Impact: Resolves build failures in some configurations
Makes it possible to disable CONFIG_RD_GZIP . In that case, the
built-in initramfs will be compressed by whatever compressor is
available (bzip2 or lzma) or left uncompressed if none is available.
It also removes a couple of warnings which occur when no ramdisk
compression at all is chosen.
It also restores the select ZLIB_INFLATE in drivers/block/Kconfig
which somehow came missing. This is needed to activate compilation of
the stuff in zlib_deflate.
Signed-off-by: Alain Knaff <alain@knaff.lu>
Signed-off-by: H. Peter Anvin <hpa@zytor.com>
Impact: Partial resolution of build failure
Move the initrd/initramfs configuration options from
drivers/block/Kconfig to usr/Kconfig, since they do not and should not
depend on CONFIG_BLK_DEV. This fixes builds when CONFIG_BLK_DEV=n.
Signed-off-by: H. Peter Anvin <hpa@zytor.com>
Impact: Partial resolution of build failure
DECOMPRESS_GZIP is just a common-interface wrapper around the
zlib_inflate code; it thus need to select it.
Signed-off-by: H. Peter Anvin <hpa@zytor.com>
Impact: Partial resolution of build failure
Make all the compression algorithms properly configurable, and make
sure the ramdisk options pull in the proper compression algorithms, as
they should.
Signed-off-by: H. Peter Anvin <hpa@zytor.com>
Impact: Bug fix (we should not show this menu on irrelevant architectures)
Make the config machinery to drive the gzip/bzip2/lzma selection
dependent on the architecture advertising HAVE_KERNEL_* so that we
don't display this for architectures where it doesn't matter.
Signed-off-by: H. Peter Anvin <hpa@zytor.com>
Impact: Bug fix
If bzip2 or lzma fails (for example, if they aren't installed on the
system), we need to propagate the failure out to "make". However,
they were masked by being followed by a semicolon.
Signed-off-by: H. Peter Anvin <hpa@zytor.com>
Impact: Replaces x86 kernel decompressor with new code
This is the third part of the bzip2/lzma patch
The bzip patch is based on an idea by Christian Ludwig, includes support for
compressing the kernel with bzip2 or lzma rather than gzip. Both
compressors give smaller sizes than gzip. Lzma's decompresses faster
than bzip2.
It also supports ramdisks and initramfs' compressed using these two
compressors.
The functionality has been successfully used for a couple of years by
the udpcast project
This version applies to "tip" kernel 2.6.28
This part contains:
- support for new bzip2 and lzma kernel compression for x86
Signed-off-by: Alain Knaff <alain@knaff.lu>
Signed-off-by: H. Peter Anvin <hpa@zytor.com>
Impact: Code simplification
Instead of open-coding testing for initramfs compression formats, use
a table.
Signed-off-by: H. Peter Anvin <hpa@zytor.com>
Impact: New code for initramfs decompression, new features
This is the second part of the bzip2/lzma patch
The bzip patch is based on an idea by Christian Ludwig, includes support for
compressing the kernel with bzip2 or lzma rather than gzip. Both
compressors give smaller sizes than gzip. Lzma's decompresses faster
than bzip2.
It also supports ramdisks and initramfs' compressed using these two
compressors.
The functionality has been successfully used for a couple of years by
the udpcast project
This version applies to "tip" kernel 2.6.28
This part contains:
- support for new compressions (bzip2 and lzma) in initramfs and
old-style ramdisk
- config dialog for kernel compression (but new kernel compressions
not yet supported)
Signed-off-by: Alain Knaff <alain@knaff.lu>
Signed-off-by: H. Peter Anvin <hpa@zytor.com>
Impact: Replaces inflate.c with a wrapper around zlib_inflate; new library code
This is the first part of the bzip2/lzma patch
The bzip patch is based on an idea by Christian Ludwig, includes support for
compressing the kernel with bzip2 or lzma rather than gzip. Both
compressors give smaller sizes than gzip. Lzma's decompresses faster
than bzip2.
It also supports ramdisks and initramfs' compressed using these two
compressors.
The functionality has been successfully used for a couple of years by
the udpcast project
This version applies to "tip" kernel 2.6.28
This part contains:
- changed inflate.c to accomodate rest of patch
- implementation of bzip2 compression (not used at this stage yet)
- implementation of lzma compression (not used at this stage yet)
- Makefile routines to support bzip2 and lzma kernel compression
Signed-off-by: Alain Knaff <alain@knaff.lu>
Signed-off-by: H. Peter Anvin <hpa@zytor.com>
* 'cpus4096-for-linus-3' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/linux-2.6-tip: (77 commits)
x86: setup_per_cpu_areas() cleanup
cpumask: fix compile error when CONFIG_NR_CPUS is not defined
cpumask: use alloc_cpumask_var_node where appropriate
cpumask: convert shared_cpu_map in acpi_processor* structs to cpumask_var_t
x86: use cpumask_var_t in acpi/boot.c
x86: cleanup some remaining usages of NR_CPUS where s/b nr_cpu_ids
sched: put back some stack hog changes that were undone in kernel/sched.c
x86: enable cpus display of kernel_max and offlined cpus
ia64: cpumask fix for is_affinity_mask_valid()
cpumask: convert RCU implementations, fix
xtensa: define __fls
mn10300: define __fls
m32r: define __fls
h8300: define __fls
frv: define __fls
cris: define __fls
cpumask: CONFIG_DISABLE_OBSOLETE_CPUMASK_FUNCTIONS
cpumask: zero extra bits in alloc_cpumask_var_node
cpumask: replace for_each_cpu_mask_nr with for_each_cpu in kernel/time/
cpumask: convert mm/
...
