PCI core will initialize device MSI/MSI-X capability in
pci_msi_init_pci_dev(). So device driver should use
pci_dev->msi_cap/msix_cap to determine whether the device
support MSI/MSI-X instead of using
pci_find_capability(pci_dev, PCI_CAP_ID_MSI/MSIX).
Access to PCIe device config space again will consume more time.
Signed-off-by: Yijing Wang <wangyijing@huawei.com>
Signed-off-by: Jon Mason <jon.mason@intel.com>
Add support for Non-Transparent Bridge connected to a PCI-E Root Port on
the remote system (also known as NTB-RP mode). This allows for a NTB
enabled system to be connected to a non-NTB enabled system/slot.
Modifications to the registers and BARs/MWs on the Secondary side by the
remote system are reflected into registers on the Primary side for the
local system. Similarly, modifications of registers and BARs/MWs on
Primary side by the local system are reflected into registers on the
Secondary side for the Remote System. This allows communication between
the 2 sides via these registers and BARs/MWs.
Note: there is not a fix for the Xeon Errata (that was already worked
around in NTB-B2B mode) for NTB-RP mode. Due to this limitation, NTB-RP
will not work on the Secondary side with the Xeon Errata workaround
enabled. To get around this, disable the workaround via the
xeon_errata_workaround=0 modparm. However, this can cause the hang
described in the errata.
Signed-off-by: Jon Mason <jon.mason@intel.com>
Many variable names in the NTB driver refer to the primary or secondary
side. However, these variables will be used to access the reverse case
when in NTB-RP mode. Make these names more generic in anticipation of
NTB-RP support.
Signed-off-by: Jon Mason <jon.mason@intel.com>
Allocate and use a DMA engine channel to transmit and receive data over
NTB. If none is allocated, fall back to using the CPU to transfer data.
Signed-off-by: Jon Mason <jon.mason@intel.com>
Reviewed-by: Dan Williams <dan.j.williams@intel.com>
Reviewed-by: Dave Jiang <dave.jiang@intel.com>
Correct the issues on NTB that prevented it from working on x86_32 and
modify the Kconfig to allow it to be permitted to be used in that
environment as well.
Signed-off-by: Jon Mason <jon.mason@intel.com>
Add support for new Intel NTB devices on upcoming Xeon hardware. Since
the Xeon hardware design is already in place in the driver, all that is
needed are the new device ids.
Remove the device IDs for NTB devs running in Transparent Bridge mode,
as this driver is not being used for those devices.
Rename the device IDs for NTB devs running in NTB-RP mode to better
identify their usage model. "PS" to denote the Primary Side of NTB, and
"SS" to denote the secondary side. The primary side is the interface
exposed to the local system, and the secondary side is the interface
exposed to the remote system.
Signed-off-by: Jon Mason <jon.mason@intel.com>
The BWD NTB device will drop the link if an error is encountered on the
point-to-point PCI bridge. The link will stay down until all errors are
cleared and the link is re-established. On link down, check to see if
the error is detected, if so do the necessary housekeeping to try and
recover from the error and reestablish the link.
There is a potential race between the 2 NTB devices recovering at the
same time. If the times are synchronized, the link will not recover and the
driver will be stuck in this loop forever. Add a random interval to the
recovery time to prevent this race.
Signed-off-by: Jon Mason <jon.mason@intel.com>
Debugfs was setup in NTB to only have a single debugfs directory. This
resulted in the leaking of debugfs directories and files when multiple
NTB devices were present, due to each device stomping on the variables
containing the previous device's values (thus preventing them from being
freed on cleanup). Correct this by creating a secondary directory of
the PCI BDF for each device present, and nesting the previously existing
information in those directories.
Signed-off-by: Jon Mason <jon.mason@intel.com>
Due to ambiguous documentation, the USD/DSD identification is backward
when compared to the setting in BIOS. Correct the bits to match the
BIOS setting.
Signed-off-by: Jon Mason <jon.mason@intel.com>
The NTB Xeon hardware has 16 scratch pad registers and 16 back-to-back
scratch pad registers. Correct the #define to represent this and update
the variable names to reflect their usage.
Signed-off-by: Jon Mason <jon.mason@intel.com>
If an error is encountered in ntb_device_setup, it is possible that the
spci_cmd isn't populated. Writes to the offset can result in a NULL
pointer dereference. This issue is easily encountered by running in
NTB-RP mode, as it currently is not supported and will generate an
error. To get around this issue, return if an error is encountered
prior to attempting to write to the spci_cmd offset.
