If __totlen is going away, we need to pass the length in separately.
Also stop callers from needlessly setting ref->next_phys to NULL,
since that's done for them... and since that'll also be going away soon.
Signed-off-by: David Woodhouse <dwmw2@infradead.org>
Make sure we allocate a ref for any dirty space which exists between nodes
which we find in an eraseblock summary.
Signed-off-by: David Woodhouse <dwmw2@infradead.org>
The incoming ref_totlen() calculation is going to rely on the existence
of nodes which cover all dirty space. We can't just tweak the accounting
data any more; we have to call jffs2_scan_dirty_space() to do it.
Signed-off-by: David Woodhouse <dwmw2@infradead.org>
To eliminate the __totlen field from struct jffs2_raw_node_ref, we need
to allocate nodes for dirty space instead of just tweaking the accounting
data. Introduce jffs2_scan_dirty_space() in preparation for that.
Signed-off-by: David Woodhouse <dwmw2@infradead.org>
For RWCOMPAT and ROCOMPAT nodes, we should still allow the mount to
succeed. Just abandon the summary and fall through to the full scan.
Signed-off-by: David Woodhouse <dwmw2@infradead.org>
If we had to allocate extra space for the summary node, we weren't
correctly freeing it when jffs2_sum_scan_sumnode() returned nonzero --
which is both the success and the failure case. Only when it returned
zero, which means fall through to the full scan, were we correctly freeing
the buffer.
Document the meaning of those return codes while we're at it.
Signed-off-by: David Woodhouse <dwmw2@infradead.org>
We should preserve these when we come to garbage collect them, not let
them get erased. Use jffs2_garbage_collect_pristine() for this, and make
sure the summary code copes -- just refrain from writing a summary for any
block which contains a node we don't understand.
Signed-off-by: David Woodhouse <dwmw2@infradead.org>
The same sequence of code was repeated in many places, to add a new
struct jffs2_raw_node_ref to an eraseblock and adjust the space accounting
accordingly. Move it out-of-line.
Signed-off-by: David Woodhouse <dwmw2@infradead.org>
We were calling ref_totlen() 18 times. Even before that becomes a real
function rather than just a dereference, apparently some compilers still
suck anyway. It'll _certainly_ suck after ref_totlen() becomes more
complicated, so calculate it once and don't rely on CSE.
Signed-off-by: David Woodhouse <dwmw2@infradead.org>
This improves the time to mount 512MiB of NAND flash on my OLPC prototype
by about 4%. We used to read the last page of the eraseblock twice -- once
to find the offset of the summary node, and again to actually _read_ the
summary node. Now we read the last page only once, and read more only if
we need to.
We also don't allocate a new buffer just for the summary code -- we use
the buffer which was already allocated for the scan. Better still, if the
'buffer' for the scan is actually just a pointer directly into NOR flash,
we use that too, avoiding the memcpy() which we used to do.
Signed-off-by: David Woodhouse <dwmw2@infradead.org>
drivers/mtd/devices/docprobe.c: In function `DoC_Probe':
drivers/mtd/devices/docprobe.c:338: warning: assignment from incompatible pointer type
drivers/mtd/devices/docprobe.c:341: warning: assignment from incompatible pointer type
Cc: David Woodhouse <dwmw2@infradead.org>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: David Woodhouse <dwmw2@infradead.org>
Remove forgotten lines from jffs2_scan_eraseblock() which
were unnecessary and may cause problem in some environments.
Thanks to Alexander Belyakov <alexander.belyakov@intel.com>.
Signed-off-by: Ferenc Havasi <havasi@inf.u-szeged.hu>
Signed-off-by: David Woodhouse <dwmw2@infradead.org>
Device node major/minor numbers are just stored in the payload of a single
data node. Just extend that to 4 bytes and use new_encode_dev() for it.
We only use the 4-byte format if we _need_ to, if !old_valid_dev(foo).
This preserves backwards compatibility with older code as much as
possible. If we do make devices with major or minor numbers above 255, and
then mount the file system with the old code, it'll just read the first
two bytes and get the numbers wrong. If it comes to garbage-collect it,
it'll then write back those wrong numbers. But that's about the best we
can expect.
Signed-off-by: David Woodhouse <dwmw2@infradead.org>
There is a second revision of "mtdconcat NAND/Sibley" patch. I hope
the patch will not get damaged as I'm posting it from gmail account,
thanks to Jorn.
The patch adds previously missing concat_writev(),
concat_writev_ecc(), concat_block_isbad(), concat_block_markbad()
functions to make concatenation layer compatible with Sibley and NAND
chips.
Patch has been cleared from whitespaces, fixed some lines of code as
requested. Also I have added code for alignment check that should
support Jorn's "writesize" patch.
Signed-off-by: Alexander Belyakov <alexander.belyakov@intel.com>
Signed-off-by: David Woodhouse <dwmw2@infradead.org>
The following difference was found between the mainline and linux-mips
kernel. LASAT depends on MTD_CFI.
Signed-off-by: Martin Michlmayr <tbm@cyrius.com>
Signed-off-by: David Woodhouse <dwmw2@infradead.org>
In an unrelated MTD commit, a description about the ms02-nv module
got removed from Kconfig. While I personally agree with this
removal, the module maintainer (Maciej W. Rozycki) would like to
see it added back. In the absense of any consistency regarding
Kconfig descriptions his wish should be followed.
Signed-off-by: Martin Michlmayr <tbm@cyrius.com>
Acked-by: Maciej W. Rozycki <macro@linux-mips.org>
Signed-off-by: David Woodhouse <dwmw2@infradead.org>
'oobavail' parameter of mtd_info structure is now propagated to the MTD
partitions
Signed-off-by: Vitaly Wool <vwool@ru.mvista.com>
Signed-off-by: David Woodhouse <dwmw2@infradead.org>
David Woodhouse
Andrew Morton
Ferenc Havasi
KaiGai Kohei
Alexander Belyakov
Martin Michlmayr
Sean Young
Vitaly Wool