gecko/security/nss/lib/freebl/mpi/doc/build
2008-06-06 08:40:11 -04:00

67 lines
2.2 KiB
Bash
Executable File

#!/bin/sh
# ***** BEGIN LICENSE BLOCK *****
# Version: MPL 1.1/GPL 2.0/LGPL 2.1
#
# The contents of this file are subject to the Mozilla Public License Version
# 1.1 (the "License"); you may not use this file except in compliance with
# the License. You may obtain a copy of the License at
# http://www.mozilla.org/MPL/
#
# Software distributed under the License is distributed on an "AS IS" basis,
# WITHOUT WARRANTY OF ANY KIND, either express or implied. See the License
# for the specific language governing rights and limitations under the
# License.
#
# The Original Code is the MPI Arbitrary Precision Integer Arithmetic library.
#
# The Initial Developer of the Original Code is
# Michael J. Fromberger <sting@linguist.dartmouth.edu>.
# Portions created by the Initial Developer are Copyright (C) 1998
# the Initial Developer. All Rights Reserved.
#
# Contributor(s):
# Netscape Communications Corporation
#
# Alternatively, the contents of this file may be used under the terms of
# either the GNU General Public License Version 2 or later (the "GPL"), or
# the GNU Lesser General Public License Version 2.1 or later (the "LGPL"),
# in which case the provisions of the GPL or the LGPL are applicable instead
# of those above. If you wish to allow use of your version of this file only
# under the terms of either the GPL or the LGPL, and not to allow others to
# use your version of this file under the terms of the MPL, indicate your
# decision by deleting the provisions above and replace them with the notice
# and other provisions required by the GPL or the LGPL. If you do not delete
# the provisions above, a recipient may use your version of this file under
# the terms of any one of the MPL, the GPL or the LGPL.
#
# ***** END LICENSE BLOCK *****
# $Id: build,v 1.3 2005/02/02 22:28:22 gerv%gerv.net Exp $
#
VERS="1.7p6"
SECT="1"
NAME="MPI Tools"
echo "Building manual pages ..."
case $# in
0)
files=`ls *.pod`
;;
*)
files=$*
;;
esac
for name in $files
do
echo -n "$name ... "
# sname=`noext $name`
sname=`basename $name .pod`
pod2man --section="$SECT" --center="$NAME" --release="$VERS" $name > $sname.$SECT
echo "(done)"
done
echo "Finished building."