Pull gpio updates from Bartosz Golaszewski:
"For this merge window we have two new drivers: support for
GPIO-signalled ACPI events on Intel platforms and a generic
GPIO-over-pinctrl driver using the ARM SCMI protocol for
controlling pins.
Several things have been reworked in GPIO core: we unduplicated GPIO
hog handling, reduced the number of SRCU locks and dereferences,
improved support for software-node-based lookup and removed more
legacy code after converting remaining users to modern alternatives.
There's also a number of driver reworks and refactoring, documentation
updates, some bug-fixes and new tests.
GPIO core:
- defer probe on software node lookups when the remote software node
exists but has not been registered as a firmware node yet
- unify GPIO hog handling by moving code duplicated in OF and ACPI
modules into GPIO core and allow setting up hogs with software
nodes
- allow matching GPIO controllers by secondary firmware node if
matching by primary does not succeed
- demote deferral warnings to debug level as they are quite normal
when using software nodes which don't support fw_devlink yet
- disable the legacy GPIO character device uAPI v1 supprt in Kconfig
by default
- rework several core functions in preparation for the upcoming
Revocable helper library for protecting resources against sudden
removal, this reduces the number of SRCU dereferences in GPIO core
- simplify file descriptor logic in GPIO character device code by
using FD_PREPARE()
- introduce a header defining symbols used by both GPIO consumers and
providers to avoid having to include provider-specific headers from
drivers which only consume GPIOs
- replace snprintf() with strscpy() where formatting is not required
New drivers:
- add the gpio-by-pinctrl generic driver using the ARM SCMI protocol
to control GPIOs (along with SCMI changes pulled from the pinctrl
tree)
- add a driver providing support for handling of platform events via
GPIO-signalled ACPI events (used on Intel Nova Lake and later
platforms)
Driver changes:
- extend the gpio-kempld driver with support for more recent models,
interrupts and setting/getting multiple values at once
- improve interrupt handling in gpio-brcmstb
- add support for multi-SoC systems in gpio-tegra186
- make sure we return correct values from the .get() callbacks in
several GPIO drivers by normalizing any values other than 0, 1 or
negative error numbers
- use flexible arrays in several drivers to reduce the number of
required memory allocations
- simplify synchronous waiting for virtual drivers to probe and
remove the dedicated, a bit overengineered helper library
dev-sync-probe
- remove unneeded Kconfig dependencies on OF_GPIO in several drivers
and subsystems
- convert the two remaining users of of_get_named_gpio() to using
GPIO descriptors and remove the (no longer used) function along
with the header that declares it
- add missing includes in gpio-mmio
- shrink and simplify code in gpio-max732x by using guard(mutex)
- remove duplicated code handling the 'ngpios' property from
gpio-ts4800, it's already handled in GPIO core
- use correct variable type in gpio-aspeed
- add support for a new model in gpio-realtek-otto
- allow to specify the active-low setting of simulated hogs over the
configfs interface (in addition to existing devicetree support) in
gpio-sim
Bug fixes:
- clear the OF_POPULATED flag on hog nodes in GPIO chip remove path
on OF systems
- fix resource leaks in error path in gpiochip_add_data_with_key()
- drop redundant device reference in gpio-mpsse
Tests:
- add selftests for use-after-free cases in GPIO character device
code
DT bindings:
- add a DT binding document for SCMI based, gpio-over-pinctrl devices
- fix interrupt description in microchip,mpfs-gpio
- add new compatible for gpio-realtek-otto
- describe the resets of the mpfs-gpio controller
- fix maintainer's email in gpio-delay bindings
- remove the binding document for cavium,thunder-8890 as the
corresponding device is bound over PCI and not firmware nodes
Documentation:
- update the recommended way of converting legacy boards to using
software nodes for GPIO description
- describe GPIO line value semantics
- misc updates to kerneldocs
Misc:
- convert OMAP1 ams-delta board to using GPIO hogs described with
software nodes"
* tag 'gpio-updates-for-v7.1-rc1' of git://git.kernel.org/pub/scm/linux/kernel/git/brgl/linux: (79 commits)
gpio: swnode: defer probe on references to unregistered software nodes
dt-bindings: gpio: cavium,thunder-8890: Remove DT binding
Documentation: gpio: update the preferred method for using software node lookup
gpio: gpio-by-pinctrl: s/used to do/is used to do/
gpio: aspeed: fix unsigned long int declaration
gpio: rockchip: convert to dynamic GPIO base allocation
gpio: remove dev-sync-probe
gpio: virtuser: stop using dev-sync-probe
gpio: aggregator: stop using dev-sync-probe
gpio: sim: stop using dev-sync-probe
gpio: Add Intel Nova Lake ACPI GPIO events driver
gpiolib: Make deferral warnings debug messages
gpiolib: fix hogs with multiple lines
gpio: fix up CONFIG_OF dependencies
gpio: gpio-by-pinctrl: add pinctrl based generic GPIO driver
gpio: dt-bindings: Add GPIO on top of generic pin control
firmware: arm_scmi: Allow PINCTRL_REQUEST to return EOPNOTSUPP
pinctrl: scmi: ignore PIN_CONFIG_PERSIST_STATE
pinctrl: scmi: Delete PIN_CONFIG_OUTPUT_IMPEDANCE_OHMS support
pinctrl: scmi: Add SCMI_PIN_INPUT_VALUE
...