Signed-off-by: Jon Mason <jon.mason@intel.com>
Pull SCSI fix from James Bottomley:
"This is a bug fix for the pm80xx driver. It turns out that when the
new hardware support was added in 3.10 the IO command size was kept at
the old hard coded value. This means that the driver attaches to some
new cards and then simply hangs the system"
* tag 'scsi-fixes' of git://git.kernel.org/pub/scm/linux/kernel/git/jejb/scsi:
[SCSI] pm80xx: fix Adaptec 71605H hang
Pull x86 boot fix from Peter Anvin:
"A single very small boot fix for very large memory systems (> 0.5T)"
* 'x86-urgent-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/tip:
x86/mm: Fix boot crash with DEBUG_PAGE_ALLOC=y and more than 512G RAM
Pull slave-dma fix from Vinod Koul:
"A fix for resolving TI_EDMA driver's build error in allmodconfig to
have filter function built in""
* 'fixes' of git://git.infradead.org/users/vkoul/slave-dma:
dma/Kconfig: TI_EDMA needs to be boolean
Pull networking fixes from David Miller:
1) There was a simplification in the ipv6 ndisc packet sending
attempted here, which avoided using memory accounting on the
per-netns ndisc socket for sending NDISC packets. It did fix some
important issues, but it causes regressions so it gets reverted here
too. Specifically, the problem with this change is that the IPV6
output path really depends upon there being a valid skb->sk
attached.
The reason we want to do this change in some form when we figure out
how to do it right, is that if a device goes down the ndisc_sk
socket send queue will fill up and block NDISC packets that we want
to send to other devices too. That's really bad behavior.
Hopefully Thomas can come up with a better version of this change.
2) Fix a severe TCP performance regression by reverting a change made
to dev_pick_tx() quite some time ago. From Eric Dumazet.
3) TIPC returns wrongly signed error codes, fix from Erik Hugne.
4) Fix OOPS when doing IPSEC over ipv4 tunnels due to orphaning the
skb->sk too early. Fix from Li Hongjun.
5) RAW ipv4 sockets can use the wrong routing key during lookup, from
Chris Clark.
6) Similar to #1 revert an older change that tried to use plain
alloc_skb() for SYN/ACK TCP packets, this broke the netfilter owner
mark which needs to see the skb->sk for such frames. From Phil
Oester.
7) BNX2x driver bug fixes from Ariel Elior and Yuval Mintz,
specifically in the handling of virtual functions.
8) IPSEC path error propagations to sockets is not done properly when
we have v4 in v6, and v6 in v4 type rules. Fix from Hannes Frederic
Sowa.
9) Fix missing channel context release in mac80211, from Johannes Berg.
10) Fix network namespace handing wrt. SCM_RIGHTS, from Andy
Lutomirski.
11) Fix usage of bogus NAPI weight in jme, netxen, and ps3_gelic
drivers. From Michal Schmidt.
12) Hopefully a complete and correct fix for the genetlink dump locking
and module reference counting. From Pravin B Shelar.
13) sk_busy_loop() must do a cpu_relax(), from Eliezer Tamir.
14) Fix handling of timestamp offset when restoring a snapshotted TCP
socket. From Andrew Vagin.
* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net: (44 commits)
net: fec: fix time stamping logic after napi conversion
net: bridge: convert MLDv2 Query MRC into msecs_to_jiffies for max_delay
mISDN: return -EINVAL on error in dsp_control_req()
net: revert 8728c544a9 ("net: dev_pick_tx() fix")
Revert "ipv6: Don't depend on per socket memory for neighbour discovery messages"
ipv4 tunnels: fix an oops when using ipip/sit with IPsec
tipc: set sk_err correctly when connection fails
tcp: tcp_make_synack() should use sock_wmalloc
bridge: separate querier and query timer into IGMP/IPv4 and MLD/IPv6 ones
ipv6: Don't depend on per socket memory for neighbour discovery messages
ipv4: sendto/hdrincl: don't use destination address found in header
tcp: don't apply tsoffset if rcv_tsecr is zero
tcp: initialize rcv_tstamp for restored sockets
net: xilinx: fix memleak
net: usb: Add HP hs2434 device to ZLP exception table
net: add cpu_relax to busy poll loop
net: stmmac: fixed the pbl setting with DT
genl: Hold reference on correct module while netlink-dump.
genl: Fix genl dumpit() locking.
xfrm: Fix potential null pointer dereference in xdst_queue_output
...
Pull sound fixes from Takashi Iwai:
"This contains two Oops fixes (opti9xx and HD-audio) and a simple fixup
for an Acer laptop. All marked as stable patches"
* tag 'sound-3.11' of git://git.kernel.org/pub/scm/linux/kernel/git/tiwai/sound:
ALSA: opti9xx: Fix conflicting driver object name
ALSA: hda - Fix NULL dereference with CONFIG_SND_DYNAMIC_MINORS=n
ALSA: hda - Add inverted digital mic fixup for Acer Aspire One
Pull ARM SoC fixes from Olof Johansson:
"Two straggling fixes that I had missed as they were posted a couple of
weeks ago, causing problems with interrupts (breaking them completely)
on the CSR SiRF platforms"
* tag 'fixes-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc:
arm: prima2: drop nr_irqs in mach as we moved to linear irqdomain
irqchip: sirf: move from legacy mode to linear irqdomain
Yijing Wang
Jon Mason
Linus Torvalds
Ian Campbell