We were pretending to use the GENERIC_ISA_DMA routines, but never
selected that symbol. Since ISA DMA is known to not work right now,
just remove the attempts to acquire the dma_spin_lock to fix compile
warnings.
Signed-off-by: Matthew Wilcox <willy@parisc-linux.org>
Signed-off-by: Kyle McMartin <kyle@parisc-linux.org>
We can compile at least one IDE driver that refers to this. We can't
use the asm-generic file because we have our own definitions of
pcibios_resource_to_bus etc.
Signed-off-by: Matthew Wilcox <willy@parisc-linux.org>
Signed-off-by: Kyle McMartin <kyle@parisc-linux.org>
Joel Soete points out that we refer to pa_tlb_lock but only define it if
CONFIG_SMP which breaks a uniprocessor build with CONFIG_DEBUG_SPINLOCK
enabled. No module refers to pa_tlb_lock, so we can delete the export.
Signed-off-by: Matthew Wilcox <willy@parisc-linux.org>
Signed-off-by: Kyle McMartin <kyle@parisc-linux.org>
GCC no longer allows a cast as lvalue; fix the same way fs/readdir.c was
Signed-off-by: Matthew Wilcox <matthew@wil.cx>
Signed-off-by: Kyle McMartin <kyle@parisc-linux.org>
iounmap's argument needs to be both const and volatile, otherwise we'll
get warnings that we're discarding pointer qualifiers
Signed-off-by: Matthew Wilcox <matthew@wil.cx>
Signed-off-by: Kyle McMartin <kyle@parisc-linux.org>
Pull out struct sba_device and struct lba_device into a
common ropes.h header. Also fold the parisc portion of
iosapic.h into this file. (Then delete the useless portion
of iosapic.h)
Signed-off-by: Kyle McMartin <kyle@parisc-linux.org>
Our prior mode of operation didn't allow nested interrupts
because it makes the interrupt code much simpler. However,
nested interrupts are better for latency.
This code uses the EIEM register to simulate level interrupts
and thus achieve nesting.
Signed-off-by: James Bottomley <James.Bottomley@SteelEye.com>
Signed-off-by: Kyle McMartin <kyle@parisc-linux.org>
This version (relative to the current tree):
o eliminates "while (ticks_elapsed)" loop. It's not needed.
o drop "ticks_elapsed" completely from timer_interrupt().
o Estimates elapsed cycles (based on HZ) to see which kind of
math we want to use to calculate "cycles_remainder".
o Fixes a bug where we would loose a tick if we decided
we wanted to skip one interrupt.
Signed-off-by: Grant Grundler <grundler@parisc-linux.org>
Signed-off-by: Kyle McMartin <kyle@parisc-linux.org>
It's just a bit easier to follow and timer code is complex enough.
So far, only tested on A500-5x (64-bit SMP), ie: gettimeoffset() code
hasn't been tested at all.
Signed-off-by: Grant Grundler <grundler@parisc-linux.org>
Signed-off-by: Kyle McMartin <kyle@parisc-linux.org>
Use the __raw_spin_lock_flags routine so we can take an interrupt while
spinning. This re-fixes a bug jejb found on 2005-10-20:
CPU0 does a flush_tlb_all holding the vmlist_lock for write.
CPU1 tries a cat of /proc/meminfo which tries to acquire vmlist_lock for read
CPU1 is now spinning with interrupts disabled
CPU0 tries to execute a smp_call_function to flush the local tlb caches
This is now a deadlock because CPU1 is spinning with interrupts disabled and
can never receive the IPI
Signed-off-by: Matthew Wilcox <matthew@wil.cx>
Signed-off-by: Kyle McMartin <kyle@parisc-linux.org>
I couldn't find where the itimer was getting started for slave CPUs.
CPU 0 (master) itimer was started in time_init() (arch/parisc/kernel/time.c).
start_cpu_itimer() code was striped from time_init().
Slaves now start their itimer in smp_cpu_init().
This is a first step towards making gettimeoffset() work for SMP.
Next step will be to determine the CR16 (cycle counter)
offsets for each CPU relative to the master (CPU 0).
Signed-off-by: Grant Grundler <grundler@parisc-linux.org>
Signed-off-by: Kyle McMartin <kyle@parisc-linux.org>
This isn't likely to be causing problems for other bits of
kernel code. I can't find any other user of CONFIG_HZ outside
of arch specific code.
Signed-off-by: Grant Grundler <grundler@parisc-linux.org>
Signed-off-by: Kyle McMartin <kyle@parisc-linux.org>