For HiperSockets the framesize-definition determines the selected
mtu-size and the size of the allocated qdio buffers.
A framesize-change may occur while a Linux system with probed
HiperSockets device is in suspend state. This patch enables proper
resuming of a HiperSockets device in this case.
Signed-off-by: Ursula Braun <ursula.braun@de.ibm.com>
Signed-off-by: Frank Blaschka <frank.blaschka@de.ibm.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
HiperSockets and OSA hardware report a maximum MTU size. Add checking
to reject larger MTUs than allowed by hardware.
Signed-off-by: Frank Blaschka <frank.blaschka@de.ibm.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Setting of a MAC-address may fail because an already used MAC-address
is to bet set or because of authorization problems. In those cases
qeth issues a message, but the mentioned MAC-address is not the
new MAC-address to be set, but the actual MAC-address. This patch
chooses now the new MAC-address to be set for the error messages.
Signed-off-by: Ursula Braun <ursula.braun@de.ibm.com>
Signed-off-by: Frank Blaschka <frank.blaschka@de.ibm.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Like Herbert's change from a few days ago:
66c46d741e gro: Reset dev pointer on reuse
this may not be necessary at this point, but we should still clean up
the skb->skb_iif. If not we may end up with an invalid valid for
skb->skb_iif when the skb is reused and the check is done in
__netif_receive_skb.
Signed-off-by: Andy Gospodarek <andy@greyhouse.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
While running insmod/rmood in a loop, an unnecessary netif_stop_queue
causes the system to crash. Remove the netif_stop_queue call
and netif_start_queue in the link status update path.
Signed-off-by: Ajit Khaparde <ajit.khaparde@emulex.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
The chip was erroneously configured to accept all multicast frames
in a normal (none-promisc) rx mode both on the RSS and on the FCoE L2 rings
when in an NPAR mode. This caused packet duplication for every received multicast
frame in this mode.
Signed-off-by: Vladislav Zolotarov <vladz@broadcom.com>
Signed-off-by: Eilon Greenstein <eilong@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
free the skb's when the Tx of PAPRD frames fails and also add a debug
message indicating that.
Signed-off-by: Mohammed Shafi Shajakhan <mshajakhan@atheros.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
When built with rcu checks enabled, vhost triggers
bogus warnings as vhost features are read without
dev->mutex sometimes, and private pointer is read
with our kind of rcu where work serves as a
read side critical section.
Fixing it properly is not trivial.
Disable the warnings by stubbing out the checks for now.
Signed-off-by: Michael S. Tsirkin <mst@redhat.com>
This error was reported by cppcheck:
drivers/net/enc28j60.c:815: error: Using sizeof for array given as function argument returns the size of pointer.
The original code reads 4 or 8 bytes instead of TSV_SIZE (= 100) bytes.
I just fixed the code, but did not run any tests.
Signed-off-by: Stefan Weil <weil@mail.berlios.de>
Signed-off-by: David S. Miller <davem@davemloft.net>
In my testing of 2.6.37 I was occassionally getting a warning about
sysctl table entries being unregistered in the wrong order. Digging
in it turns out this dates back to the last great sysctl reorg done
where Al Viro introduced the requirement that sysctl directories
needed to be created before and destroyed after the files in them.
It turns out that in that great reorg /proc/sys/net/ipv6/neigh was
overlooked. So this patch fixes that oversight and makes an annoying
warning message go away.
