Commit d50f4630c2 ("arm: dts: Remove p1010-flexcan compatible from imx
series dts") removed the fallback compatible "fsl,p1010-flexcan" from
the imx device trees. As the flexcan cores on i.MX25, i.MX35 and i.MX53
are identical, introduce the first as fallback for the two latter ones.
Fixes: d50f4630c2 ("arm: dts: Remove p1010-flexcan compatible from imx series dts")
Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
Cc: linux-stable <stable@vger.kernel.org> # >= v4.16
Signed-off-by: Marc Kleine-Budde <mkl@pengutronix.de>
In commit 88462d2a78 ("can: flexcan: Remodel FlexCAN register r/w APIs
for big endian FlexCAN controllers.") the following logic was
implemented:
if the dt property "big-endian" is given or
the device is compatible to "fsl,p1010-flexcan":
use big-endian mode;
else
use little-endian mode;
This relies on commit d50f4630c2 ("arm: dts: Remove p1010-flexcan
compatible from imx series dts") which was applied a few commits later.
Without this commit (or an old device tree used for booting a new
kernel) the flexcan devices on i.MX25, i.MX28, i.MX35 and i.MX53 match
the 'the device is compatible to "fsl,p1010-flexcan"' test and so are
switched erroneously to big endian mode.
Instead of the check above put a quirk in devtype data and rely on
of_match_device yielding the most compatible match
Fixes: 88462d2a78 ("can: flexcan: Remodel FlexCAN register r/w APIs for big endian FlexCAN controllers.")
Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
Tested-by: Gavin Schenk <g.schenk@eckelmann.de>
Cc: linux-stable <stable@vger.kernel.org> # >= v4.16
Signed-off-by: Marc Kleine-Budde <mkl@pengutronix.de>
bus-off is usually caused by hardware malfunction or configuration error
(baud rate mismatch) and causes a complete loss of communication.
Increase the "bus-off" message's severity from netdev_dbg() to
netdev_info() to make it visible to the user.
A can interface going into bus-off is similar in severity to ethernet's
"Link is Down" message, which is also printed at info level.
It is debatable whether the the "restarted" message should also be
changed to netdev_info() to make the interface state changes
comprehensible from the kernel log. I have chosen to keep the
"restarted" message at dbg for now as the "bus-off" message should be
enough for the user to notice and investigate the problem.
Signed-off-by: Jakob Unterwurzacher <jakob.unterwurzacher@theobroma-systems.com>
Cc: linux-can@vger.kernel.org
Cc: linux-kernel@vger.kernel.org
Signed-off-by: Marc Kleine-Budde <mkl@pengutronix.de>
Igor Russkikh says:
====================
Aquantia various patches 2018-05
These are two patches covering issues found during test cycles:
First is that driver should declare valid vlan_features
Second fix is about correct allocation of MSI interrupts on some systems.
====================
Signed-off-by: David S. Miller <davem@davemloft.net>
Driver should use pci_alloc_irq_vectors return value to correct number
of allocated vectors and napi instances. Otherwise it'll panic later
in pci_irq_vector.
Driver also should allow more than one MSI vectors to be allocated.
Error return path from pci_alloc_irq_vectors is also fixed to revert
resources in a correct sequence when error happens.
Reported-by: Long, Nicholas <nicholas.a.long@baesystems.com>
Fixes: 23ee07a ("net: aquantia: Cleanup pci functions module")
Signed-off-by: Igor Russkikh <igor.russkikh@aquantia.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
In particular, not reporting SG forced skbs to be linear for vlan
interfaces over atlantic NIC.
With this fix it is possible to enable SG feature on device and
therefore optimize performance.
Reported-by: Ma Yuying <yuma@redhat.com>
Signed-off-by: Igor Russkikh <igor.russkikh@aquantia.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
This patch removes "experimental" from the help text where depends on
CONFIG_EXPERIMENTAL was already removed.
Signed-off-by: Georg Hofmann <georg@hofmannsweb.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Replace my old E-Mail address with a working one.
While at it, change the maintainance status to
'Odd Fixes'. I'm still around with some knowledge,
but don't actively maintain it anymore.
Signed-off-by: Steffen Klassert <steffen.klassert@secunet.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Steffen Klassert says:
====================
pull request (net): ipsec 2018-05-07
1) Always verify length of provided sadb_key to fix a
slab-out-of-bounds read in pfkey_add. From Kevin Easton.
2) Make sure that all states are really deleted
before we check that the state lists are empty.
Otherwise we trigger a warning.
3) Fix MTU handling of the VTI6 interfaces on
interfamily tunnels. From Stefano Brivio.
====================
Signed-off-by: David S. Miller <davem@davemloft.net>
In the case of writing a partial tls record we forgot to clear the
ctx->in_tcp_sendpages flag, causing some connections to stall.
Fixes: c212d2c7fc ("net/tls: Don't recursively call push_record during tls_write_space callbacks")
Signed-off-by: Andre Tomt <andre@tomt.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
Most of the mv88e6xxx switches have the PHYs at address 0, 1, 2, ...
