Core Changes:
- Stop proliferation of drm_vblank_cleanup by adding to the docs and deleting
boilerplate (Daniel)
- Roll out and use mode_valid hooks across crtc/encoder/bridge (Jose)
- Add drm_vblank.[hc] to isolate vblank code from optional irq helpers (Daniel)
Driver Changes:
- Replace drm_for_each_connector with drm_for_each_connector_iter (Gustavo)
- A couple misc driver fixes
Cc: Gustavo Padovan <gustavo.padovan@collabora.com>
Cc: Jose Abreu <Jose.Abreu@synopsys.com>
Cc: Daniel Vetter <daniel.vetter@intel.com>
* tag 'drm-misc-next-2017-06-02' of git://anongit.freedesktop.org/git/drm-misc: (34 commits)
drm/vc4: Mark the device as active when enabling runtime PM.
drm: remove writeq/readq function definitions
drm/atmel-hlcdc: Use crtc->mode_valid() callback
drm/exynos: Drop drm_vblank_cleanup
drm/hdlcd|mali: Drop drm_vblank_cleanup
drm/doc: Polish irq helper documentation
drm: Extract drm_vblank.[hc]
drm/vc4: Fix comment in vc4_drv.h
drm/pl111: fix warnings without CONFIG_ARM_AMBA
drm/atomic: Consitfy mode parameter to drm_atomic_set_mode_for_crtc()
drm/arcgpu: Drop drm_vblank_cleanup
drm/atmel: Drop drm_vblank_cleanup
drm/imx: Drop drm_vblank_cleanup
drm/meson: Drop drm_vblank_cleanup
drm/stm: Drop drm_vblank_cleanup
drm/sun4i: Drop drm_vblank_cleanup
drm: better document how to send out the crtc disable event
drm: Use vsnprintf extension %ph
drm/doc: move printf helpers out of drmP.h
drm/pl111: select DRM_PANEL
...
omap_gem uses page alignment for buffer stride. The related calculations
are a bit off, though, as byte stride of 4096 gets aligned to 8192,
instead of 4096.
This patch changes the code to use DIV_ROUND_UP(), which fixes those
calculations and makes them more readable.
Signed-off-by: Tomi Valkeinen <tomi.valkeinen@ti.com>
Reviewed-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
When rotating 90/270 + mirroring with YUV422, the end result will have
adjacent pixels swapped. The problem is that
dispc_ovl_set_rotation_attrs() has wrong rotation values for these
cases.
Signed-off-by: Tomi Valkeinen <tomi.valkeinen@ti.com>
Reviewed-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
TILER rotation with YUV422 pixelformats does not work at the moment. All
other pixel formats work, because the pixelformat's pixel size is equal
to tiler unit size (e.g. XR24's pixel size is 32 bits, and the TILER
unit size that has to be used is 32 bits).
For YUV422 formats this is not the case, as the TILER unit size has to
be 32 bits, but the pixel size is 16 bits. The end result is OCP errors
and sync losts.
This patch adds the code to adjust the variables for YUV422 formats.
We could make the code more generic by passing around the pixel format,
rotation type, angle and the tiler unit size, which would allow us to do
calculations without special case for YUV422. However, this would make
the code more complex, and at least for now this is much more easier to
handle with these two special cases for YUV422.
Signed-off-by: Tomi Valkeinen <tomi.valkeinen@ti.com>
Reviewed-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
The omapdrm driver has not passed the rotation value to the dispc
driver. This doesn't affect RGB formats, but YUV formats don't work
without dispc knowing the orientation.
Signed-off-by: Tomi Valkeinen <tomi.valkeinen@ti.com>
Reviewed-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
At the moment the dispc driver uses a custom enum for rotation. Change
it to use the DRM's DRM_MODE_ROTATE_*.
Note that mirroring is at the moment handled as a separate boolean in
the dispc driver, so we only use the DRM_MODE_ROTATE_* values.
Note, DSS HW uses clockwise rotation, DRM counter-clockwise.
Signed-off-by: Tomi Valkeinen <tomi.valkeinen@ti.com>
Reviewed-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
struct omap_drm_window is only used to pass plane setup data to
omap_framebuffer_update_scanout(). This can as well be accomplished by
just passing the DRM state.
Signed-off-by: Tomi Valkeinen <tomi.valkeinen@ti.com>
Reviewed-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
Add a helper function to convert DRM rotation to TILER rotation.
Also drop a error print that can never happen, as the DRM framework
makes sure the rotation is valid.
Signed-off-by: Tomi Valkeinen <tomi.valkeinen@ti.com>
Reviewed-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
omap_fb.c has a table with DSS and DRM formats, used to convert between
them. This is no longer needed, so we can change the array to a plain
array of DRM_FORMAT_* values which contain all possible pixel formats
supported by any DSS IP version.
Signed-off-by: Tomi Valkeinen <tomi.valkeinen@ti.com>
Reviewed-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
We now get a fourcc array from dispc when asking for a plane's supported
pixel formats, so we can drop omap_framebuffer_get_formats() which was
used to convert between DSS and DRM pixel formats.
Signed-off-by: Tomi Valkeinen <tomi.valkeinen@ti.com>
Reviewed-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
enum omap_color_mode is a bitmask, so at the moment we present the
supported color modes as mask. To be able to move to fourccs, we need to
use an array to present the supported color modes.
As a first step towards fourccs, this patch changes the code to use an
array to store the enums.
Signed-off-by: Tomi Valkeinen <tomi.valkeinen@ti.com>
Acked-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
omapdss.h contains prototypes for three functions, which are also
defined in dss_features.h. Remove the extra prototypes from omapdss.h.
Signed-off-by: Tomi Valkeinen <tomi.valkeinen@ti.com>
Reviewed-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
In a few places the dispc driver needs to know whether the pixel format
is an YUV format. Add a helper to figure that out.
Signed-off-by: Tomi Valkeinen <tomi.valkeinen@ti.com>
Reviewed-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
We have three rotation methods supported by the SoCs with DSS: DMA,
VRFB and TILER.
DMA rotation works in theory on all DSS platforms, but in practice it's
unusable due to the huge amount of memory bandwidth it uses, and has
never really been used.
VRFB is available on OMAP3, but is not supported by omapdrm, even though
we have some code for it in the dispc driver.
TILER is supported on OMAP4/OMAP5/DRA7/AM5 platforms, but has some
driver bugs.
To clean up the driver to help fixing the TILER issues, this patch drops
the DMA and VRFB rotation support, leaving only TILER rotation.
Signed-off-by: Tomi Valkeinen <tomi.valkeinen@ti.com>
Acked-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
DSS IP versions 2 and 3 support CLUT modes (color lookup table), but the
driver has never supported those. We still have had some code for CLUT
modes. As the newer DSS IP versions have dropped CLUT support, we might
as well clean up the driver by removing the CLUT related code.
Signed-off-by: Tomi Valkeinen <tomi.valkeinen@ti.com>
Reviewed-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
Dave Airlie
Eric Anholt
Corentin Labbe
Jose Abreu
Tomi Valkeinen