A number of drivers in drivers/gpio return -ENODEV when confronted with
missing setup parameters such as the platform data. However, returning
-ENODEV causes the driver layer to silently ignore the driver as it
assumes the probe did not find anything and was only speculative.
To make life easier to discern why a driver is not being attached, change
to returning -EINVAL, which is a better description of the fact that the
driver data was not valid.
Also add a set of dev_dbg() statements to the error paths to provide an
better explanation of the error as there may be more that one point in the
driver.
Signed-off-by: Ben Dooks <ben-linux@fluff.org>
Cc: David Brownell <david-b@pacbell.net>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
For some reason I have to slowdown clock to touchscreen device.
In atmel_spi_setup() there is comment that max_speed_hz == 0 means as slow
as possible and divider is set to maximum value. But in
atmel_spi_transfer() function is check against not zero max_speed_hz with
EINVAL returned.
Probably driver should setup divider for each transfer based on
transfer->speed_hz value, but I think that would be not necessary overhead
as all used devices have constant clock.
Below patch works fine for me.
Signed-off-by: Stanislaw Gruszka <stf_xl@wp.pl>
Signed-off-by: Haavard Skinnemoen <haavard.skinnemoen@atmel.com>
Cc: David Brownell <david-b@pacbell.net>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
Fix the following problem, related to hardware flow control (CTS/RTS):
Transmitting while CTS line is asserted in DMA mode, due to not checking
for tx-stopped condition.
We found these problems while testing the UARTs with hardware
flow-control.
Signed-off-by: Haavard Skinnemoen <haavard.skinnemoen@atmel.com>
Cc: "Andrew Victor" <avictor.za@gmail.com>
Cc: Alan Cox <alan@lxorguk.ukuu.org.uk>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
Update Documentation/sysctl/vm.txt and Documentation/filesystems/proc.txt.
More specifically, the section on /proc/sys/vm in
Documentation/filesystems/proc.txt was removed and a link to
Documentation/sysctl/vm.txt added.
Most of the verbiage from proc.txt was simply moved in vm.txt, with new
addtional text for "swappiness" and "stat_interval".
Signed-off-by: Peter W Morreale <pmorreale@novell.com>
Acked-by: Randy Dunlap <randy.dunlap@oracle.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
* 'release' of git://git.kernel.org/pub/scm/linux/kernel/git/aegl/linux-2.6:
[IA64] SN specific version of dma_get_required_mask()
[IA64] generic_defconfig: Enable SATA_VITESSE
[IA64] dump stack on kernel unaligned warnings
[IA64] Turn on CONFIG_HAVE_UNSTABLE_CLOCK
[IA64] Update to use account_{steal,idle}_ticks
Update employer's care-of address in CREDITS file, and remove references
to some _very_ old stuff I'd forgotten I'd ever done.
Signed-off-by: David Woodhouse <David.Woodhouse@intel.com>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tiwai/sound-2.6:
ALSA: hda - Fix invalid amp value for STAC925x
ASoC: Fix the power update function for snd_soc_dapm_value_mux
sound: virtuoso: do not overwrite EEPROM on Xonar D2/D2X
ALSA: hda - Fix HP dv5 mic input
ALSA: hda - Fix missing initialization of NID 0x0e for STAC925x
ALSA: USB quirk for Logitech Quickcam Pro 9000 name
ALSA: hda - Fix stac92hd83xxx_amp_nids[]
ALSA: hda - Add automatic model setting for Samsung Q45
ALSA: hda - Don't reset HP pinctl in patch_sigmatel.c
ALSA: hda: stac92hd8xxx amp mixers
ALSA: hda - Fix silent headphone output on Panasonic CF-74
ALSA: hda - Update model descriptions in patch_sigmatel.c
ALSA: hda - Use queue_delayed_work()
ALSA: hda - Add quirk for another HP dv5
ALSA: hda - Add support of NVidia MCP78 HDMI
ALSA: hda - Fix a typo
ALSA: hda - More fixes on Gateway entries
ALSA: patch_sigmatel: Add missing Gateway entries and autodetection
ALSA: hda - Add a new function to seek for a codec ID
This patch is for Alan Cox as it related to the tty layer.
Hopefully the hso driver is again relatively stable with this fix.
Signed-off-by: Denis Joseph Barrow <D.Barow@option.com>
Signed-off-by: Alan Cox <alan@redhat.com>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
The HSO changes for kref introduced a recursive spinlock take. All
functions which call put_rxbuf_data already have serial->serial_lock
grabbed.
[Comment to code added-AC]
Signed-off-by: Denis Joseph Barrow <D.Barrow@option.com>
Signed-off-by: Alan Cox <alan@redhat.com>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
This was not implemented correctly for the pnx8xxx_uart driver.
