iTCO vendor support was introduced in 2006 to support SuperMicro boards
with Pentium 3 CPUs. It was extended in 2009 to support motherbords
with broken BIOS (specifically Intel DG33TL). The code is long since
obsolete, so let's drop support for it.
Signed-off-by: Guenter Roeck <linux@roeck-us.net>
Reviewed-by: Wim Van Sebroeck <wim@linux-watchdog.org>
Signed-off-by: Wim Van Sebroeck <wim@linux-watchdog.org>
This driver adds support for the Renesas Window Watchdog Timer (WWDT).
Because it can only be setup once after boot and we cannot know if this
already happened in early boot stages, it is mandated that the firmware
configures the watchdog. Linux then adapts according to the given
setup. Note that this watchdog only reports an overflow to the Error
Control Module (ECM) and does not reset the SoC on its own.
Signed-off-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
Reviewed-by: Guenter Roeck <linux@roeck-us.net>
Signed-off-by: Guenter Roeck <linux@roeck-us.net>
Signed-off-by: Wim Van Sebroeck <wim@linux-watchdog.org>
The S32 platform has several Watchdog Timer available and tied with a
CPU. The SWT0 is the only one which directly asserts the reset line,
other SWT require an external setup to configure the reset behavior
which is not part of this change.
As a side note, in the NXP documentation, the s32g2 and s32g3
reference manuals refer the watchdog as the 'Software Timer Watchdog'
where the name can be misleading as it is actually a hardware
watchdog.
The maximum watchdog timeout value depends on the clock feeding the
SWT counter which is 32bits wide. On the s32g274-rb2, the clock has a
rate of 51MHz which result on 83 seconds maximum timeout.
The timeout can be specified via the device tree with the usual
existing bindings 'timeout-sec' or via the module param timeout.
The watchdog can be loaded with the 'nowayout' option, preventing the
watchdog to be stopped.
The watchdog can be started at boot time with the 'early-enable'
option, thus letting the watchdog framework to service the watchdog
counter.
The watchdog support the magic character to stop when the userspace
releases the device.
Cc: Ghennadi Procopciuc <ghennadi.procopciuc@nxp.com>
Cc: Thomas Fossati <thomas.fossati@linaro.org>
Signed-off-by: Daniel Lezcano <daniel.lezcano@linaro.org>
Tested-by: Alexandru-Catalin Ionita <alexandru-catalin.ionita@nxp.com>
Reviewed-by: Guenter Roeck <linux@roeck-us.net>
Link: https://lore.kernel.org/r/20250410082616.1855860-3-daniel.lezcano@linaro.org
Signed-off-by: Guenter Roeck <linux@roeck-us.net>
Signed-off-by: Wim Van Sebroeck <wim@linux-watchdog.org>
Pull watchdog updates from Wim Van Sebroeck:
- Add support for exynosautov920 SoC
- Add support for Airoha EN7851 watchdog
- Add support for MT6735 TOPRGU/WDT
- Delete the cpu5wdt driver
- Always print when registering watchdog fails
- Several other small fixes and improvements
* tag 'linux-watchdog-6.13-rc1' of git://www.linux-watchdog.org/linux-watchdog: (36 commits)
watchdog: rti: of: honor timeout-sec property
watchdog: s3c2410_wdt: add support for exynosautov920 SoC
dt-bindings: watchdog: Document ExynosAutoV920 watchdog bindings
watchdog: mediatek: Add support for MT6735 TOPRGU/WDT
watchdog: mediatek: Make sure system reset gets asserted in mtk_wdt_restart()
dt-bindings: watchdog: fsl-imx-wdt: Add missing 'big-endian' property
dt-bindings: watchdog: Document Qualcomm QCS8300
docs: ABI: Fix spelling mistake in pretimeout_avaialable_governors
Revert "watchdog: s3c2410_wdt: use exynos_get_pmu_regmap_by_phandle() for PMU regs"
watchdog: rzg2l_wdt: Power on the watchdog domain in the restart handler
watchdog: Switch back to struct platform_driver::remove()
watchdog: it87_wdt: add PWRGD enable quirk for Qotom QCML04
watchdog: da9063: Remove __maybe_unused notations
watchdog: da9063: Do not use a global variable
watchdog: Delete the cpu5wdt driver
watchdog: Add support for Airoha EN7851 watchdog
dt-bindings: watchdog: airoha: document watchdog for Airoha EN7581
watchdog: sl28cpld_wdt: don't print out if registering watchdog fails
watchdog: rza_wdt: don't print out if registering watchdog fails
watchdog: rti_wdt: don't print out if registering watchdog fails
...
This driver has a number of issues (accesses arbitrary I/O ports
without identifying the hardware, doesn't document what hardware it
supports, suspiciously inconsistent locking model, doesn't implement
WDIOC_SETTIMEOUT, potential integer overflow...)
The driver was added in 2003 and there's no evidence that it has any
recent user, all changes seem to be tree-wide, subsystem-wide, or the
result of static code analysis. So I believe we should simply drop
this legacy piece of code.
