbd0fdcd60
already in the README or texinfo (and which needs to be updated
relatively often -- list of authors, list of supported JTAG devices etc).
git-svn-id: svn://svn.berlios.de/openocd/trunk@379 b42882b7-edfa-0310-969c-e2dbd0fdcd60
this patch fixes an issue in jtag_init - shall not reset jtag to NULL.
This causes jtag interface (USB device) not to be closed properly if jtag chain validation fails.
Once the underlaying jtag interface is initialized, jtag pointer shall be left untouched,
even in case of an error, so that proper cleanup can be done, see exit_handler in openocd.c
git-svn-id: svn://svn.berlios.de/openocd/trunk@372 b42882b7-edfa-0310-969c-e2dbd0fdcd60
provides a better impeadance match for debug output char fn's, e.g. eCos.
- Line endings are now added at the caller site of command_print*(). command_print()
still adds a line ending
- echo of commands in scripts are now available via debug_level instead of
forced echo
- Added a USER_SAMELINE() for printing without a lineend.
git-svn-id: svn://svn.berlios.de/openocd/trunk@364 b42882b7-edfa-0310-969c-e2dbd0fdcd60
