Pull ARM SoC fixes from Olof Johansson:
"The latest and greatest fixes for ARM platform code. Worth pointing
out are:
- Lines-wise, largest is a PXA fix for dealing with interrupts on DT
that was quite broken. It's still newish code so while we could
have held this off, it seemed appropriate to include now
- Some GPIO fixes for OMAP platforms added a few lines. This was
also fixes for code recently added (this release).
- Small OMAP timer fix to behave better with partially upstreamed
platforms, which is quite welcome.
- Allwinner fixes about operating point control, reducing
overclocking in some cases for better stability.
plus a handful of other smaller fixes across the map"
* tag 'armsoc-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc:
arm64: juno: Fix misleading name of UART reference clock
ARM: dts: sunxi: Remove overclocked/overvoltaged OPP
ARM: dts: sun4i: a10-lime: Override and remove 1008MHz OPP setting
ARM: socfpga: dts: fix spi1 interrupt
ARM: dts: Fix gpio interrupts for dm816x
ARM: dts: dra7: remove ti,hwmod property from pcie phy
ARM: OMAP: dmtimer: disable pm runtime on remove
ARM: OMAP: dmtimer: check for pm_runtime_get_sync() failure
ARM: OMAP2+: Fix socbus family info for AM33xx devices
ARM: dts: omap3: Add missing dmas for crypto
ARM: dts: rockchip: disable gmac by default in rk3288.dtsi
MAINTAINERS: add rockchip regexp to the ARM/Rockchip entry
ARM: pxa: fix pxa interrupts handling in DT
ARM: pxa: Fix typo in zeus.c
ARM: sunxi: Have ARCH_SUNXI select RESET_CONTROLLER for clock driver usage
Allwinner fixes for 4.0
There's a few fixes to merge for 4.0, one to add a select in the machine
Kconfig option to fix a potential build failure, and two fixing cpufreq related
issues.
* tag 'sunxi-fixes-for-4.0' of https://git.kernel.org/pub/scm/linux/kernel/git/mripard/linux:
ARM: dts: sunxi: Remove overclocked/overvoltaged OPP
ARM: dts: sun4i: a10-lime: Override and remove 1008MHz OPP setting
ARM: sunxi: Have ARCH_SUNXI select RESET_CONTROLLER for clock driver usage
Signed-off-by: Olof Johansson <olof@lixom.net>
Fixes for omaps for the -rc cycle:
- Fix a device tree based booting vs legacy booting regression for
omap3 crypto hardware by adding the missing DMA channels.
- Fix /sys/bus/soc/devices/soc0/family for am33xx devices.
- Fix two timer issues that can cause hangs if the timer related
hwmod data is missing like it often initially is for new SoCs.
- Remove pcie hwmods entry from dts as that causes runtime PM to
fail for the PHYs.
- A paper bag type dts configuration fix for dm816x GPIO
interrupts that I just noticed. This is most of the changes
diffstat wise, but as it's a basic feature for connecting
devices and things work otherwise, it should be fixed.
* tag 'fixes-v4.0-rc4' of git://git.kernel.org/pub/scm/linux/kernel/git/tmlind/linux-omap:
ARM: dts: Fix gpio interrupts for dm816x
ARM: dts: dra7: remove ti,hwmod property from pcie phy
ARM: OMAP: dmtimer: disable pm runtime on remove
ARM: OMAP: dmtimer: check for pm_runtime_get_sync() failure
ARM: OMAP2+: Fix socbus family info for AM33xx devices
ARM: dts: omap3: Add missing dmas for crypto
Signed-off-by: Olof Johansson <olof@lixom.net>
Late fix for v4.0 on the SoCFPGA platform:
- Fix interrupt number for SPI1 interface
* tag 'socfpga_fix_for_v4.0_2' of git://git.rocketboards.org/linux-socfpga-next:
ARM: socfpga: dts: fix spi1 interrupt
Signed-off-by: Olof Johansson <olof@lixom.net>
The UART reference clock speed is 7273.8 kHz, not 72738 kHz.
Dots aren't usually used in node names even though ePAPR permits
them. However, this can easily be avoided by expressing the
frequency in Hz, not kHz.
This patch changes the name to refclk7273800hz, reflecting the
actual clock speed.
Signed-off-by: Dave Martin <Dave.Martin@arm.com>
Acked-by: Liviu Dudau <Liviu.Dudau@arm.com>
Signed-off-by: Olof Johansson <olof@lixom.net>
arm: pxa: fixes for v4.0-rc5
There are only 2 fixes, one for the zeus board about the regulator changes,
where a typo prevented the zeus board from having a working can regulator,
and one regression triggered by the interrupts IRQ shift of 16 affecting all
boards.