>------------[ cut here ]------------
>WARNING: at kernel/sysctl.c:1992 unregister_sysctl_table+0x134/0x164()
>Pid: 23951, comm: kworker/u:3 Not tainted 2.6.37-350888.2010AroraKernelBeta.fc14.x86_64 #1
>Call Trace:
> [<ffffffff8103e034>] warn_slowpath_common+0x80/0x98
> [<ffffffff8103e061>] warn_slowpath_null+0x15/0x17
> [<ffffffff810452f8>] unregister_sysctl_table+0x134/0x164
> [<ffffffff810e7834>] ? kfree+0xc4/0xd1
> [<ffffffff813439b2>] neigh_sysctl_unregister+0x22/0x3a
> [<ffffffffa02cd14e>] addrconf_ifdown+0x33f/0x37b [ipv6]
> [<ffffffff81331ec2>] ? skb_dequeue+0x5f/0x6b
> [<ffffffffa02ce4a5>] addrconf_notify+0x69b/0x75c [ipv6]
> [<ffffffffa02eb953>] ? ip6mr_device_event+0x98/0xa9 [ipv6]
> [<ffffffff813d2413>] notifier_call_chain+0x32/0x5e
> [<ffffffff8105bdea>] raw_notifier_call_chain+0xf/0x11
> [<ffffffff8133cdac>] call_netdevice_notifiers+0x45/0x4a
> [<ffffffff8133d2b0>] rollback_registered_many+0x118/0x201
> [<ffffffff8133d3af>] unregister_netdevice_many+0x16/0x6d
> [<ffffffff8133d571>] default_device_exit_batch+0xa4/0xb8
> [<ffffffff81337c42>] ? cleanup_net+0x0/0x194
> [<ffffffff81337a2a>] ops_exit_list+0x4e/0x56
> [<ffffffff81337d36>] cleanup_net+0xf4/0x194
> [<ffffffff81053318>] process_one_work+0x187/0x280
> [<ffffffff8105441b>] worker_thread+0xff/0x19f
> [<ffffffff8105431c>] ? worker_thread+0x0/0x19f
> [<ffffffff8105776d>] kthread+0x7d/0x85
> [<ffffffff81003824>] kernel_thread_helper+0x4/0x10
> [<ffffffff810576f0>] ? kthread+0x0/0x85
> [<ffffffff81003820>] ? kernel_thread_helper+0x0/0x10
>---[ end trace 8a7e9310b35e9486 ]---
Signed-off-by: Eric W. Biederman <ebiederm@xmission.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
axnet_cs:
mdelay of 10ms is too long at ei_rx_overrun.
It should be reduced to 2ms.
Signed-off-by: Ken Kawasaki <ken_kawasaki@spring.nifty.jp>
Signed-off-by: David S. Miller <davem@davemloft.net>
In get_rps_cpu, add check that the rps_flow_table for the device is
NULL when trying to take fast path when RPS map length is one.
Without this, RFS is effectively disabled if map length is one which
is not correct.
Signed-off-by: Tom Herbert <therbert@google.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Without this dependency the softing driver will be buildable on s390,
where it fails.
Signed-Off-By: Chuck Ebbert <cebbert@redhat.com>
Acked-by: Kurt Van Dijck <kurt.van.dijck@eia.be>
Signed-off-by: David S. Miller <davem@davemloft.net>
When an IPSEC SA is still being set up, __xfrm_lookup() will return
-EREMOTE and so ip_route_output_flow() will return a blackhole route.
This can happen in a sndmsg call, and after d33e455337 ("net: Abstract
default MTU metric calculation behind an accessor.") this leads to a
crash in ip_append_data() because the blackhole dst_ops have no
default_mtu() method and so dst_mtu() calls a NULL pointer.
Fix this by adding default_mtu() methods (that simply return 0, matching
the old behavior) to the blackhole dst_ops.
The IPv4 part of this patch fixes a crash that I saw when using an IPSEC
VPN; the IPv6 part is untested because I don't have an IPv6 VPN, but it
looks to be needed as well.
Signed-off-by: Roland Dreier <roland@purestorage.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
When DEBUG_SPI is included in the debug log level wl1271_spi_reset()
will dump the already freed memory instead of the SPI buffer.
This bug was spotted by the semantic patch tool coccinelle using the
script found at scripts/coccinelle/free/kfree.cocci.
More information about semantic patching is available at
http://coccinelle.lip6.fr/
Signed-off-by: Mathias Krause <minipli@googlemail.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
All functions on a port should be set to take the MDC/MDIO lock to avoid contention on the bus
Signed-off-by: Yaniv Rosner <yanivr@broadcom.com>
Signed-off-by: Eilon Greenstein <eilong@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Fix link on BCM57712 + BCM8073 when port swap is enabled. Common PHY reset was done on the wrong port.
Signed-off-by: Yaniv Rosner <yanivr@broadcom.com>
Signed-off-by: Eilon Greenstein <eilong@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>