The 6341 however has the PHYs at 0x10, 0x11, 0x12. Add a parameter to
the info structure for this base address.
Testing of 6f88284f3b ("net: dsa: mv88e6xxx: Add MDIO interrupts for
internal PHYs") was performed on the 6341. So it works only on the
6341. Use this base information to correctly set the interrupt.
Fixes: 6f88284f3b ("net: dsa: mv88e6xxx: Add MDIO interrupts for internal PHYs")
Signed-off-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: David S. Miller <davem@davemloft.net>
Now sctp only delays the authentication for the normal cookie-echo
chunk by setting chunk->auth_chunk in sctp_endpoint_bh_rcv(). But
for the duplicated one with auth, in sctp_assoc_bh_rcv(), it does
authentication first based on the old asoc, which will definitely
fail due to the different auth info in the old asoc.
The duplicated cookie-echo chunk will create a new asoc with the
auth info from this chunk, and the authentication should also be
done with the new asoc's auth info for all of the collision 'A',
'B' and 'D'. Otherwise, the duplicated cookie-echo chunk with auth
will never pass the authentication and create the new connection.
This issue exists since very beginning, and this fix is to make
sctp_assoc_bh_rcv() follow the way sctp_endpoint_bh_rcv() does
for the normal cookie-echo chunk to delay the authentication.
While at it, remove the unused params from sctp_sf_authenticate()
and define sctp_auth_chunk_verify() used for all the places that
do the delayed authentication.
v1->v2:
fix the typo in changelog as Marcelo noticed.
Acked-by: Marcelo Ricardo Leitner <marcelo.leitner@gmail.com>
Signed-off-by: Xin Long <lucien.xin@gmail.com>
Acked-by: Neil Horman <nhorman@tuxdriver.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Fixes the following warnings:
warning: pointer targets in passing argument 1 of
‘is_valid_ether_addr’ differ in signedness [-Wpointer-sign]
if (mac_addr && is_valid_ether_addr(mac_addr)) {
^~~~~~~~
expected ‘const u8 * {aka const unsigned char *}’ but argument
is of type ‘const char *’
static inline bool is_valid_ether_addr(const u8 *addr)
^~~~~~~~~~~~~~~~~~~
warning: pointer targets in passing argument 2 of
‘ether_addr_copy’ differ in signedness [-Wpointer-sign]
ether_addr_copy(ndev->dev_addr, mac_addr);
^~~~~~~~
expected ‘const u8 * {aka const unsigned char *}’ but argument
is of type ‘const char *’
static inline void ether_addr_copy(u8 *dst, const u8 *src)
Signed-off-by: Moritz Fischer <mdf@kernel.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
Fix issue where nixge_get_nvmem_address() returns a non-NULL
return value on a failed nvmem_cell_get() that causes an invalid
access when error value encoded in pointer is dereferenced.
Furthermore ensure that buffer allocated by nvmem_cell_read()
actually gets kfreed() if the function succeeds.
Fixes commit 492caffa8a ("net: ethernet: nixge: Add support for
National Instruments XGE netdev")
Reported-by: Alex Williams <alex.williams@ni.com>
Signed-off-by: Moritz Fischer <mdf@kernel.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
When a script file that isn't generated uses the variable
TEST_GEN_PROGS_EXTENDED and a 'make -C tools/testing/selftests clean' is
performed the script file gets removed and git shows the file as
deleted. For script files that isn't generated TEST_PROGS_EXTENDED
should be used.
Fixes: 9faedd643f ("selftests: net: add in_netns.sh TEST_GEN_PROGS_EXTENDED")
Signed-off-by: Anders Roxell <anders.roxell@linaro.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
Johan Hedberg says:
====================
pull request: bluetooth 2018-05-07
Here are a few more Bluetooth fixes for the 4.17 kernel, all for the
btusb driver. Two relate to the needs_reset_resume table, and one is a
revert of a patch for Atheros 1525/QCA6174 which caused a regression for
some people.
====================
Signed-off-by: David S. Miller <davem@davemloft.net>
Daniel Borkmann says:
====================
pull-request: bpf 2018-05-05
The following pull-request contains BPF updates for your *net* tree.
The main changes are:
1) Sanitize attr->{prog,map}_type from bpf(2) since used as an array index
to retrieve prog/map specific ops such that we prevent potential out of
bounds value under speculation, from Mark and Daniel.
====================
Signed-off-by: David S. Miller <davem@davemloft.net>
In an SFP EEPROM values can be read to get information about a given SFP
module. One of those is the bitrate, which can be determined using a
nominal bitrate in addition with min and max values (in %). The SFP code
currently compute both BR,min and BR,max values thanks to this nominal
and min,max values.
This patch fixes the BR,min computation as the min value should be
subtracted to the nominal one, not added.
Fixes: 9962acf7fb ("sfp: add support for 1000Base-PX and 1000Base-BX10")
Signed-off-by: Antoine Tenart <antoine.tenart@bootlin.com>
Signed-off-by: David S. Miller <davem@davemloft.net>