DPU driver contains code to parse clock items from device tree into
special data struct and then enable/disable/set rate for the clocks
using that data struct. However the DPU driver itself uses only parsing
and enabling/disabling part (the rate setting is used by DP driver).
Move this implementation to the DP driver (which actually uses rate
setting) and replace hand-coded enable/disable/get loops in the DPU
with the respective clk_bulk operations. Put operation is removed
completely because, it is handled using devres instead.
DP implementation is unchanged for now.
Tested-by: Jessica Zhang <quic_jesszhan@quicinc.com> # RB3 (sdm845) and RB5 (qrb5165)
Reviewed-by: Jessica Zhang <quic_jesszhan@quicinc.com>
Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
Link: https://lore.kernel.org/r/20220217055529.499829-2-dmitry.baryshkov@linaro.org
Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
MSM DRM driver has support for eDP block present on MSM 8x74/8x84 SoC
families. However since addition back in 2015 this driver received only
generic fixes. No actual devices with these SoCs supported upstream (or
by the community) seem to support eDP panels. Judging from downstream
kernels the eDP was present only on MSM8974 LIQUID or on APQ8084 CDP.
Remove this driver.
Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
Link: https://lore.kernel.org/r/20211001165011.441945-3-dmitry.baryshkov@linaro.org
Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
[rob: Rebased on "drm: msm: fix building without CONFIG_COMMON_CLK"]
Signed-off-by: Rob Clark <robdclark@chromium.org>
When CONFIG_COMMON_CLOCK is disabled, the 8996 specific
phy code is left out, which results in a link failure:
ld: drivers/gpu/drm/msm/hdmi/hdmi_phy.o:(.rodata+0x3f0): undefined reference to `msm_hdmi_phy_8996_cfg'
This was only exposed after it became possible to build
test the driver without the clock interfaces.
Make COMMON_CLK a hard dependency for compile testing,
and simplify it a little based on that.
Fixes: b3ed524f84 ("drm/msm: allow compile_test on !ARM")
Reported-by: Randy Dunlap <rdunlap@infradead.org>
Suggested-by: Geert Uytterhoeven <geert@linux-m68k.org>
Signed-off-by: Arnd Bergmann <arnd@arndb.de>
Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
Link: https://lore.kernel.org/r/20211013144308.2248978-1-arnd@kernel.org
Signed-off-by: Rob Clark <robdclark@chromium.org>
Add the msm_disp_snapshot module which adds supports to dump dpu
registers and capture the drm atomic state which can be used in
case of error conditions.
changes in v5:
- start storing disp_state in msm_kms instead of dpu_kms
- get rid of MSM_DISP_SNAPSHOT_IN_* enum by simplifying the functions
- move snprintf inside the snapshot core by using varargs
- get rid of some stale code comments
- allow snapshot module for non-DPU targets
Reported-by: kernel test robot <lkp@intel.com>
Signed-off-by: Abhinav Kumar <abhinavk@codeaurora.org>
Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
Link: https://lore.kernel.org/r/1618606645-19695-3-git-send-email-abhinavk@codeaurora.org
Signed-off-by: Rob Clark <robdclark@chromium.org>
Add initial support for merge3D hardware block on SM8[12]50. Merge3D is
reposible for merging contents of two LMs (two PPs) into single
interface.
Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
Signed-off-by: Rob Clark <robdclark@chromium.org>
To prepare the MSM DP driver for running video pattern
compliance tests introduce debugfs module for it.
Changes in v2: rebase on top of latest patchset of dependency
Signed-off-by: Abhinav Kumar <abhinavk@codeaurora.org>
Signed-off-by: Rob Clark <robdclark@chromium.org>
Introduce audio support for Display Port on MSM chipsets.
This change integrates DP audio sub-module with the main
Display Port platform driver.
In addition, this change leverages hdmi_codec_ops to expose
the operations to the audio driver.
Changes in v2: fix up a compilation issue on drm-next branch
Changes in v3: none
Changes in v4: none
Changes in v5: none
Changes in v6: rebase on top of latest patchset of dependency
Signed-off-by: Abhinav Kumar <abhinavk@codeaurora.org>
Signed-off-by: Rob Clark <robdclark@chromium.org>
Add the needed DP PLL specific files to support
display port interface on msm targets.
The DP driver calls the DP PLL driver registration.
The DP driver sets the link and pixel clock sources.
Changes in v2:
-- Update copyright markings on all relevant files.
-- Use DRM_DEBUG_DP for debug msgs.
Changes in v4:
-- Update the DP link clock provider names
Changes in V5:
-- Addressed comments from Stephen Boyd, Rob clark.
Changes in V6:
-- Remove PLL as separate driver and include PLL as DP module
-- Remove redundant clock parsing from PLL module and make DP as
clock provider
-- Map USB3 DPCOM and PHY IO using hardcoded register address and
move mapping form parser to PLL module
-- Access DP PHY modules from same base address using offsets instead of
deriving base address of individual module from device tree.
-- Remove dp_pll_10nm_util.c and include its functionality in
dp_pll_10nm.c
-- Introduce new data structures private to PLL module
Changes in v7:
-- Remove DRM_MSM_DP_PLL config from Makefile and Kconfig
-- Remove set_parent from determin_rate API
-- Remove phy_pll_vco_div_clk from parent list
-- Remove flag CLK_DIVIDER_ONE_BASED
-- Remove redundant cell-index property parsing
Changes in v8:
-- Unregister hardware clocks during driver cleanup
Changes in v9:
-- Remove redundant Kconfig option DRM_MSM_DP_10NM_PLL
Changes in v10:
-- Limit 10nm PLL function scope
Signed-off-by: Chandan Uddaraju <chandanu@codeaurora.org>
Signed-off-by: Vara Reddy <varar@codeaurora.org>
Signed-off-by: Tanmay Shah <tanmay@codeaurora.org>
Signed-off-by: Rob Clark <robdclark@chromium.org>
Dmitry Baryshkov
Abhinav Kumar
Vinod Koul
Arnd Bergmann
Rob Clark
Abhinav Kumar
Stephen Boyd
Chandan Uddaraju