gecko/rdf/base/idl/nsIRDFRemoteDataSource.idl

/* -*- Mode: C++; tab-width: 4; indent-tabs-mode: nil; c-basic-offset: 4 -*- */
/* ***** BEGIN LICENSE BLOCK *****
 * Version: MPL 1.1/GPL 2.0/LGPL 2.1
 *
 * The contents of this file are subject to the Mozilla Public License Version
 * 1.1 (the "License"); you may not use this file except in compliance with
 * the License. You may obtain a copy of the License at
 * http://www.mozilla.org/MPL/
 *
 * Software distributed under the License is distributed on an "AS IS" basis,
 * WITHOUT WARRANTY OF ANY KIND, either express or implied. See the License
 * for the specific language governing rights and limitations under the
 * License.
 *
 * The Original Code is mozilla.org code.
 *
 * The Initial Developer of the Original Code is
 * Netscape Communications Corporation.
 * Portions created by the Initial Developer are Copyright (C) 1998
 * the Initial Developer. All Rights Reserved.
 *
 * Contributor(s):
 *
 * Alternatively, the contents of this file may be used under the terms of
 * either of the GNU General Public License Version 2 or later (the "GPL"),
 * or the GNU Lesser General Public License Version 2.1 or later (the "LGPL"),
 * in which case the provisions of the GPL or the LGPL are applicable instead
 * of those above. If you wish to allow use of your version of this file only
 * under the terms of either the GPL or the LGPL, and not to allow others to
 * use your version of this file under the terms of the MPL, indicate your
 * decision by deleting the provisions above and replace them with the notice
 * and other provisions required by the GPL or the LGPL. If you do not delete
 * the provisions above, a recipient may use your version of this file under
 * the terms of any one of the MPL, the GPL or the LGPL.
 *
 * ***** END LICENSE BLOCK ***** */

#include "nsISupports.idl"

/**
 * A datasource that may load asynchronously
 */
[scriptable, uuid(1D297320-27F7-11d3-BE01-000064657374)]
interface nsIRDFRemoteDataSource : nsISupports
{
    /**
     * This value is <code>true</code> when the datasource has
     * fully loaded itself.
     */
    readonly attribute boolean loaded;

    /**
     * Specify the URI for the data source: this is the prefix
     * that will be used to register the data source in the
     * data source registry.
     * @param aURI the URI to load
     */
    void Init(in string aURI);

    /**
     * Refresh the remote datasource, re-loading its contents
     * from the URI.
     *
     * @param aBlocking If <code>true</code>, the call will block
     * until the datasource has completely reloaded.
     */
    void Refresh(in boolean aBlocking);

    /**
     * Request that a data source write its contents out to 
     * permanent storage, if applicable.
     */
    void Flush();
    void FlushTo(in string aURI);
};