dwork struct is large (>128 byte) and not needed when conntrack module
is not loaded.
Place it in net_generic data instead. The struct net dwork member is now
obsolete and will be removed in a followup patch.
Signed-off-by: Florian Westphal <fw@strlen.de>
Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>
No need to keep this in struct net, place it in the net_generic data.
The sysctl pointer is removed from struct net in a followup patch.
Signed-off-by: Florian Westphal <fw@strlen.de>
Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>
This moves all nf_tables pernet data from struct net to a net_generic
extension, with the exception of the gencursor.
The latter is used in the data path and also outside of the nf_tables
core. All others are only used from the configuration plane.
Signed-off-by: Florian Westphal <fw@strlen.de>
Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>
This allows followup patch to remove these members from struct net.
Signed-off-by: Florian Westphal <fw@strlen.de>
Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>
Move dst_check() to the garbage collector path. Stale routes trigger the
flow entry teardown state which makes affected flows go back to the
classic forwarding path to re-evaluate flow offloading.
IPv6 requires the dst cookie to work, store it in the flow_tuple,
otherwise dst_check() always fails.
Fixes: e5075c0bad ("netfilter: flowtable: call dst_check() to fall back to classic forwarding")
Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>
modprobe calls from the nf_logger_find_get() API causes deadlock in very
special cases because they occur with the nf_tables transaction mutex held.
In the specific case of nf_log, deadlock is via:
A nf_tables -> transaction mutex -> nft_log -> modprobe -> nf_log_syslog \
-> pernet_ops rwsem -> wait for C
B netlink event -> rtnl_mutex -> nf_tables transaction mutex -> wait for A
C close() -> ip6mr_sk_done -> rtnl_mutex -> wait for B
Earlier patch added NFLOG/xt_LOG module softdeps to avoid the need to load
the backend module during a transaction.
For nft_log we would have to add a softdep for both nfnetlink_log or
nf_log_syslog, since we do not know in advance which of the two backends
are going to be configured.
This defers the modprobe op until after the transaction mutex is released.
Tested-by: Phil Sutter <phil@nwl.cc>
Signed-off-by: Florian Westphal <fw@strlen.de>
Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>
Remove nf_log_common. Now that all per-af modules have been merged
there is no longer a need to provide a helper module.
Signed-off-by: Florian Westphal <fw@strlen.de>
Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>
Provide bridge log support from nf_log_syslog.
After the merge there is no need to load the "real packet loggers",
all of them now reside in the same module.
Signed-off-by: Florian Westphal <fw@strlen.de>
Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>
The switch might have already added the VLAN tag through PVID hardware
offload. Keep this extra VLAN in the flowtable but skip it on egress.
Signed-off-by: Felix Fietkau <nbd@nbd.name>
Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
If there is a forward path to reach an ethernet device and hardware
offload is enabled, then use the direct xmit path.
Moreover, store the real device in the direct xmit path info since
software datapath uses dev_hard_header() to push the layer encapsulation
headers while hardware offload refers to the real device.
Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
Add the vlan id and protocol to the flow tuple to uniquely identify
flows from the receive path. For the transmit path, dev_hard_header() on
the vlan device push the headers. This patch includes support for two
vlan headers (QinQ) from the ingress path.
Add a generic encap field to the flowtable entry which stores the
protocol and the tag id. This allows to reuse these fields in the PPPoE
support coming in a later patch.
Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
The egress device in the tuple is obtained from route. Use
dev_fill_forward_path() instead to provide the real egress device for
this flow whenever this is available.
The new FLOW_OFFLOAD_XMIT_DIRECT type uses dev_queue_xmit() to transmit
ethernet frames. Cache the source and destination hardware address to
use dev_queue_xmit() to transfer packets.
The FLOW_OFFLOAD_XMIT_DIRECT replaces FLOW_OFFLOAD_XMIT_NEIGH if
dev_fill_forward_path() finds a direct transmit path.
In case of topology updates, if peer is moved to different bridge port,
the connection will time out, reconnect will result in a new entry with
the correct path. Snooping fdb updates would allow for cleaning up stale
flowtable entries.
Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
Obtain the ingress device in the tuple from the route in the reply
direction. Use dev_fill_forward_path() instead to get the real ingress
device for this flow.
