nvmet_sq_init() returns a value <= 0. nvmet_rdma_cm_reject() expects
a second argument that is a NVME_RDMA_CM_* constant. Hence this patch.
Signed-off-by: Bart Van Assche <bart.vanassche@sandisk.com>
Reviewed-by: Sagi Grimberg <sagi@grimbeg.me>
Signed-off-by: Sagi Grimberg <sagi@grimberg.me>
Since commit e73c23ff73 ("block: add async variant of
blkdev_issue_zeroout") messages like the following show up:
EXT4-fs (dm-1): Delayed block allocation failed for inode 2368848 at
logical offset 0 with max blocks 1 with error 95
EXT4-fs (dm-1): This should not happen!! Data will be lost
Due to the following fallthrough introduced with
commit 2d253440b5 ("block: Define zoned block device operations"),
generic_make_request_checks() would accept a REQ_OP_WRITE_SAME bio only
if the block device supports "write same" *and* is a zoned one:
switch (bio_op(bio)) {
[...]
case REQ_OP_WRITE_SAME:
if (!bdev_write_same(bio->bi_bdev))
goto not_supported;
case REQ_OP_ZONE_REPORT:
case REQ_OP_ZONE_RESET:
if (!bdev_is_zoned(bio->bi_bdev))
goto not_supported;
break;
[...]
}
Thus, although the bio setup as done by __blkdev_issue_write_same() from
commit e73c23ff73 ("block: add async variant of blkdev_issue_zeroout")
would succeed, its actual submission would not, resulting in the
EOPNOTSUPP == 95.
Fix this by removing the fallthrough which, due to the lack of an explicit
comment, seems to be unintended anyway.
Fixes: e73c23ff73 ("block: add async variant of blkdev_issue_zeroout")
Fixes: 2d253440b5 ("block: Define zoned block device operations")
Signed-off-by: Nicolai Stange <nicstange@gmail.com>
Reviewed-by: Christoph Hellwig <hch@lst.de>
Signed-off-by: Jens Axboe <axboe@fb.com>
We have this:
ERROR: "__aeabi_ldivmod" [drivers/block/nbd.ko] undefined!
ERROR: "__divdi3" [drivers/block/nbd.ko] undefined!
nbd.c:(.text+0x247c72): undefined reference to `__divdi3'
due to a recent commit, that did 64-bit division. Use the proper
divider function so that 32-bit compiles don't break.
Fixes: ef77b51524 ("nbd: use loff_t for blocksize and nbd_set_size args")
Signed-off-by: Jens Axboe <axboe@fb.com>
If we have large devices (say like the 40t drive I was trying to test with) we
will end up overflowing the int arguments to nbd_set_size and not get the right
size for our device. Fix this by using loff_t everywhere so I don't have to
think about this again. Thanks,
Signed-off-by: Josef Bacik <jbacik@fb.com>
Signed-off-by: Jens Axboe <axboe@fb.com>
Factor out common code for setting REQ_NOMERGE flag which is being used
out at certain places and make it a helper instead, req_set_nomerge().
Signed-off-by: Ritesh Harjani <riteshh@codeaurora.org>
Get rid of the inline.
Signed-off-by: Jens Axboe <axboe@fb.com>
Fix bug https://bugzilla.kernel.org/show_bug.cgi?id=188531. In function
mtip_block_initialize(), variable rv takes the return value, and its
value should be negative on errors. rv is initialized as 0 and is not
reset when the call to ida_pre_get() fails. So 0 may be returned.
The return value 0 indicates that there is no error, which may be
inconsistent with the execution status. This patch fixes the bug by
explicitly assigning -ENOMEM to rv on the branch that ida_pre_get()
fails.
Signed-off-by: Pan Bian <bianpan2016@163.com>
Signed-off-by: Jens Axboe <axboe@fb.com>
Add support for handling write zeroes command on target.
Call into __blkdev_issue_zeroout, which the block layer expands into the
best suitable variant of zeroing the LBAs. Allow write zeroes operation
to deallocate the LBAs when calling __blkdev_issue_zeroout.