[From further discussion:
Correct, you can look to it as two separate bugs:
a) the next character is not ignored while it should;
b) the status bits 31-8 are copied to the 'ch' variable while they shouldn't.
Both bugs prevent correct break signal handling (and therefore correct
behaviour of the magic SysRq key). Bug b didn't cause too much trouble
earlier because in most situations the status bits are all zero; for
this case they unfortunately aren't.
]
Signed-off-by: Mischa Jonker <mischa.jonker@nxp.com>
Signed-off-by: Alan Cox <alan@redhat.com>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
Add SupraExpress 336i PnP Voice Modem
Tested and working with the following device: (output from lspnp -v)
01:01.00 SUP1381 (unknown)
state = active
io 0x2f8-0x2ff
irq 3
Signed-off-by: Daniel Gagnon <daniel.gagnon@yahoo.com>
Signed-off-by: Alan Cox <alan@redhat.com>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
Most of netmos 9835 hardware is handled by parport-serial. IBM introduces
a device which doesn't have any parallel ports and have screwed subdevice
PCI id (not corresponding to port numbers).
Handle this device (9710:9835 1014:0299) properly.
Signed-off-by: Jiri Slaby <jirislaby@gmail.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Alan Cox <alan@redhat.com>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
If you issue an ioctl to flush a tty as the line discipline is changing or
otherwise unplugged you can get a crash. The bug is very old but the rest
of the BKL lock dropping and some very "good" luck on Ingo's part caught
an example.
Use the correct ldisc_ref form so that we wait for the ldisc change to
complete and then flush
Signed-off-by: Alan Cox <alan@redhat.com>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
Create a platform specific version of dma_get_required_mask()
for ia64 SN Altix. All SN Altix platforms support 64 bit DMA
addressing regardless of the size of system memory.
Create an ia64 machvec for dma_get_required_mask, with the
SN version unconditionally returning DMA_64BIT_MASK.
Signed-off-by: John Keller <jpk@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
CONFIG_SATA_VITESSE=y was not added to generic_defconfig when
sn2_defconfig was removed. SGI Altix systems that use an IO10
base IO card to drive the root device are unable to boot without
the Vitesse controller.
Signed-off-by: Brent Casavant <bcasavan@sgi.com>
Signed-off-by: Robin Holt <holt@sgi.com>
Signed-off-by: Jes Sorensen <jes@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Often the cause of kernel unaligned access warnings is not
obvious from just the ip displayed in the warning. This adds
the option via proc to dump the stack in addition to the warning.
The default is off (just display the 1 line warning). To enable
the stack to be shown: echo 1 > /proc/sys/kernel/unaligned-dump-stack
Signed-off-by: Doug Chapman <doug.chapman@hp.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
sched_clock() on ia64 is based on ar.itc, so is never
completely synchronized between cpus. On some platforms
(e.g. certain models of SGI Altix) it may be running at
radically different frequencies.
Based on a patch from Dimitri Sivanich which set this
just for SN2 && GENERIC kernels ... it is needed for
all ia64 machines.
Signed-off-by: Tony Luck <tony.luck@intel.com>
This patch fixes the following errors caused by
79741dd357 which changed
the prototypes of account_steal_time() and account_idle_time().
> CC arch/ia64/xen/time.o
> arch/ia64/xen/time.c: In function 'consider_steal_time':
> arch/ia64/xen/time.c:132: warning: passing argument 1 of 'account_steal_time' makes integer from pointer without a cast
> arch/ia64/xen/time.c:132: error: too many arguments to function 'account_steal_time'
> arch/ia64/xen/time.c:133: warning: passing argument 1 of 'account_steal_time' makes integer from pointer without a cast
> arch/ia64/xen/time.c:133: error: too many arguments to function 'account_steal_time'
Cc: Martin Schwidefsky <schwidefsky@de.ibm.com>
Signed-off-by: Isaku Yamahata <yamahata@valinux.co.jp>
Signed-off-by: Tony Luck <tony.luck@intel.com>
The value set in the commit 2465fb6605
is actually wrong. The value range is from 0 to 0x1f while the patch
sets to 0x7f. Let's fix it.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Ben Dooks
Stanislaw Gruszka
Itai Levi
Peter W Morreale
Linus Torvalds
David Woodhouse
Denis Joseph Barrow
Denis Joseph Barrow
Alan Cox
Jim Paris
Mischa Jonker
Daniel Gagnon
Jiri Slaby
John Keller
Brent Casavant
Doug Chapman
Tony Luck
Isaku Yamahata
Takashi Iwai