Fall back to use the ingress device that the IP forwarding route
provides if:
- dev_fill_forward_path() finds no real ingress device.
- the ingress device that is obtained is not part of the flowtable
devices.
- this route has a xfrm policy.
Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
Add the xmit_type field that defines the two supported xmit paths in the
flowtable data plane, which are the neighbour and the xfrm xmit paths.
This patch prepares for new flowtable xmit path types to come.
Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
Do not update table flags from the preparation phase. Store the flags
update into the transaction, then update the flags from the commit
phase.
Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>
Simplify existing fast NAT routines by returning void. After the
skb_try_make_writable() call consolidation, these routines cannot ever
fail.
Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>
This allows to remove the default case which should not ever happen and
that was added to avoid gcc warnings on unhandled FLOW_OFFLOAD_DIR_MAX
enumeration case.
Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>
commit e97c3e278e ("tproxy: split off ipv6 defragmentation to a separate
module") left behind this.
Signed-off-by: YueHaibing <yuehaibing@huawei.com>
Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>
Honor flowtable flags from the control update path. Disallow disabling
to toggle hardware offload support though.
Fixes: 8bb69f3b29 ("netfilter: nf_tables: add flowtable offload control plane")
Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>
A userspace daemon like firewalld might need to monitor for netlink
updates to detect its ruleset removal by the (global) flush ruleset
command to ensure ruleset persistency. This adds extra complexity from
userspace and, for some little time, the firewall policy is not in
place.
This patch adds the NFT_TABLE_F_OWNER flag which allows a userspace
program to own the table that creates in exclusivity.
Tables that are owned...
- can only be updated and removed by the owner, non-owners hit EPERM if
they try to update it or remove it.
- are destroyed when the owner closes the netlink socket or the process
is gone (implicit netlink socket closure).
- are skipped by the global flush ruleset command.
- are listed in the global ruleset.
The userspace process that sets on the NFT_TABLE_F_OWNER flag need to
leave open the netlink socket.
A new NFTA_TABLE_OWNER netlink attribute specifies the netlink port ID
to identify the owner from userspace.
This patch also updates error reporting when an unknown table flag is
specified to change it from EINVAL to EOPNOTSUPP given that EINVAL is
usually reserved to report for malformed netlink messages to userspace.
Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>
Pablo Neira Ayuso says:
====================
Netfilter/IPVS updates for net-next
1) Remove indirection and use nf_ct_get() instead from nfnetlink_log
and nfnetlink_queue, from Florian Westphal.
2) Add weighted random twos choice least-connection scheduling for IPVS,
from Darby Payne.
3) Add a __hash placeholder in the flow tuple structure to identify
the field to be included in the rhashtable key hash calculation.
4) Add a new nft_parse_register_load() and nft_parse_register_store()
to consolidate register load and store in the core.
5) Statify nft_parse_register() since it has no more module clients.
6) Remove redundant assignment in nft_cmp, from Colin Ian King.
* git://git.kernel.org/pub/scm/linux/kernel/git/pablo/nf-next:
netfilter: nftables: remove redundant assignment of variable err
netfilter: nftables: statify nft_parse_register()
netfilter: nftables: add nft_parse_register_store() and use it
netfilter: nftables: add nft_parse_register_load() and use it
netfilter: flowtable: add hash offset field to tuple
ipvs: add weighted random twos choice algorithm
netfilter: ctnetlink: remove get_ct indirection
====================
Link: https://lore.kernel.org/r/20210206015005.23037-1-pablo@netfilter.org
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
This new function combines the netlink register attribute parser
and the store validation function.
This update requires to replace:
enum nft_registers dreg:8;
in many of the expression private areas otherwise compiler complains
with:
error: cannot take address of bit-field ‘dreg’
when passing the register field as reference.
Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>
This new function combines the netlink register attribute parser
and the load validation function.
This update requires to replace:
enum nft_registers sreg:8;
in many of the expression private areas otherwise compiler complains
with:
error: cannot take address of bit-field ‘sreg’
when passing the register field as reference.
Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>
Florian Westphal
Pablo Neira Ayuso
David S. Miller
Felix Fietkau
YueHaibing
Jakub Kicinski