Signed-off-by: Chaitanya Kulkarni <chaitanya.kulkarni@hgst.com>
Reviewed-by: Christoph Hellwig <hch@lst.de>
Signed-off-by: Jens Axboe <axboe@fb.com>
Allow write zeroes operations (REQ_OP_WRITE_ZEROES) on the block
device, if the device supports optional command bit set for write
zeroes. Add support to setup write zeroes command. Set maximum possible
write zeroes sectors in one write zeroes command according to
nvme write zeroes command definition.
Signed-off-by: Chaitanya Kulkarni <chaitanya.kulkarni@hgst.com>
Reviewed-by: Christoph Hellwig <hch@lst.de>
Signed-off-by: Jens Axboe <axboe@fb.com>
Add the command structure, optional command set support (ONCS) bit and
a new error code for the Write Zeroes command.
Signed-off-by: Chaitanya Kulkarni <chaitanya.kulkarni@hgst.com>
Reviewed-by: Christoph Hellwig <hch@lst.de>
Signed-off-by: Jens Axboe <axboe@fb.com>
This adds a new block layer operation to zero out a range of
LBAs. This allows to implement zeroing for devices that don't use
either discard with a predictable zero pattern or WRITE SAME of zeroes.
The prominent example of that is NVMe with the Write Zeroes command,
but in the future, this should also help with improving the way
zeroing discards work. For this operation, suitable entry is exported in
sysfs which indicate the number of maximum bytes allowed in one
write zeroes operation by the device.
Signed-off-by: Chaitanya Kulkarni <chaitanya.kulkarni@hgst.com>
Reviewed-by: Christoph Hellwig <hch@lst.de>
Signed-off-by: Jens Axboe <axboe@fb.com>
Similar to __blkdev_issue_discard this variant allows submitting
the final bio asynchronously and chaining multiple ranges
into a single completion.
Signed-off-by: Chaitanya Kulkarni <chaitanya.kulkarni@hgst.com>
Reviewed-by: Christoph Hellwig <hch@lst.de>
Signed-off-by: Jens Axboe <axboe@fb.com>
Both blkdev_report_zones and blkdev_reset_zones can operate on a partition of
a zoned block device. However, the first and last zones reported for a
partition make sense only if the partition start sector and size are aligned
on the device zone size. The same applies for zone reset. Resetting the first
or the last zone of a partition straddling zones may impact neighboring
partitions. Finally, if a partition start sector is not at the beginning of a
sequential zone, it will be impossible to write to the first sectors of the
partition on a host-managed device.
Avoid all these problems and incoherencies by ignoring partitions that are not
zone aligned.
Note: Even with CONFIG_BLK_DEV_ZONED disabled, bdev_is_zoned() will report the
correct disk zoning type (host-aware, host-managed or none) but
bdev_zone_size() will always return 0 for zoned block devices (i.e. the zone
size is unknown). So test this as a way to ensure that a zoned block device is
being handled as such. As a result, for a host-aware devices, unaligned zone
partitions will be accepted with CONFIG_BLK_DEV_ZONED disabled. That is, the
disk will be treated as a regular block device (as it should). If zoned block
device support is enabled, only aligned partitions will be accepted.
Signed-off-by: Damien Le Moal <damien.lemoal@wdc.com>
Reviewed-by: Hannes Reinecke <hare@suse.com>
Signed-off-by: Jens Axboe <axboe@fb.com>
Since targets are given a virtual target device, it is necessary to
translate all communication between targets and the backend device.
Implement the translation layer for get/set bad block table.
Signed-off-by: Javier González <javier@cnexlabs.com>
Signed-off-by: Matias Bjørling <m@bjorling.me>
Signed-off-by: Jens Axboe <axboe@fb.com>
On target-specific operations pass on nvm_tgt_dev instead of the generic
nvm device.
Signed-off-by: Javier González <javier@cnexlabs.com>
Signed-off-by: Matias Bjørling <m@bjorling.me>
Signed-off-by: Jens Axboe <axboe@fb.com>
Target devices do not have access to the device driver operations.
Introduce a helper function that exposes the max. number of physical
sectors supported by the underlying device.
