block, bfq: improve responsiveness

This patch introduces a simple heuristic to load applications quickly,
and to perform the I/O requested by interactive applications just as
quickly. To this purpose, both a newly-created queue and a queue
associated with an interactive application (we explain in a moment how
BFQ decides whether the associated application is interactive),
receive the following two special treatments:

1) The weight of the queue is raised.

2) The queue unconditionally enjoys device idling when it empties; in
fact, if the requests of a queue are sync, then performing device
idling for the queue is a necessary condition to guarantee that the
queue receives a fraction of the throughput proportional to its weight
(see [1] for details).

For brevity, we call just weight-raising the combination of these
two preferential treatments. For a newly-created queue,
weight-raising starts immediately and lasts for a time interval that:
1) depends on the device speed and type (rotational or
non-rotational), and 2) is equal to the time needed to load (start up)
a large-size application on that device, with cold caches and with no
additional workload.

Finally, as for guaranteeing a fast execution to interactive,
I/O-related tasks (such as opening a file), consider that any
interactive application blocks and waits for user input both after
starting up and after executing some task. After a while, the user may
trigger new operations, after which the application stops again, and
so on. Accordingly, the low-latency heuristic weight-raises again a
queue in case it becomes backlogged after being idle for a
sufficiently long (configurable) time. The weight-raising then lasts
for the same time as for a just-created queue.

According to our experiments, the combination of this low-latency
heuristic and of the improvements described in the previous patch
allows BFQ to guarantee a high application responsiveness.

[1] P. Valente, A. Avanzini, "Evolution of the BFQ Storage I/O
    Scheduler", Proceedings of the First Workshop on Mobile System
    Technologies (MST-2015), May 2015.
    http://algogroup.unimore.it/people/paolo/disk_sched/mst-2015.pdf

Signed-off-by: Paolo Valente <paolo.valente@linaro.org>
Signed-off-by: Arianna Avanzini <avanzini.arianna@gmail.com>
Signed-off-by: Jens Axboe <axboe@fb.com>

Documentation/block/bfq-iosched.txt

@@ -375,6 +375,11 @@ default, low latency mode is enabled. If enabled, interactive and soft
 real-time applications are privileged and experience a lower latency,
 as explained in more detail in the description of how BFQ works.
 
+DO NOT enable this mode if you need full control on bandwidth
+distribution. In fact, if it is enabled, then BFQ automatically
+increases the bandwidth share of privileged applications, as the main
+means to guarantee a lower latency to them.
+
 timeout_sync
 ------------
 
@@ -507,6 +512,10 @@ linear mapping between ioprio and weights, described at the beginning
 of the tunable section, is still valid, but all weights higher than
 IOPRIO_BE_NR*10 are mapped to ioprio 0.
 
+Recall that, if low-latency is set, then BFQ automatically raises the
+weight of the queues associated with interactive and soft real-time
+applications. Unset this tunable if you need/want to control weights.
+
 
 [1] P. Valente, A. Avanzini, "Evolution of the BFQ Storage I/O
     Scheduler", Proceedings of the First Workshop on Mobile System