generic/081: wait for lv to be settled before creating fs on it

Call 'udevadm settle' or 'udevsettle' or 'sleep 1' to make sure new lv
is ready for use before making filesystem on it, depends on which
command is available on the system.

Signed-off-by: Eryu Guan <eguan@redhat.com>
Reviewed-by: Dave Chinner <dchinner@redhat.com>
Signed-off-by: Dave Chinner <david@fromorbit.com>

common/config

@@ -192,6 +192,24 @@ export DUMP_PROG="`set_prog_path dump`"
 export RESTORE_PROG="`set_prog_path restore`"
 export LVM_PROG="`set_prog_path lvm`"
 
+# use 'udevadm settle' or 'udevsettle' to wait for lv to be settled.
+# newer systems have udevadm command but older systems like RHEL5 don't.
+# But if neither one is available, just set it to "sleep 1" to wait for lv to
+# be settled
+UDEV_SETTLE_PROG="`set_prog_path udevadm`"
+if [ "$UDEV_SETTLE_PROG" == "" ]; then
+	# try udevsettle command
+	UDEV_SETTLE_PROG="`set_prog_path udevsettle`"
+else
+	# udevadm is available, add 'settle' as subcommand
+	UDEV_SETTLE_PROG="$UDEV_SETTLE_PROG settle"
+fi
+# neither command is available, use sleep 1
+if [ "$UDEV_SETTLE_PROG" == "" ]; then
+	UDEV_SETTLE_PROG="sleep 1"
+fi
+export UDEV_SETTLE_PROG
+
 # Generate a comparable xfsprogs version number in the form of
 # major * 10000 + minor * 100 + release
 #

tests/generic/081

@@ -66,6 +66,8 @@ mkdir -p $mnt
 _scratch_mkfs_sized $((300 * 1024 * 1024)) >>$seqres.full 2>&1
 $LVM_PROG vgcreate -f $vgname $SCRATCH_DEV >>$seqres.full 2>&1
 $LVM_PROG lvcreate --yes -L 256M -n $lvname $vgname >>$seqres.full 2>&1
+# wait for lvcreation to fully complete
+$UDEV_SETTLE_PROG >>$seqres.full 2>&1
 
 # _mkfs_dev exits the test on failure, this can make sure lv is created in
 # above vgcreate/lvcreate steps