It's showing up as regressions; disabling it very likely just papers
over an underlying issue, but time is running out for 2.6.28, lets get
back to this for 2.6.29
Fixes: #11826 and #11893
Signed-off-by: Arjan van de Ven <arjan@linux.intel.com>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
The below is a simplistic fix for "make deb-pkg"; it splits the
firmware out to a linux-firmware-image package and adds an
(unversioned) Suggests to the linux package for this firmware.
Signed-Off-By: Jonathan McDowell <noodles@earth.li>
Acked-by: Frans Pop <elendil@planet.nl>
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
The "Exclude staging drivers" question is there so that we don't build
staging drivers for allyesconfig or allnoconfig settings, but it's very
irritating when you've already said "no" to staging drivers earlier.
There is absolutely no point in declining twice - once you've declined
the staging drivers, you're done.
So make the second question depend on the first question having been
answered in the affirmative.
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
* 'cpus4096' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/linux-2.6-tip:
cpumask: introduce new API, without changing anything, v3
cpumask: new API, v2
cpumask: introduce new API, without changing anything
Commit 8d7c4203 "nfsd: fix failure to set eof in readdir in some
situations" introduced a bug: on a directory in an exported ext3
filesystem with dir_index unset, a READDIR will only return about 250
entries, even if the directory was larger.
Bisected it back to this commit; reverting it fixes the problem.
It turns out that in this case ext3 reads a block at a time, then
returns from readdir, which means we can end up with buf.full==0 but
with more entries in the directory still to be read. Before 8d7c4203
(but after c002a6c797 "Optimise NFS readdir hack slightly"), this would
cause us to return the READDIR result immediately, but with the eof bit
unset. That could cause a performance regression (because the client
would need more roundtrips to the server to read the whole directory),
but no loss in correctness, since the cleared eof bit caused the client
to send another readdir. After 8d7c4203, the setting of the eof bit
made this a correctness problem.
So, move nfserr_eof into the loop and remove the buf.full check so that
we loop until buf.used==0. The following seems to do the right thing
and reduces the network traffic since we don't return a READDIR result
until the buffer is full.
Tested on an empty directory & large directory; eof is properly sent and
there are no more short buffers.
Signed-off-by: Doug Nazar <nazard@dragoninc.ca>
Cc: David Woodhouse <David.Woodhouse@intel.com>
Cc: Al Viro <viro@zeniv.linux.org.uk>
Signed-off-by: J. Bruce Fields <bfields@citi.umich.edu>
Impact: cleanup
Clean up based on feedback from Andrew Morton and others:
- change to inline functions instead of macros
- add __init to bootmem method
- add a missing debug check
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Previously I assumed that the receive queues of candidates don't
change during the GC. This is only half true, nothing can be received
from the queues (see comment in unix_gc()), but buffers could be added
through the other half of the socket pair, which may still have file
descriptors referring to it.
This can result in inc_inflight_move_tail() erronously increasing the
"inflight" counter for a unix socket for which dec_inflight() wasn't
previously called. This in turn can trigger the "BUG_ON(total_refs <
inflight_refs)" in a later garbage collection run.
Fix this by only manipulating the "inflight" counter for sockets which
are candidates themselves. Duplicating the file references in
unix_attach_fds() is also needed to prevent a socket becoming a
candidate for GC while the skb that contains it is not yet queued.
Reported-by: Andrea Bittau <a.bittau@cs.ucl.ac.uk>
Signed-off-by: Miklos Szeredi <mszeredi@suse.cz>
CC: stable@kernel.org
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
Currently, all existing users of cnt32_to_63() are fine since the CPU
architectures where it is used don't do read access reordering, and user
mode preemption is disabled already. It is nevertheless a good idea to
better elaborate usage requirements wrt preemption, and use an explicit
memory barrier on SMP to avoid different CPUs accessing the counter
value in the wrong order. On UP a simple compiler barrier is
sufficient.
