We copy 7 bytes at eip for userspace's instruction decode; we have to
carefully handle the case where eip is at the end of a page. We can't
leave this to userspace since kernel has all the page table decode
logic.
The decode logic moves to userspace, basically unchanged.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
We normally abort the guest unconditionally when it gives us a bad address,
but in the next patch we want to copy some bytes which may not be mapped.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
We use the ptrace API struct, and we currently don't let them set
anything but the normal registers (we'd have to filter the others).
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
Since PCI is little endian, 8-bit access might work, but the spec section
is very clear on this:
4.1.3.1 Driver Requirements: PCI Device Layout
The driver MUST access each field using the “natural” access method,
i.e. 32-bit accesses for 32-bit fields, 16-bit accesses for 16-bit
fields and 8-bit accesses for 8-bit fields.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
Acked-by: Michael S. Tsirkin <mst@redhat.com>
The VIRTIO_F_ANY_LAYOUT and VIRTIO_F_NOTIFY_ON_EMPTY features are pre-1.0
only.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
Acked-by: Michael S. Tsirkin <mst@redhat.com>
This allows modern implementations to ensure they don't use legacy
feature bits or SCSI commands (which are not used in v1.0 non-legacy).
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
Acked-by: Michael S. Tsirkin <mst@redhat.com>
This provides backdoor access to the device MMIOs, and every device should
have one. From the virtio 1.0 spec (CS03):
4.1.4.7.1 Device Requirements: PCI configuration access capability
The device MUST present at least one VIRTIO_PCI_CAP_PCI_CFG capability.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
Acked-by: Michael S. Tsirkin <mst@redhat.com>
The virtqueue_add() calls START_USE() upon entry. The virtqueue_kick() is
called if vq->num_added == (1 << 16) - 1 before calling END_USE().
The virtqueue_kick_prepare() called via virtqueue_kick() calls START_USE()
upon entry, and will call panic() if DEBUG is enabled.
Move this virtqueue_kick() call to after END_USE() call.
Signed-off-by: Tetsuo Handa <penguin-kernel@I-love.SAKURA.ne.jp>
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
This patch add a support for second version of the virtio-mmio device,
which follows OASIS "Virtual I/O Device (VIRTIO) Version 1.0"
specification.
Main changes:
1. The control register symbolic names use the new device/driver
nomenclature rather than the old guest/host one.
2. The driver detect the device version (version 1 is the pre-OASIS
spec, version 2 is compatible with fist revision of the OASIS spec)
and drives the device accordingly.
3. New version uses direct addressing (64 bit address split into two
low/high register) instead of the guest page size based one,
and addresses each part of the queue (descriptors, available, used)
separately.
4. The device activity is now explicitly triggered by writing to the
"queue ready" register.
5. Whole 64 bit features are properly handled now (both ways).
Signed-off-by: Pawel Moll <pawel.moll@arm.com>
Acked-by: Michael S. Tsirkin <mst@redhat.com>
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
release function in modern driver is unused:
it's a left-over from when each driver had
to have its own release.
Signed-off-by: Michael S. Tsirkin <mst@redhat.com>
If set, try legacy interface first, modern one if that fails. Useful to
work around device/driver bugs, and for compatibility testing.
Signed-off-by: Michael S. Tsirkin <mst@redhat.com>
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
Useful for testing device virtio 1 compatibility.
Based on patch by Rusty - couldn't resist putting
that flying car joke in there!
Signed-off-by: Michael S. Tsirkin <mst@redhat.com>
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
The ABI *is* stable, and has been for a while now.
Drop Kconfig warning saying that it's not guaranteed
to work.
Signed-off-by: Michael S. Tsirkin <mst@redhat.com>
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
Most of our code has
struct foo {
}
Fix one instances where ring is inconsistent.
Signed-off-by: Michael S. Tsirkin <mst@redhat.com>
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
Most of our code has
struct foo {
}
Fix two instances where blk is inconsistent.
Signed-off-by: Michael S. Tsirkin <mst@redhat.com>
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
Most of our code has
struct foo {
}
Fix two instances where balloon is inconsistent.
Signed-off-by: Michael S. Tsirkin <mst@redhat.com>
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
Virtio 1.0 spec lists device config as optional.
Set get/set callbacks to NULL. Drivers can check that
and fail gracefully.
Signed-off-by: Michael S. Tsirkin <mst@redhat.com>
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
We don't know the # of VQs that drivers are going to use so it's hard to
predict how much memory we'll need to map. However, the relevant
capability does give us an upper limit.
If that's below a page, we can reduce the number of required
mappings by mapping it all once ahead of the time.
Signed-off-by: Michael S. Tsirkin <mst@redhat.com>
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
Rusty Russell
Tetsuo Handa
Pawel Moll
Michael S. Tsirkin