check_cpu_capabilities runs through a given list of caps and
checks if the system has the cap, updates the system capability
bitmap and also runs any enable() methods associated with them.
All of this is not quite obvious from the name 'check'. This
patch splits the check_cpu_capabilities into two parts :
1) update_cpu_capabilities
=> Runs through the given list and updates the system
wide capability map.
2) enable_cpu_capabilities
=> Runs through the given list and invokes enable() (if any)
for the caps enabled on the system.
Cc: Andre Przywara <andre.przywara@arm.com>
Cc: Will Deacon <will.deacon@arm.com>
Suggested-by: Catalin Marinas <catalin.marinsa@arm.com>
Signed-off-by: Suzuki K. Poulose <suzuki.poulose@arm.com>
Tested-by: Dave Martin <Dave.Martin@arm.com>
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
This patch adds an infrastructure to keep track of the CPU feature
registers on the system. For each register, the infrastructure keeps
track of the system wide safe value of the feature bits. Also, tracks
the which fields of a register should be matched strictly across all
the CPUs on the system for the SANITY check infrastructure.
The feature bits are classified into following 3 types depending on
the implication of the possible values. This information is used to
decide the safe value for a feature.
LOWER_SAFE - The smaller value is safer
HIGHER_SAFE - The bigger value is safer
EXACT - We can't decide between the two, so a predefined safe_value is used.
This infrastructure will be later used to make better decisions for:
- Kernel features (e.g, KVM, Debug)
- SANITY Check
- CPU capability
- ELF HWCAP
- Exposing CPU Feature register to userspace.
Signed-off-by: Suzuki K. Poulose <suzuki.poulose@arm.com>
Tested-by: Dave Martin <Dave.Martin@arm.com>
[catalin.marinas@arm.com: whitespace fix]
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
This patch moves the /proc/cpuinfo handling code:
arch/arm64/kernel/{setup.c to cpuinfo.c}
No functional changes
Signed-off-by: Suzuki K. Poulose <suzuki.poulose@arm.com>
Tested-by: Dave Martin <Dave.Martin@arm.com>
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
Move the mixed endian support detection code to cpufeature.c
from cpuinfo.c. This also moves the update_cpu_features()
used by mixed endian detection code, which will get more
functionality.
Also moves the ID register field shifts to asm/sysreg.h,
where all the useful definitions will end up in later patches.
Signed-off-by: Suzuki K. Poulose <suzuki.poulose@arm.com>
Tested-by: Dave Martin <Dave.Martin@arm.com>
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
This patch moves the CPU feature detection code from
arch/arm64/kernel/{setup.c to cpufeature.c}
The plan is to consolidate all the CPU feature handling
in cpufeature.c.
Apart from changing pr_fmt from "alternatives" to "cpu features",
there are no functional changes.
Signed-off-by: Suzuki K. Poulose <suzuki.poulose@arm.com>
Tested-by: Dave Martin <Dave.Martin@arm.com>
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
At the moment the boot CPU stores the cpuinfo long before the
PERCPU areas are initialised by the kernel. This could be problematic
as the non-boot CPU data structures might get copied with the data
from the boot CPU, giving us no chance to detect if a particular CPU
updated its cpuinfo. This patch delays the boot cpu store to
smp_prepare_boot_cpu().
Also kills the setup_processor() which no longer does meaningful
work.
Signed-off-by: Suzuki K. Poulose <suzuki.poulose@arm.com>
Tested-by: Dave Martin <Dave.Martin@arm.com>
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
Delay the ELF HWCAP initialisation until all the (enabled) CPUs are
up, i.e, smp_cpus_done(). This is in preparation for detecting the
common features across the CPUS and creating a consistent ELF HWCAP
for the system.
Signed-off-by: Suzuki K. Poulose <suzuki.poulose@arm.com>
Tested-by: Dave Martin <Dave.Martin@arm.com>
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
At early boot, we print the CPU version/revision. On a heterogeneous
system, we could have different types of CPUs. Print the CPU info for
all active cpus. Also, the secondary CPUs prints the message only when
they turn online.
Also, remove the redundant 'revision' information which doesn't
make any sense without the 'variant' field.
Signed-off-by: Suzuki K. Poulose <suzuki.poulose@arm.com>
Tested-by: Dave Martin <Dave.Martin@arm.com>
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
Commit 215399392f (arm64: 36 bit VA) introduced 36-bit VA support for
the arm64 kernel when the 16KB page configuration is enabled. While this
is a valid hardware configuration, it's not something we want to
encourage since it reduces the memory (and I/O) range that the kernel
can access. Make this depend on EXPERT to avoid complaints of Linux not
mapping the whole RAM, especially on platforms following the ARM
recommended memory map.