Signed-off-by: Nicolas Pitre <nico@marvell.com>
Acked-by: Mathieu Desnoyers <mathieu.desnoyers@polymtl.ca>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
Use menuconfig instead of flat configs so that you can disable/enable
regulator items with one selection. Also, use depends instead of
reverse selections to make life easier, too.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Liam Girdwood <lrg@slimlogic.co.uk>
It seems that some cards are slightly out of spec and occasionally
will not be able to complete a write in the alloted 250 ms [1].
Incease the timeout slightly to allow even these cards to function
properly.
[1] http://lkml.org/lkml/2008/9/23/390
Signed-off-by: Pierre Ossman <drzeus@drzeus.cx>
* 'sched-fixes-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/linux-2.6-tip:
sched: optimize sched_clock() a bit
sched: improve sched_clock() performance
* 'oprofile-fixes-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/linux-2.6-tip:
oprofile: Fix p6 counter overflow check
Cell OProfile: Incorrect local array size in activate spu profiling function
Revert "Cell OProfile: Incorrect local array size in activate spu profiling function"
oprofile: fix memory ordering
Cell OProfile: Incorrect local array size in activate spu profiling function
Change UTF8 chars in Kconfig help text about Oprofile AMD barcelona
* git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/staging-2.6:
Staging: make usbip depend on CONFIG_NET
Staging: only build the tree if we really want to
Fix the __pfn_to_page(pfn) macro so that it doesn't evaluate its
argument twice in the CONFIG_DISCONTIGMEM=y case, because 'pfn' may
be a result of a funtion call having side effects.
For example, the hibernation code applies pfn_to_page(pfn) to the
result of a function returning the pfn corresponding to the next set
bit in a bitmap and the current bit position is modified on each
call. This leads to "interesting" failures for CONFIG_DISCONTIGMEM=y
due to the current behavior of __pfn_to_page(pfn).
Signed-off-by: Rafael J. Wysocki <rjw@sisk.pl>
Acked-by: Pavel Machek <pavel@suse.cz>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
sched_clock() uses cycles_2_ns() needlessly - which is an irq-disabling
variant of __cycles_2_ns().
Most of the time sched_clock() is called with irqs disabled already.
The few places that call it with irqs enabled need to be updated.
Signed-off-by: Ingo Molnar <mingo@elte.hu>
in scheduler-intense workloads native_read_tsc() overhead accounts for
20% of the system overhead:
659567 system_call 41222.9375
686796 schedule 435.7843
718382 __switch_to 665.1685
823875 switch_mm 4526.7857
1883122 native_read_tsc 55385.9412
9761990 total 2.8468
this is large part due to the rdtsc_barrier() that is done before
and after reading the TSC.
But sched_clock() is not a precise clock in the GTOD sense, using such
barriers is completely pointless. So remove the barriers and only use
them in vget_cycles().
This improves lat_ctx performance by about 5%.
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Thanks to Randy Dunlap for finding this problem.
Reported-by: Randy Dunlap <randy.dunlap@oracle.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
This Kconfig change allows the common 'make allmodconfig' and
'make allyesconfig' build options to skip the staging tree, which is
probably what you want to have happen anyway.
This makes the linux-next developer's life a lot easier so he doesn't
have to worry about changes that break the staging tree, that's for me
to worry about...
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
* 'release' of git://git.kernel.org/pub/scm/linux/kernel/git/aegl/linux-2.6:
[IA64] Reserve elfcorehdr memory in CONFIG_CRASH_DUMP
[IA64] fix boot panic caused by offline CPUs
[IA64] reorder Kconfig options to match x86
[IA64] Build VT-D iommu support into generic kernel
[IA64] remove dead BIO_VMERGE_BOUNDARY definition
[IA64] remove duplicated #include from pci-dma.c
[IA64] use common header for software IO/TLB
[IA64] fix the difference between node_mem_map and node_start_pfn
[IA64] Add error_recovery_info field to SAL section header
[IA64] Add UV watchlist support.
[IA64] Simplify SGI uv vs. sn2 driver issues
Linus Torvalds
Arjan van de Ven
Jonathan McDowell
Doug Nazar
Rusty Russell
Miklos Szeredi
Nicolas Pitre
Takashi Iwai
Kay Sievers
Pierre Ossman
Rafael J. Wysocki
Ingo Molnar
Greg Kroah-Hartman