* tag 'fixes-for-v4.0-rc5' of https://github.com/rjarzmik/linux:
ARM: pxa: fix pxa interrupts handling in DT
ARM: pxa: Fix typo in zeus.c
Signed-off-by: Olof Johansson <olof@lixom.net>
Pull x86 fix from Ingo Molnar:
"Fix x86 syscall exit code bug that resulted in spurious non-execution
of TIF-driven user-return worklets, causing big trouble for things
like KVM that rely on user notifiers for correctness of their vcpu
model, causing crashes like double faults"
* 'x86-urgent-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/tip:
x86/asm/entry: Check for syscall exit work with IRQs disabled
Pull scheduler fix from Ingo Molnar:
"A single sched/rt corner case fix for RLIMIT_RTIME correctness"
* 'sched-urgent-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/tip:
sched: Fix RLIMIT_RTTIME when PI-boosting to RT
Pull perf fix from Ingo Molnar:
"A perf kernel side fix for a fuzzer triggered lockup"
* 'perf-urgent-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/tip:
perf: Fix irq_work 'tail' recursion
Pull locking fix from Ingo Molnar:
"A module unload lockdep race fix"
* 'locking-urgent-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/tip:
lockdep: Fix the module unload key range freeing logic
Pull parsic fixes from Helge Deller:
"One patch from Mikulas fixes a bug on parisc by artifically
incrementing the counter in pmd_free when the kernel tries to free
the preallocated pmd.
Other than that we now prevent that syscalls gets added without
incrementing __NR_Linux_syscalls and fix the initial pmd setup code
if a default page size greater than 4k has been selected"
* 'parisc-4.0-1' of git://git.kernel.org/pub/scm/linux/kernel/git/deller/parisc-linux:
parisc: Fix pmd code to depend on PT_NLEVELS value, not on CONFIG_64BIT
parisc: mm: don't count preallocated pmds
parisc: Add compile-time check when adding new syscalls
Pull ARC fixes from Vineet Gupta:
"We found some issues with signal handling taking down the system. I
know its late, but these are important and all marked for stable.
ARC signal handling related fixes uncovered during recent testing of
NPTL tools"
* tag 'arc-4.0-fixes-part-2' of git://git.kernel.org/pub/scm/linux/kernel/git/vgupta/arc:
ARC: signal handling robustify
ARC: SA_SIGINFO ucontext regs off-by-one
Pull selinux bugfix from James Morris.
Fix broken return value.
* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/jmorris/linux-security:
selinux: fix sel_write_enforce broken return value
Pull sound fixes from Takashi Iwai:
"Three trivial oneliner fixes for HD-audio.
Two are device-specific quirks while one is a generic fix for recent
Realtek codecs"
* tag 'sound-4.0-rc6' of git://git.kernel.org/pub/scm/linux/kernel/git/tiwai/sound:
ALSA: hda - Add one more node in the EAPD supporting candidate list
ALSA: hda_intel: apply the Seperate stream_tag for Sunrise Point
ALSA: hda - Add dock support for Thinkpad T450s (17aa:5036)
The IMG PDC watchdog driver heartbeat module parameter has no default so
it is initialised to zero. This results in the following warning during
probe:
imgpdc-wdt 2006000.wdt: Initial timeout out of range! setting max timeout
The module parameter description implies that the default value should
be PDC_WDT_DEF_TIMEOUT, which isn't yet used, so initialise it to that.
Also tweak the heartbeat module parameter description for consistency.
Fixes: 93937669e9 ("watchdog: ImgTec PDC Watchdog Timer Driver")
Signed-off-by: James Hogan <james.hogan@imgtec.com>
Cc: Ezequiel Garcia <ezequiel.garcia@imgtec.com>
Cc: Naidu Tellapati <Naidu.Tellapati@imgtec.com>
Cc: Jude Abraham <Jude.Abraham@imgtec.com>
Cc: linux-watchdog@vger.kernel.org
Reviewed-by: Guenter Roeck <linux@roeck-us.net>
Signed-off-by: Wim Van Sebroeck <wim@iguana.be>
The IMG PDC watchdog probe function calls pdc_wdt_stop() prior to
watchdog_set_drvdata(), causing a NULL pointer dereference when
pdc_wdt_stop() retrieves the struct pdc_wdt_dev pointer using
watchdog_get_drvdata() and reads the register base address through it.
Fix by moving the watchdog_set_drvdata() call earlier, to where various
other pdc_wdt->wdt_dev fields are initialised.
Fixes: 93937669e9 ("watchdog: ImgTec PDC Watchdog Timer Driver")
Signed-off-by: James Hogan <james.hogan@imgtec.com>
Cc: Ezequiel Garcia <ezequiel.garcia@imgtec.com>
Cc: Naidu Tellapati <Naidu.Tellapati@imgtec.com>
Cc: Jude Abraham <Jude.Abraham@imgtec.com>
Cc: linux-watchdog@vger.kernel.org
Reviewed-by: Guenter Roeck <linux@roeck-us.net>
Signed-off-by: Wim Van Sebroeck <wim@iguana.be>
"ret" should be signed for the error handling to work correctly. This
doesn't matter much in real life since mtk_wdt_set_timeout() always
succeeds.
Signed-off-by: Dan Carpenter <dan.carpenter@oracle.com>
Reviewed-by: Matthias Brugger <matthias.bgg@gmail.com>
Reviewed-by: Guenter Roeck <linux@roeck-us.net>
Signed-off-by: Wim Van Sebroeck <wim@iguana.be>
Ingo Molnar
Ross Zwisler
Christoph Hellwig
Linus Torvalds
Olof Johansson
Dave Martin
James Morris
James Hogan
Dan Carpenter