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
Unlike perf callchain relying on walk_stackframe(), dump_backtrace()
has its own backtrace logic. A major difference between them is the
moment a symbol is recorded. Perf writes down a symbol *before*
calling unwind_frame(), but dump_backtrace() prints it out *after*
unwind_frame(). As a result, the last valid symbol cannot be hooked
in case of dump_backtrace(). This patch addresses the issue as
synchronising dump_backtrace() with perf callchain.
A simple test and its results are as follows:
- crash trigger
$ sudo echo c > /proc/sysrq-trigger
- current status
Call trace:
[<fffffe00003dc738>] sysrq_handle_crash+0x24/0x30
[<fffffe00003dd2ac>] __handle_sysrq+0x128/0x19c
[<fffffe00003dd730>] write_sysrq_trigger+0x60/0x74
[<fffffe0000249fc4>] proc_reg_write+0x84/0xc0
[<fffffe00001f2638>] __vfs_write+0x44/0x104
[<fffffe00001f2e60>] vfs_write+0x98/0x1a8
[<fffffe00001f3730>] SyS_write+0x50/0xb0
- with this change
Call trace:
[<fffffe00003dc738>] sysrq_handle_crash+0x24/0x30
[<fffffe00003dd2ac>] __handle_sysrq+0x128/0x19c
[<fffffe00003dd730>] write_sysrq_trigger+0x60/0x74
[<fffffe0000249fc4>] proc_reg_write+0x84/0xc0
[<fffffe00001f2638>] __vfs_write+0x44/0x104
[<fffffe00001f2e60>] vfs_write+0x98/0x1a8
[<fffffe00001f3730>] SyS_write+0x50/0xb0
[<fffffe00000939ec>] el0_svc_naked+0x20/0x28
Note that this patch does not cover a case where MMU is disabled. The
last stack frame of swapper, for example, has PC in a form of physical
address. Unfortunately, a simple conversion using phys_to_virt() cannot
cover all scenarios since PC is retrieved from LR - 4, not LR. It is
a big tradeoff to change both head.S and unwind_frame() for only a few
of symbols in *.S. Thus, this hunk does not take care of the case.
Cc: AKASHI Takahiro <takahiro.akashi@linaro.org>
Cc: James Morse <james.morse@arm.com>
Cc: Mark Rutland <mark.rutland@arm.com>
Signed-off-by: Jungseok Lee <jungseoklee85@gmail.com>
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
Currently, if cpuidle is disabled or not supported, powertop reports
zero wakeups and zero events. This is due to the cpu_idle tracepoints
are missing.
This patch is to make cpu_idle tracepoints always available even if
cpuidle is disabled or not supported.
Signed-off-by: Jisheng Zhang <jszhang@marvell.com>
Acked-by: Lorenzo Pieralisi <lorenzo.pieralisi@arm.com>
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
We choose NR_FIX_BTMAPS such that each slot (NR_FIX_BTMAPS * PAGE_SIZE)
can address 256K.
Use division to derive NR_FIX_BTMAPS rather than defining it for each
page size.
Signed-off-by: Mark Rutland <mark.rutland@arm.com>
Signed-off-by: Suzuki K. Poulose <suzuki.poulose@arm.com>
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
We use !CONFIG_ARM64_64K_PAGES for CONFIG_ARM64_4K_PAGES
(and vice versa) in code. It all worked well, so far since
we only had two options. Now, with the introduction of 16K,
these cases will break. This patch cleans up the code to
use the required CONFIG symbol expression without the assumption
that !64K => 4K (and vice versa)
Cc: Will Deacon <will.deacon@arm.com>
Acked-by: Mark Rutland <mark.rutland@arm.com>
Signed-off-by: Suzuki K. Poulose <suzuki.poulose@arm.com>
Reviewed-by: Ard Biesheuvel <ard.biesheuvel@linaro.org>
Tested-by: Ard Biesheuvel <ard.biesheuvel@linaro.org>
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
Now that we can calculate the number of levels required for
mapping a va width, reserve exact number of pages that would
be required to cover the idmap. The idmap should be able to handle
the maximum physical address size supported.
Cc: Will Deacon <will.deacon@arm.com>
Signed-off-by: Suzuki K. Poulose <suzuki.poulose@arm.com>
Reviewed-by: Ard Biesheuvel <ard.biesheuvel@linaro.org>
Tested-by: Ard Biesheuvel <ard.biesheuvel@linaro.org>
Acked-by: Mark Rutland <mark.rutland@arm.com>
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
Suzuki K. Poulose
Catalin Marinas
Jungseok Lee
Jisheng Zhang
Ard Biesheuvel
Mark Rutland