gecko/netwerk/base/public/nsITransport.idl

193 lines
8.2 KiB
Plaintext
Raw Normal View History

/* ***** BEGIN LICENSE BLOCK *****
* Version: MPL 1.1/GPL 2.0/LGPL 2.1
*
* The contents of this file are subject to the Mozilla Public License Version
* 1.1 (the "License"); you may not use this file except in compliance with
* the License. You may obtain a copy of the License at
* http://www.mozilla.org/MPL/
*
* Software distributed under the License is distributed on an "AS IS" basis,
* WITHOUT WARRANTY OF ANY KIND, either express or implied. See the License
* for the specific language governing rights and limitations under the
* License.
*
* The Original Code is Mozilla.
*
* The Initial Developer of the Original Code is
* Netscape Communications Corporation.
* Portions created by the Initial Developer are Copyright (C) 2002
* the Initial Developer. All Rights Reserved.
*
* Contributor(s):
* Darin Fisher <darin@netscape.com>
*
* Alternatively, the contents of this file may be used under the terms of
* either the GNU General Public License Version 2 or later (the "GPL"), or
* the GNU Lesser General Public License Version 2.1 or later (the "LGPL"),
* in which case the provisions of the GPL or the LGPL are applicable instead
* of those above. If you wish to allow use of your version of this file only
* under the terms of either the GPL or the LGPL, and not to allow others to
* use your version of this file under the terms of the MPL, indicate your
* decision by deleting the provisions above and replace them with the notice
* and other provisions required by the GPL or the LGPL. If you do not delete
* the provisions above, a recipient may use your version of this file under
* the terms of any one of the MPL, the GPL or the LGPL.
*
* ***** END LICENSE BLOCK ***** */
#include "nsISupports.idl"
interface nsIInputStream;
interface nsIOutputStream;
interface nsITransportEventSink;
interface nsIEventTarget;
/**
* nsITransport
*
* This interface provides a common way of accessing i/o streams connected
* to some resource. This interface does not in any way specify the resource.
* It provides methods to open blocking or non-blocking, buffered or unbuffered
* streams to the resource. The name "transport" is meant to connote the
* inherent data transfer implied by this interface (i.e., data is being
* transfered in some fashion via the streams exposed by this interface).
*
* A transport can have an event sink associated with it. The event sink
* receives transport-specific events as the transfer is occuring. For a
* socket transport, these events can include status about the connection.
* See nsISocketTransport for more info about socket transport specifics.
*/
[scriptable, uuid(d8786c64-eb49-4a0b-b42c-0936a745fbe8)]
interface nsITransport : nsISupports
{
/**
* Open flags.
*/
const unsigned long OPEN_BLOCKING = 1<<0;
const unsigned long OPEN_UNBUFFERED = 1<<1;
/**
* Open an input stream on this transport.
*
* Flags have the following meaning:
*
* OPEN_BLOCKING
* If specified, then the resulting stream will have blocking stream
* semantics. This means that if the stream has no data and is not
* closed, then reading from it will block the calling thread until
* at least one byte is available or until the stream is closed.
* If this flag is NOT specified, then the stream has non-blocking
* stream semantics. This means that if the stream has no data and is
* not closed, then reading from it returns NS_BASE_STREAM_WOULD_BLOCK.
* In addition, in non-blocking mode, the stream is guaranteed to
* support nsIAsyncInputStream. This interface allows the consumer of
* the stream to be notified when the stream can again be read.
*
* OPEN_UNBUFFERED
* If specified, the resulting stream may not support ReadSegments.
* ReadSegments is only gauranteed to be implemented when this flag is
* NOT specified.
*
* @param aFlags
* optional transport specific flags.
* @param aSegmentSize
* if OPEN_UNBUFFERED is not set, then this parameter specifies the
* size of each buffer segment (pass 0 to use default value).
* @param aSegmentCount
* if OPEN_UNBUFFERED is not set, then this parameter specifies the
* maximum number of buffer segments (pass 0 to use default value).
*/
nsIInputStream openInputStream(in unsigned long aFlags,
in unsigned long aSegmentSize,
in unsigned long aSegmentCount);
/**
* Open an output stream on this transport.
*
* Flags have the following meaning:
*
* OPEN_BLOCKING
* If specified, then the resulting stream will have blocking stream
* semantics. This means that if the stream is full and is not closed,
* then writing to it will block the calling thread until ALL of the
* data can be written or until the stream is closed. If this flag is
* NOT specified, then the stream has non-blocking stream semantics.
* This means that if the stream is full and is not closed, then writing
* to it returns NS_BASE_STREAM_WOULD_BLOCK. In addition, in non-
* blocking mode, the stream is guaranteed to support
* nsIAsyncOutputStream. This interface allows the consumer of the
* stream to be notified when the stream can again accept more data.
*
* OPEN_UNBUFFERED
* If specified, the resulting stream may not support WriteSegments and
* WriteFrom. WriteSegments and WriteFrom are only gauranteed to be
* implemented when this flag is NOT specified.
*
* @param aFlags
* optional transport specific flags.
* @param aSegmentSize
* if OPEN_UNBUFFERED is not set, then this parameter specifies the
* size of each buffer segment (pass 0 to use default value).
* @param aSegmentCount
* if OPEN_UNBUFFERED is not set, then this parameter specifies the
* maximum number of buffer segments (pass 0 to use default value).
*/
nsIOutputStream openOutputStream(in unsigned long aFlags,
in unsigned long aSegmentSize,
in unsigned long aSegmentCount);
/**
* Close the transport and any open streams.
*
* @param aReason
* the reason for closing the stream.
*/
void close(in nsresult aReason);
/**
* Set the transport event sink.
*
* @param aSink
* receives transport layer notifications
* @param aEventTarget
* indicates the event target to which the notifications should
* be delivered. if NULL, then the notifications may occur on
* any thread.
*/
void setEventSink(in nsITransportEventSink aSink,
in nsIEventTarget aEventTarget);
/**
* Generic nsITransportEventSink status codes. nsITransport
* implementations may override these status codes with their own more
* specific status codes (e.g., see nsISocketTransport).
*/
const unsigned long STATUS_READING = 0x804b0008;
const unsigned long STATUS_WRITING = 0x804b0009;
};
[scriptable, uuid(EDA4F520-67F7-484b-A691-8C3226A5B0A6)]
interface nsITransportEventSink : nsISupports
{
/**
* Transport status notification.
*
* @param aTransport
* the transport sending this status notification.
* @param aStatus
* the transport status (resolvable to a string using
* nsIErrorService). See nsISocketTransport for socket specific
* status codes and more comments.
* @param aProgress
* the amount of data either read or written depending on the value
* of the status code. this value is relative to aProgressMax.
* @param aProgressMax
* the maximum amount of data that will be read or written. if
* unknown, 0xFFFFFFFF will be passed.
*/
void onTransportStatus(in nsITransport aTransport,
in nsresult aStatus,
in unsigned long long aProgress,
in unsigned long long aProgressMax);
};