Avoid these kernel-doc warnings by:
- adding short descriptions for enums
- using correct (matching) struct names in kernel-doc short descriptions
- using the correct struct member name for @nfunctions
Warning: include/linux/gpio/gpio-nomadik.h:116 missing initial short
description on line: * enum prcm_gpiocr_reg_index
Warning: include/linux/gpio/gpio-nomadik.h:125 missing initial short
description on line: * enum prcm_gpiocr_altcx_index
Warning: include/linux/gpio/gpio-nomadik.h:146 expecting prototype for
struct prcm_gpio_altcx. Prototype was for struct prcm_gpiocr_altcx instead
Warning: include/linux/gpio/gpio-nomadik.h:156 expecting prototype for
struct prcm_gpio_altcx_pin_desc. Prototype was for
struct prcm_gpiocr_altcx_pin_desc instead
Warning: include/linux/gpio/gpio-nomadik.h:212 struct member 'nfunctions'
not described in 'nmk_pinctrl_soc_data'
Signed-off-by: Randy Dunlap <rdunlap@infradead.org>
Link: https://patch.msgid.link/20260301014811.3133250-1-rdunlap@infradead.org
Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@oss.qualcomm.com>
Provide an interface allowing consumers to check if a GPIO descriptor
represents a GPIO that can potentially be shared by multiple consumers
at the same time. This is exposed to allow subsystems that already
work around the limitations of the current non-exclusive GPIO handling
in some ways, to gradually convert to relying on the new shared GPIO
feature of GPIOLIB.
Extend the gpiolib-shared module to mark the GPIO shared proxy
descriptors with a flag checked by the new interface.
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Acked-by: Linus Walleij <linus.walleij@linaro.org>
Link: https://lore.kernel.org/r/20251112-gpio-shared-v4-6-b51f97b1abd8@linaro.org
Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@linaro.org>
Last user of linux/gpio/legacy-of-mm-gpiochip.h is gone.
Remove linux/gpio/legacy-of-mm-gpiochip.h and
CONFIG_OF_GPIO_MM_GPIOCHIP
Signed-off-by: Christophe Leroy <christophe.leroy@csgroup.eu>
Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@linaro.org>
There are GPIO controllers such as the one present in the LX2160ARDB
QIXIS FPGA which have fixed-direction input and output GPIO lines mixed
together in a single register. This cannot be modeled using the
gpio-regmap as-is since there is no way to present the true direction of
a GPIO line.
In order to make this use case possible, add a new configuration
parameter - fixed_direction_output - into the gpio_regmap_config
structure. This will enable user drivers to provide a bitmap that
represents the fixed direction of the GPIO lines.
Signed-off-by: Ioana Ciornei <ioana.ciornei@nxp.com>
Acked-by: Bartosz Golaszewski <bartosz.golaszewski@linaro.org>
Reviewed-by: Michael Walle <mwalle@kernel.org>
Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@linaro.org>
With all users of bgpio_init() converted to using the modernized generic
GPIO chip API, we can now move the gpio-mmio-specific fields out of
struct gpio_chip and into the dedicated struct gpio_generic_chip. To
that end: adjust the gpio-mmio driver to the new layout, update the
docs, etc.
The changes in gpio-mlxbf2.c and gpio-mpc8xxx.c are here and not in their
respective conversion commits because the former passes the address of
the generic chip's lock to the __releases() annotation and we cannot
really hide it while gpio-mpc8xxx.c accesses the shadow registers in a
driver-specific workaround and there's no reason to make them available
in a public API.
Also: drop the relevant task from TODO as it's now done.
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Link: https://lore.kernel.org/r/20250910-gpio-mmio-gpio-conv-part4-v2-15-f3d1a4c57124@linaro.org
Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@linaro.org>
Linus Torvalds
Bartosz Golaszewski
Linus Walleij
Randy Dunlap
Andy Shevchenko
Stefan Kerkmann
Bartosz Golaszewski
Christophe Leroy
Ioana Ciornei
Mathieu Dubois-Briand
Thomas Richard