tests/qtest: Add STM32L4x5 GPIO QTest testcase

The testcase contains :
- `test_idr_reset_value()` :
Checks the reset values of MODER, OTYPER, PUPDR, ODR and IDR.
- `test_gpio_output_mode()` :
Checks that writing a bit in register ODR results in the corresponding
pin rising or lowering, if this pin is configured in output mode.
- `test_gpio_input_mode()` :
Checks that a input pin set high or low externally results
in the pin rising and lowering.
- `test_pull_up_pull_down()` :
Checks that a floating pin in pull-up/down mode is actually high/down.
- `test_push_pull()` :
Checks that a pin set externally is disconnected when configured in
push-pull output mode, and can't be set externally while in this mode.
- `test_open_drain()` :
Checks that a pin set externally high is disconnected when configured
in open-drain output mode, and can't be set high while in this mode.
- `test_bsrr_brr()` :
Checks that writing to BSRR and BRR has the desired result in ODR.
- `test_clock_enable()` :
Checks that GPIO clock is at the right frequency after enabling it.

Acked-by: Thomas Huth <thuth@redhat.com>
Signed-off-by: Arnaud Minier <arnaud.minier@telecom-paris.fr>
Signed-off-by: Inès Varhol <ines.varhol@telecom-paris.fr>
Message-id: 20240305210444.310665-4-ines.varhol@telecom-paris.fr
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>

tests/qtest/meson.build

@@ -204,7 +204,8 @@ qtests_aspeed = \
 qtests_stm32l4x5 = \
   ['stm32l4x5_exti-test',
    'stm32l4x5_syscfg-test',
-   'stm32l4x5_rcc-test']
+   'stm32l4x5_rcc-test',
+   'stm32l4x5_gpio-test']
 
 qtests_arm = \
   (config_all_devices.has_key('CONFIG_MPS2') ? ['sse-timer-test'] : []) + \