* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/ericvh/v9fs:
9p: v9fs_vfs_rename incorrect clunk order
9p: fix memleak in fs/9p/v9fs.c
9p: add virtio transport
This adds a transport to 9p for communicating between guests and a host
using a virtio based transport.
Signed-off-by: Eric Van Hensbergen <ericvh@gmail.com>
* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/roland/infiniband:
mlx4_core: Increase command timeout for INIT_HCA to 10 seconds
IPoIB/cm: Use common CQ for CM send completions
IB/uverbs: Fix checking of userspace object ownership
IB/mlx4: Sanity check userspace send queue sizes
IPoIB: Rewrite "if (!likely(...))" as "if (unlikely(!(...)))"
IB/ehca: Enable large page MRs by default
IB/ehca: Change meaning of hca_cap_mr_pgsize
IB/ehca: Fix ehca_encode_hwpage_size() and alloc_fmr()
IB/ehca: Fix masking error in {,re}reg_phys_mr()
IB/ehca: Supply QP token for SRQ base QPs
IPoIB: Use round_jiffies() for ah_reap_task
RDMA/cma: Fix deadlock destroying listen requests
RDMA/cma: Add locking around QP accesses
IB/mthca: Avoid alignment traps when writing doorbells
mlx4_core: Kill mlx4_write64_raw()
This makes lguest able to use the virtio devices.
We change the device descriptor page from a simple array to a variable
length "type, config_len, status, config data..." format, and
implement virtio_config_ops to read from that config data.
We use the virtio ring implementation for an efficient Guest <-> Host
virtqueue mechanism, and the new LHCALL_NOTIFY hypercall to kick the
host when it changes.
We also use LHCALL_NOTIFY on kernel addresses for very very early
console output. We could have another hypercall, but this hack works
quite well.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
This patch gets rid of the old lguest host I/O infrastructure and
replaces it with a single hypercall "LHCALL_NOTIFY" which takes an
address.
The main change is the removal of io.c: that mainly did inter-guest
I/O, which virtio doesn't yet support.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
This gets rid of the lguest bus, drivers and DMA mechanism, to make
way for a generic virtio mechanism.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
These helper routines supply most of the virtqueue_ops for hypervisors
which want to use a ring for virtio. Unlike the previous lguest
implementation:
1) The rings are variable sized (2^n-1 elements).
2) They have an unfortunate limit of 65535 bytes per sg element.
3) The page numbers are always 64 bit (PAE anyone?)
4) They no longer place used[] on a separate page, just a separate
cacheline.
5) We do a modulo on a variable. We could be tricky if we cared.
6) Interrupts and notifies are suppressed using flags within the rings.
Users need only get the ring pages and provide a notify hook (KVM
wants the guest to allocate the rings, lguest does it sanely).
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
Cc: Dor Laor <dor.laor@qumranet.com>
This is an hvc-based virtio console driver. It's suboptimal becuase
hvc expects to have raw access to interrupts and virtio doesn't assume
that, so it currently polls.
There are two solutions: expose hvc's "kick" interface, or wean off hvc.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
The block driver uses scatter-gather lists with sg[0] being the
request information (struct virtio_blk_outhdr) with the type, sector
and inbuf id. The next N sg entries are the bio itself, then the last
sg is the status byte. Whether the N entries are in or out depends on
whether it's a read or a write.
We accept the normal (SCSI) ioctls: they get handed through to the other
side which can then handle it or reply that it's unsupported. It's
not clear that this actually works in general, since I don't know
if blk_pc_request() requests have an accurate rq_data_dir().
Although we try to reply -ENOTTY on unsupported commands, ioctl(fd,
CDROMEJECT) returns success to userspace. This needs a separate
patch.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
Cc: Jens Axboe <jens.axboe@oracle.com>
The network driver uses two virtqueues: one for input packets and one
for output packets. This has nice locking properties (ie. we don't do
any for recv vs send).
TODO:
1) Big packets.
2) Multi-client devices (maybe separate driver?).
3) Resolve freeing of old xmit skbs (Christian Borntraeger)
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
Cc: Christian Borntraeger <borntraeger@de.ibm.com>
Cc: Herbert Xu <herbert@gondor.apana.org.au>
Cc: netdev@vger.kernel.org
This attempts to implement a "virtual I/O" layer which should allow
common drivers to be efficiently used across most virtual I/O
mechanisms. It will no-doubt need further enhancement.
The virtio drivers add buffers to virtio queues; as the buffers are consumed
the driver "interrupt" callbacks are invoked.
There is also a generic implementation of config space which drivers can query
to get setup information from the host.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
Cc: Dor Laor <dor.laor@qumranet.com>
Cc: Arnd Bergmann <arnd@arndb.de>
1) This allows us to get alot closer to booting bzImages.
2) It means we don't have to know page_offset.
3) The Guest needs to modify the boot pagetables to create the
PAGE_OFFSET mapping before jumping to C code.
4) guest_pa() walks the page tables rather than using page_offset.
5) We don't use page_offset to figure out whether to emulate: it was
always kinda quesationable, and won't work for instructions done
before remapping (bzImage unpacking in particular).
6) We still want the kernel address for tlb flushing: have the initial
hypercall give us that, too.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
(Based on Ron Minnich's LGUEST_PLAN9_SYSCALL patch).