* 'for_linus' of git://git.kernel.org/pub/scm/linux/kernel/git/mchehab/linux-2.6: (34 commits)
V4L/DVB (10173): Missing v4l2_prio_close in radio_release
V4L/DVB (10172): add DVB_DEVICE_TYPE= to uevent
V4L/DVB (10171): Use usb_set_intfdata
V4L/DVB (10170): tuner-simple: prevent possible OOPS caused by divide by zero error
V4L/DVB (10168): sms1xxx: fix inverted gpio for lna control on tiger r2
V4L/DVB (10167): sms1xxx: add support for inverted gpio
V4L/DVB (10166): dvb frontend: stop using non-C99 compliant comments
V4L/DVB (10165): Add FE_CAN_2G_MODULATION flag to frontends that support DVB-S2
V4L/DVB (10164): Add missing S2 caps flag to S2API
V4L/DVB (10163): em28xx: allocate adev together with struct em28xx dev
V4L/DVB (10162): tuner-simple: Fix tuner type set message
V4L/DVB (10161): saa7134: fix autodetection for AVer TV GO 007 FM Plus
V4L/DVB (10160): em28xx: update chip id for em2710
V4L/DVB (10157): Add USB ID for the Sil4701 radio from DealExtreme
V4L/DVB (10156): saa7134: Add support for Avermedia AVer TV GO 007 FM Plus
V4L/DVB (10155): Add TEA5764 radio driver
V4L/DVB (10154): saa7134: fix a merge conflict on Behold H6 board
V4L/DVB (10153): Add the Beholder H6 card to DVB-T part of sources.
V4L/DVB (10152): Change configuration of the Beholder H6 card
V4L/DVB (10151): Fix I2C bridge error in zl10353
...
* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/drzeus/mmc:
mmc: warn about voltage mismatches
mmc_spi: Add support for OpenFirmware bindings
pxamci: fix dma_unmap_sg length
mmc_block: ensure all sectors that do not have errors are read
drivers/mmc: Move a dereference below a NULL test
sdhci: handle built-in sdhci with modular leds class
mmc: balanc pci_iomap with pci_iounmap
mmc_block: print better error messages
mmc: Add mmc_vddrange_to_ocrmask() helper function
ricoh_mmc: Handle newer models of Ricoh controllers
mmc: Add 8-bit bus width support
sdhci: activate led support also when module
mmc: trivial annotation of 'blocks'
pci: use pci_ioremap_bar() in drivers/mmc
sdricoh_cs: Add support for Bay Controller devices
mmc: at91_mci: reorder timer setup and mmc_add_host() call
Before, when we only ever printed out the pointer value itself, a NULL
pointer would never cause issues and might as well be printed out as
just its numeric value.
However, with the extended %p formats, especially %pR, we might validly
want to print out resources for debugging. And sometimes they don't
even exist, and the resource pointer is just NULL. Print it out as
such, rather than oopsing.
This is a more generic version of a patch done by Trent Piepho (catching
all %p cases rather than just %pR, and using "(null)" instead of
"[NULL]" to match glibc).
Requested-by: Trent Piepho <xyzzy@speakeasy.org>
Acked-by: Harvey Harrison <harvey.harrison@gmail.com>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
They are actually alpha vs. i386/arm/m68k i.e. ecoff vs. aout.
In the only place where we actually tried to handle arm and i386/m68k in
different ways (START_DATA() in coredump handling), the arm variant
works for all of them (i386 and m68k have u.start_code set to 0).
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
This updates some personal info in the CREDITS file.
I'm no longer actively involved in Keyspan driver work so shouldn't
really be listed as a Maintainer here.
I do however field the occasional question on them and as I'm dropping
the misc.nu domain, want to ensure people can find me should they need
to.
Signed-off-by: Hugh Blemings <hugh@blemings.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
Impact: cleanup
__alloc_bootmem and __alloc_bootmem_node do panic
for us in case of fail so no need for additional
checks here.
Also lets use pr_*() macros for printing.
Signed-off-by: Cyrill Gorcunov <gorcunov@openvz.org>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
CONFIG_NR_CPUS will be defined for all arch's whether SMP or not, but
it may not have made it into all arches yet.
Signed-off-by: Mike Travis <travis@sgi.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Impact: Reduce inter-node memory traffic.
Reduces inter-node memory traffic (offloading the global system bus)
by allocating referenced struct cpumasks on the same node as the
referring struct.
Signed-off-by: Mike Travis <travis@sgi.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
