Generate a unique inode numbers for any entries in the cram file system.
For files which did not contain data's (device nodes, fifos and sockets)
the offset of the directory entry inside the cramfs plus 1 will be used as
inode number.
The + 1 for the inode will it make possible to distinguish between a file
which contains no data and files which has data, the later one has a inode
value where the lower two bits are always 0.
It also reimplements the behavior to set the size and the number of block
to 0 for special file, which is the right value for empty files, devices,
fifos and sockets
As a little benefit it will be also more compatible which older mkcramfs,
because it will never use the cramfs_inode->offset for creating a inode
number for special files.
[akpm@linux-foundation.org: trivial comment fix]
[akpm@linux-foundation.org: coding-style fixes]
Signed-off-by: Stefani Seibold <stefani@seibold.net>
Cc: Al Viro <viro@zeniv.linux.org.uk>
Cc: Pekka Enberg <penberg@kernel.org>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
aio_run_iocbs() is not used at all, so get rid of it.
[akpm@linux-foundation.org: coding-style fixes]
Signed-off-by: Jeff Moyer <jmoyer@redhat.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
When hypervisor decides to decrease target balloon size while the balloon
driver tries to lock pages hypervisor may respond with
VMW_BALLOON_PPN_NOTNEEDED. Use this data and immediately stop reserving
pages and wait for the next update cycle to fetch new target instead of
continuing trying to lock pages until size of refused list grows above
VMW_BALLOON_MAX_REFUSED (16) pages.
As a result the driver stops bothering the hypervisor with its attempts to
lock more pages that are not needed anymore. Most likely next order from
hypervisor will be to reduce ballon size anyway.
It is a small optimization.
Signed-off-by: Dmitry Torokhov <dtor@vmware.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
Apart from currently used standard memstick data transfer method, Sony
introduced several newer ones, to uncover full bandwidth/capacity of its
Pro, HG and XC media formats. This patch lays a foundation to enable
those methods as made possible by host/media capabilities.
As a side effect of this patch, mspro_block_read_attributes became more
streamlined and readable.
[akpm@linux-foundation.org: fix printk warning]
Signed-off-by: Alex Dubov <oakad@yahoo.com>
Reported-by: Maxim Levitsky <maximlevitsky@gmail.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
Implement the usual pattern around idr_pre_get() and idr_get_new() to
handlethe situation where another thread concurrently steals this thread's
idr_pre_get() preallocation.
Signed-off-by: Alex Dubov <oakad@yahoo.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
This patch corrects the definition of clock values for JMicron 38x
controllers and sets the value properly per interface type.
Also, it adds a check for TPC errors in the interrupt handler.
Signed-off-by: Aries Lee <arieslee@jmicron.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Cc: Alex Dubov <oakad@yahoo.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
Add PPS signal generator which utilizes STROBE pin of a parallel port to
send PPS signals. It uses parport abstraction layer and hrtimers to
precisely control the signal.
Signed-off-by: Alexander Gordeev <lasaine@lvk.cs.msu.su>
Cc: Rodolfo Giometti <giometti@linux.it>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
Add PPS signal generator which utilizes STROBE pin of a parallel port to
send PPS signals. It uses parport abstraction layer and hrtimers to
precisely control the signal.
[akpm@linux-foundation.org: fix build]
Signed-off-by: Alexander Gordeev <lasaine@lvk.cs.msu.su>
Acked-by: Rodolfo Giometti <giometti@linux.it>
Cc: john stultz <johnstul@us.ibm.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
Add parallel port PPS client. It uses a standard method for capturing
timestamps for assert edge transitions: getting a timestamp soon after an
interrupt has happened.
This is not a very precise source of time information due to interrupt
handling delays. However, timestamps for clear edge transitions are much
more precise because the interrupt handler continuously polls hardware
port until the transition is done.
Hardware port operations require only about 1us so the maximum error
should not exceed this value. This was my primary goal when developing
this client.
Clear edge capture could be disabled using clear_wait parameter.
Signed-off-by: Alexander Gordeev <lasaine@lvk.cs.msu.su>
Acked-by: Rodolfo Giometti <giometti@linux.it>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
MONOTONIC_RAW clock timestamps are ideally suited for frequency
calculation and also fit well into the original NTP hardpps design. Now
phase and frequency can be adjusted separately: the former based on
REALTIME clock and the latter based on MONOTONIC_RAW clock.
A new function getnstime_raw_and_real is added to timekeeping subsystem to
capture both timestamps at the same time and atomically.
Signed-off-by: Alexander Gordeev <lasaine@lvk.cs.msu.su>
Acked-by: John Stultz <johnstul@us.ibm.com>
Cc: Rodolfo Giometti <giometti@enneenne.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
This commit adds hardpps() implementation based upon the original one from
the NTPv4 reference kernel code from David Mills. However, it is highly
optimized towards very fast syncronization and maximum stickness to PPS
signal. The typical error is less then a microsecond.
To make it sync faster I had to throw away exponential phase filter so
that the full phase offset is corrected immediately. Then I also had to
throw away median phase filter because it gives a bigger error itself if
used without exponential filter.
Maybe we will find an appropriate filtering scheme in the future but it's
not necessary if the signal quality is ok.
Signed-off-by: Alexander Gordeev <lasaine@lvk.cs.msu.su>
Acked-by: John Stultz <johnstul@us.ibm.com>
Cc: Rodolfo Giometti <giometti@enneenne.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
Remove the code that gatheres timestamp in pps_tty_dcd_change() in case
passed ts parameter is NULL because it never happens in the current code.
Fix comments as well.
Signed-off-by: Alexander Gordeev <lasaine@lvk.cs.msu.su>
Acked-by: Rodolfo Giometti <giometti@linux.it>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
This way less overhead is involved when running production kernel. If you
want to debug a pps client module please define DEBUG to enable the
checks.
Signed-off-by: Alexander Gordeev <lasaine@lvk.cs.msu.su>
Acked-by: Rodolfo Giometti <giometti@linux.it>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
Now pps_idr_lock is never used in interrupt context so we can replace
spin_lock_irq/spin_unlock_irq with plain spin_lock/spin_unlock. But
there is also a potential race condition when someone can steal an id
which was allocated by idr_pre_get before it is used. So convert spin
lock to mutex and protect the whole id generation process.
Signed-off-by: Alexander Gordeev <lasaine@lvk.cs.msu.su>
Cc: Rodolfo Giometti <giometti@linux.it>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
Since now idr is only used to manage char device id's and not used in
kernel API anymore it should be moved to pps.c. This also makes it
possible to release id only at actual device freeing so nobody can
register a pps device with the same id while our device is not freed yet.
Signed-off-by: Alexander Gordeev <lasaine@lvk.cs.msu.su>
Acked-by: Rodolfo Giometti <giometti@linux.it>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
Andrew Morton
Stefani Seibold
Alexander Shishkin
Jeff Moyer
Namhyung Kim
Dmitry Torokhov
Mika Laitio
Alex Dubov
Takashi Iwai
Vasiliy Kulikov
Alexander Gordeev