This patch allows Guests to specify what system call vector they want,
and we try to reserve it. We only allow one non-Linux system call
vector, to try to avoid DoS on the Host.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
Clean up the hypercall code to make the code in hypercalls.c
architecture independent. First process the common hypercalls and
then call lguest_arch_do_hcall() if the call hasn't been handled.
Rename struct hcall_ring to hcall_args.
This patch requires the previous patch which reorganize the layout of
struct lguest_regs on i386 so they match the layout of struct
hcall_args.
Signed-off-by: Jes Sorensen <jes@sgi.com>
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
Back when we had all the Guest state in the switcher, we had a fixed
array of them. This is no longer necessary.
If we switch the network code to using random_ether_addr (46 bits is
enough to avoid clashes), we can get rid of the concept of "guest id"
altogether.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
Move architecture specific portion of lg_hcall code to asm-i386/lg_hcall.h
and have it included from linux/lguest.h.
[Changed to asm-i386/lguest_hcall.h so documentation finds it -RR]
Signed-off-by: Jes Sorensen <jes@sgi.com>
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
Cc: Jes Sorensen <jes@sgi.com>
lguest_launcher.h uses "u32" not "__u32", which sets a bad example. Fix that,
and include <linux/types.h>.
This means we need to use -I on the Launcher build line so types.h is found.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
To actually write a bootloader (or, say, the lguest launcher)
currently requires duplication of these structures. Making them
includable from userspace is much nicer.
We merge the common userspace-required definitions of e820_32/64.h
into e820.h for export.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
Commit 238e4f142c ("ide: add
IDE_HFLAG_NO_LBA48 and IDE_HFLAG_NO_LBA48_DMA host flags") caused a
regression because the host_flags in struct hwif_s wasn't expanded to
cope with the fact that the host flags no longer fit in 16 bits.
Signed-off-by: David S. Miller <davem@davemloft.net>
[ I hate having to add good commit descriptions. - Linus ]
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
* 'master' of master.kernel.org:/pub/scm/linux/kernel/git/davem/net-2.6: (30 commits)
[IPSEC] IPV6: Fix to add tunnel mode SA correctly.
[NET]: Cut off the queue_mapping field from sk_buff
[NET]: Hide the queue_mapping field inside netif_subqueue_stopped
[NET]: Make and use skb_get_queue_mapping
[NET]: Use the skb_set_queue_mapping where appropriate
[INET]: Use MODULE_ALIAS_NET_PF_PROTO_TYPE where possible.
[INET]: Let inet_diag and friends autoload
[NIU]: Cleanup PAGE_SIZE checks a bit
[NET]: Fix SKB_WITH_OVERHEAD calculation
[ATM]: Fix clip module reload crash.
[TG3]: Update version to 3.85
[TG3]: PCI command adjustment
[TG3]: Add management FW version to ethtool report
[TG3]: Add 5723 support
[Bluetooth] Convert RFCOMM to use kthread API
[Bluetooth] Add constant for Bluetooth socket options level
[Bluetooth] Add support for handling simple eSCO links
[Bluetooth] Add address and channel attribute to RFCOMM TTY device
[Bluetooth] Fix wrong argument in debug code of HIDP
[Bluetooth] Add generic driver for Bluetooth USB devices
...
* 'master' of ssh://master.kernel.org/pub/scm/linux/kernel/git/mchehab/v4l-dvb: (37 commits)
V4L/DVB (6382): saa7134: fix NULL dereference at suspend time for cards without IR receiver
V4L/DVB (6380): ivtvfb: Removal of the 'osd_compat' module option
V4L/DVB (6379): patch which improves GotView Saa7135 remote control
V4L/DVB (6378b): Updates info about the removal of V4L1 at feature-removal-schedule.txt
V4L/DVB (6378a): Removal of VIDIOC_[G|S]_MPEGCOMP from feature-removal-schedule.txt
V4L/DVB (6378): DiB0700-device: Using 1.10 firmware
V4L/DVB (6357): pvrusb2: Improve encoder chip health tracking
V4L/DVB (6356): "while (!ca->wakeup)" breaks the CAM initialisation
V4L/DVB (6352): ir-kbd-i2c: Missing break statement
V4L/DVB (6350): V4L: possible leak in em28xx_init_isoc
V4L/DVB (6348): ivtv: undo video mute when closing the radio
V4L/DVB (6347): ivtv: fix video mute when radio is used
V4L/DVB (6346): ivtvfb: YUV output size fix when ivtvfb is not loaded
V4L/DVB (6345): ivtvfb: YUV handling of an image which is not visible in the display area
V4L/DVB (6343): ivtvfb: check return value of unregister_framebuffer
V4L/DVB (6342): ivtv: fix circular locking (bug 9037)
V4L/DVB (6341): ivtv: fix resizing MPEG1 streams
V4L/DVB (6340): ivtvfb: screen mode change sometimes goes wrong
V4L/DVB (6339): ivtv: set the video color to black instead of green when capturing from the radio
V4L/DVB (6338): ivtv: fix incorrect EBUSY return
...
* 'sg' of git://git.kernel.dk/linux-2.6-block:
Add CONFIG_DEBUG_SG sg validation
Change table chaining layout
Update arch/ to use sg helpers
Update swiotlb to use sg helpers
Update net/ to use sg helpers
Update fs/ to use sg helpers
[SG] Update drivers to use sg helpers
[SG] Update crypto/ to sg helpers
[SG] Update block layer to use sg helpers
[SG] Add helpers for manipulating SG entries