Signed-off-by: Javier González <javier@cnexlabs.com>
Signed-off-by: Matias Bjørling <m@bjorling.me>
Signed-off-by: Jens Axboe <axboe@fb.com>
Avoid calling media manager and device-specific operations directly from
rrpc. Create helper functions on lightnvm's core instead.
Signed-off-by: Javier González <javier@cnexlabs.com>
Made it work with null_blk as well.
Signed-off-by: Matias Bjørling <m@bjorling.me>
Signed-off-by: Matias Bjørling <m@bjorling.me>
Signed-off-by: Jens Axboe <axboe@fb.com>
In order to naturally support multi-target instances on an Open-Channel
SSD, targets should own the LUNs they get blocks from and manage
provisioning internally. This is done in several steps.
Since targets own the LUNs the are instantiated on top of and manage the
free block list internally, there is no need for a LUN abstraction in
the media manager. LUNs are intrinsically managed as in the physical
layout (ch:0,lun:0, ..., ch:0,lun:n, ch:1,lun:0, ch:1,lun:n, ...,
ch:m,lun:0, ch:m,lun:n) and given to the targets based on the target
creation ioctl. This simplifies LUN management and clears the path for a
partition manager to sit directly underneath LightNVM targets.
Signed-off-by: Javier González <javier@cnexlabs.com>
Signed-off-by: Matias Bjørling <m@bjorling.me>
Signed-off-by: Jens Axboe <axboe@fb.com>
In order to naturally support multi-target instances on an Open-Channel
SSD, targets should own the LUNs they get blocks from and manage
provisioning internally. This is done in several steps.
A part of this transformation is that targets manage their blocks
internally. This patch eliminates the nvm_block abstraction and moves
block management to the target logic. The rrpc target is transformed.
Signed-off-by: Javier González <javier@cnexlabs.com>
Signed-off-by: Matias Bjørling <m@bjorling.me>
Signed-off-by: Jens Axboe <axboe@fb.com>
Since LUNs are managed internally on targets, the media manager has no
access to the free LUN lists. Thus, debug functions that show LUN
information on the device should not be implemented on the media
manager, but rather on the target in itself.
Signed-off-by: Javier González <javier@cnexlabs.com>
Signed-off-by: Matias Bjørling <m@bjorling.me>
Signed-off-by: Jens Axboe <axboe@fb.com>
Since LUNs are managed internally on the target, there is no need for
the media manager to implement a get_lun operation.
Signed-off-by: Javier González <javier@cnexlabs.com>
Signed-off-by: Matias Bjørling <m@bjorling.me>
Signed-off-by: Jens Axboe <axboe@fb.com>
In order to naturally support multi-target instances on an Open-Channel
SSD, targets should own the LUNs they get blocks from and manage
provisioning internally. This is done in several steps.
This patch moves the block provisioning inside of the target and removes
the get/put block interface from the media manager.
Signed-off-by: Javier González <javier@cnexlabs.com>
Signed-off-by: Matias Bjørling <m@bjorling.me>
Signed-off-by: Jens Axboe <axboe@fb.com>
LUNs are exclusively owned by targets implementing a block device FTL.
Doing this reservation requires at the moment a 2-way callback gennvm
<-> target. The reason behind this is that LUNs were not assumed to
always be exclusively owned by targets. However, this design decision
goes against I/O determinism QoS (two targets would mix I/O on the same
parallel unit in the device).
This patch makes LUN reservation as part of the target creation on the
media manager. This makes that LUNs are always exclusively owned by the
target instantiated on top of them. LUN stripping and/or sharing should
be implemented on the target itself or the layers on top.
Signed-off-by: Javier González <javier@cnexlabs.com>
Signed-off-by: Matias Bjørling <m@bjorling.me>
Signed-off-by: Jens Axboe <axboe@fb.com>
Bart Van Assche
Jens Axboe
Nicolai Stange
Josef Bacik
Shaohua Li
Ritesh Harjani
Rabin Vincent
Pan Bian
Chaitanya Kulkarni
Damien Le Moal
Javier González
Javier González