Add options about Internal RC(IRC) oscillator.
- GD32_HAS_IRC_32K/40K indicates IRC types.
- GD32_LOW_SPEED_IRC_FREQUENCY is the numeric value of frequency
Signed-off-by: TOKITA Hiroshi <tokita.hiroshi@gmail.com>
Enable ticker ticks slow window extensions implementation
when broadcaster role is enabled. This feature moves the
primary channel advertising event within the specified
window when overlapping with other roles.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Linker scripts contains a `.last_section` section that is placed in rom
region as NOLOAD for the purpose of retrieve the actual number of bytes
contained in the image. See d85efe0b10
However, a previous section may cause the location counter to be
incremented for alignment purposes. This can result in the size of the
image to be 0x10FA but location counter to be 0x1100 because it has been
aligned for next section placement.
Therefore, two new Kconfig settings are introduced.
Those settings request the linker to will write a pattern in
`.last_section`. Together with removing NOLOAD and writing a patten to
the section then we ensure that data is written after alignment of
location counter, and thereby forces the image size to be in sync with
the location counter.
The default pattern used will be 0xE015 (end of last section).
Some systems may fill up the flash completely, or simply write data at
the end of the flash, which in both cases can result in overflow.
Therefore, the new settings can be disabled.
Signed-off-by: Torsten Rasmussen <Torsten.Rasmussen@nordicsemi.no>
Enable 4 bit bus width for high speed cards, so that host and card
combinations that cannot use UHS mode will still benefit from the
speed increase of using 4 data lines.
Signed-off-by: Daniel DeGrasse <daniel.degrasse@nxp.com>
When adding nodelabels to shields devices, it should be taken car not to
use forbidden characters.
Fix existing occurrence.
Signed-off-by: Erwan Gouriou <erwan.gouriou@linaro.org>
Shield's nodelabels should now be in the form <device>_<shield_name>.
This occurrence was left out in the initial change.
Signed-off-by: Erwan Gouriou <erwan.gouriou@linaro.org>
Tests will be restructured in a future commit. Temporarily disabled to
partition the changes to allow tests to be a separate PR.
Signed-off-by: Nirosharn Amarasinghe <niag@demant.com>
Implemented:
-- Combining segments from multiple SDUs in a single PDU for TX
-- Release of PDU based on remaining capacity below threshold
-- Release of any PDUs in production on receiving a timeout for the
upcoming event
-- Release of PDUs in production if source if destroyed
-- Synchronization flag to exclude multiple contexts in ISO-AL
-- New Kconfig BT_CTLR_ISO_TX_SEG_PLAYLOAD_MIN to allow definition of
minimum TX segment size
Signed-off-by: Nirosharn Amarasinghe <niag@demant.com>
Implements:
-- SDU fragments can be buffered in the ISO-AL so that the correct size
of the SDU can be computed such that it can be released for inclusion
in the first fragment's header
-- Changed SDU emit interface to allow the same structure to be used to
buffer as well as release fragments
-- New configuration BT_CTLR_ISO_RX_SDU_BUFFERS to specify the number of
SDU buffers for each sink
(Buffering disabled when BT_CTLR_ISO_RX_SDU_BUFFERS=0)
Signed-off-by: Nirosharn Amarasinghe <niag@demant.com>
Implemented:
-- Storing information required to service HCI_LE_Read_ISO_TX_Sync
request
-- Implemented interface to retrieve information
-- Cleared ISO-AL source and sink state on deallocation
-- Renamed cig_ref_point to grp_ref_point as it serves a common purpose
in both CIS and BIS
Signed-off-by: Nirosharn Amarasinghe <niag@demant.com>
Improvement for IAL/CIS/FRA/PER/BI-01-C & IAL/CIS/FRA/PER/BI-02-C
-- Test appears to fail as the transmitted PDU is packed with less data
than is indicated in the segment headers.
-- Guards were included to verify that sufficient data exists in the PDU
before extracting the segment.
General
-- Updated timestamps in error SDUs to better approximate the expected
timestamps if time information is missing.
Signed-off-by: Nirosharn Amarasinghe <niag@demant.com>
This nodelabel was changed while converting all shields to new nodelabel
scheme.
On this particular nodelabel, there was no change to be done, as it doesn't
refer to a node defined in the shield.
Revert this chagne.
Signed-off-by: Erwan Gouriou <erwan.gouriou@linaro.org>
This commit updates the CI workflows to use the CI image 0.24.3, in
order to pull in the LLVM/Clang 15 and Renode 1.13.1.
Signed-off-by: Stephanos Ioannidis <root@stephanos.io>
This commit removes stale clang-related variables that are not used by
the footprint-tracking workflow.
Signed-off-by: Stephanos Ioannidis <root@stephanos.io>
This commit removes stale clang-related variables that are not used by
the bluetooth-tests workflow.
Signed-off-by: Stephanos Ioannidis <root@stephanos.io>