Signed-off-by: Jean Delvare <jdelvare@suse.de>
Message-ID: <20241011170710.484a257a@endymion.delvare>
Reviewed-by: Guenter Roeck <linux@roeck-us.net>
Link: https://lore.kernel.org/r/20241022114731.31f69c94@endymion.delvare
Signed-off-by: Guenter Roeck <linux@roeck-us.net>
Signed-off-by: Wim Van Sebroeck <wim@linux-watchdog.org>
AR7 is going to be removed from the Kernel, so remove its watchdog
support. This allows us to remove the platform because this driver
includes a platform specific header.
Signed-off-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
Acked-by: Florian Fainelli <f.fainelli@gmail.com>
Acked-by: Guenter Roeck <linux@roeck-us.net>
Signed-off-by: Thomas Bogendoerfer <tsbogend@alpha.franken.de>
This patch add support for Marvell GTI watchdog. Global timer
unit (GTI) support hardware watchdog timer. Software programs
watchdog timer to generate interrupt on first timeout, second
timeout is configured to be ignored and system reboots on
third timeout.
Signed-off-by: Bharat Bhushan <bbhushan2@marvell.com>
Reviewed-by: Guenter Roeck <linux@roeck-us.net>
Link: https://lore.kernel.org/r/20230803032523.6242-2-bbhushan2@marvell.com
[groeck: MODULE_LICENSE GPL v2 -> GPL since that is sufficient]
Signed-off-by: Guenter Roeck <linux@roeck-us.net>
Signed-off-by: Wim Van Sebroeck <wim@linux-watchdog.org>
Versal watchdog driver uses window watchdog mode. Window watchdog
timer(WWDT) contains closed(first) and open(second) window with
32 bit width. Write to the watchdog timer within predefined window
periods of time. This means a period that is not too soon and a
period that is not too late. The WWDT has to be restarted within
the open window time. If software tries to restart WWDT outside of
the open window time period, it generates a reset.
Signed-off-by: Srinivas Neeli <srinivas.neeli@amd.com>
Reviewed-by: Guenter Roeck <linux@roeck-us.net>
Link: https://lkml.kernel.org/r/20230420104231.2243079-4-srinivas.neeli@amd.com
Signed-off-by: Guenter Roeck <linux@roeck-us.net>
Signed-off-by: Wim Van Sebroeck <wim@linux-watchdog.org>
PAPR v2.12 defines a new hypercall, H_WATCHDOG. The hypercall permits
guest control of one or more virtual watchdog timers. The timers have
millisecond granularity. The guest is terminated when a timer
expires.
This patch adds a watchdog driver for these timers, "pseries-wdt".
pseries_wdt_probe() currently assumes the existence of only one
platform device and always assigns it watchdogNumber 1. If we ever
expose more than one timer to userspace we will need to devise a way
to assign a distinct watchdogNumber to each platform device at device
registration time.
Signed-off-by: Scott Cheloha <cheloha@linux.ibm.com>
Acked-by: Guenter Roeck <linux@roeck-us.net>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>
Link: https://lore.kernel.org/r/20220713202335.1217647-5-cheloha@linux.ibm.com
Pull more ARM SoC updates from Arnd Bergmann:
"This is the second part of the general SoC updates, containing
everything that did not make it in the initial pull request, or that
came in as a bugfix later.
- Devicetree updates for SoCFPGA, ASPEED, AT91 and Rockchip,
including a new machine using an ASPEED BMC.
- More DT fixes from Krzysztof Kozlowski across platforms
- A new SoC platform for the GXP baseboard management controller,
used in current server products from HPE"
* tag 'arm-late-5.19' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc: (56 commits)
ARM: configs: Enable more audio support for i.MX
tee: optee: Pass a pointer to virt_addr_valid()
arm64: dts: rockchip: rename Quartz64-A bluetooth gpios
arm64: dts: rockchip: add clocks property to cru node rk3368
arm64: dts: rockchip: add clocks property to cru node rk3308
arm64: dts: rockchip: add clocks to rk356x cru
ARM: dts: rockchip: add clocks property to cru node rk3228
ARM: dts: rockchip: add clocks property to cru node rk3036
ARM: dts: rockchip: add clocks property to cru node rk3066a/rk3188
ARM: dts: rockchip: add clocks property to cru node rk3288
ARM: dts: rockchip: Remove "amba" bus nodes from rv1108
ARM: dts: rockchip: add clocks property to cru node rv1108
arm64: dts: sprd: use new 'dma-channels' property
ARM: dts: da850: use new 'dma-channels' property
ARM: dts: pxa: use new 'dma-channels/requests' properties
soc: ixp4xx/qmgr: Fix unused match warning
ARM: ep93xx: Make ts72xx_register_flash() static
ARM: configs: enable support for Kontron KSwitch D10
ep93xx: clock: Do not return the address of the freed memory
arm64: dts: intel: add device tree for n6000
...
Add support for the HPE GXP Watchdog. The GXP asic contains a full
complement of timers one of which is the watchdog timer. The watchdog
timer is 16 bit and has 10ms resolution. The watchdog is created as a
child device of timer since the same register range is used.
Signed-off-by: Nick Hawkins <nick.hawkins@hpe.com>
Signed-off-by: Arnd Bergmann <arnd@arndb.de>
Acked-by: Guenter Roeck <linux@roeck-us.net>
