This enables QoS configuration for QNOC type device which can be found
on SA8775P platform. It enables QoS configuration for master ports with
predefined priority and urgency forwarding. This helps in prioritizing
the traffic originating from different interconnect masters at NOC.
The system may function normally without this feature. However, enabling
QoS helps optimize latency and bandwidth across subsystems like CPU, GPU,
and multimedia engines, which becomes important in high-throughput
scenarios. This is a feature aimed at performance enhancement to improve
system performance under concurrent workloads.
* icc-sa8775p
dt-bindings: interconnect: add reg and clocks properties to enable QoS on sa8775p
interconnect: qcom: sa8775p: enable QoS configuration
Link: https://lore.kernel.org/r/20251001073344.6599-1-odelu.kukatla@oss.qualcomm.com
Signed-off-by: Georgi Djakov <djakov@kernel.org>
Drop the QPIC interconnect and BCM nodes for the SDX75 SoC. The reason
is that this QPIC BCM resource is already defined as a RPMh clock in
clk-rpmh driver as like other SDX SoCs. So it is wrong to describe the
same resource in two different providers.
Also, without this series, the NAND driver fails to probe on SDX75 as
the interconnect sync state disables the QPIC nodes as there were no
clients voting for this ICC resource. However, the NAND driver had already
voted for this BCM resource through the clk-rpmh driver. Since both votes
come from Linux, RPMh was unable to distinguish between these two and ends
up disabling the resource during sync state.
* icc-sdx75
interconnect: qcom: sdx75: Drop QPIC interconnect and BCM nodes
dt-bindings: interconnect: qcom: Drop QPIC_CORE IDs
Link: https://lore.kernel.org/r/20250926-sdx75-icc-v2-0-20d6820e455c@oss.qualcomm.com>
Signed-off-by: Georgi Djakov <djakov@kernel.org>
The lack of the interconnects for the USB2 host might result in the
register writes for the PHY not reaching the PHY and thus the PLL not
locking up, resulting in -EBUSY errors for the USB host on the platform.
Add missing interconnect link and add interconnect paths to the USB2
device.
* icc-msm8996
interconnect: qcom: msm8996: add missing link to SLAVE_USB_HS
arm64: dts: qcom: msm8996: add interconnect paths to USB2 controller
Link: https://lore.kernel.org/r/20251002-fix-msm8996-icc-v1-0-a36a05d1f869@oss.qualcomm.com
Signed-off-by: Georgi Djakov <djakov@kernel.org>
The icc_commit_set() function, used by the debugfs interface, checks
the validity of the global cur_path pointer using IS_ERR_OR_NULL().
However, in the specific case where cur_path is NULL, while
IS_ERR_OR_NULL(NULL) correctly evaluates to true, the subsequent call
to PTR_ERR(NULL) returns 0.
This causes the function to return a success code (0) instead of an
error, misleading the user into believing their bandwidth request was
successfully committed when, in fact, no operation was performed.
Fix this by adding an explicit check to return -EINVAL if cur_path is
NULL. This prevents silent failures and ensures that an invalid
operational sequence is immediately and clearly reported as an error.
Fixes: 770c69f037 ("interconnect: Add debugfs test client")
Signed-off-by: Kuan-Wei Chiu <visitorckw@gmail.com>
Link: https://lore.kernel.org/r/20251010151447.2289779-1-visitorckw@gmail.com
Signed-off-by: Georgi Djakov <djakov@kernel.org>
As like other SDX SoCs, SDX75 SoC's QPIC BCM resource was modeled as a
RPMh clock in clk-rpmh driver. However, for SDX75, this resource was also
described as an interconnect and BCM node mistakenly. It is incorrect to
describe the same resource in two different providers, as it will lead to
votes from clients overriding each other.
Hence, drop the QPIC interconnect and BCM nodes and let the clients use
clk-rpmh driver to vote for this resource.
Without this change, the NAND driver fails to probe on SDX75, as the
interconnect sync state disables the QPIC nodes as there were no clients
voting for this ICC resource. However, the NAND driver had already voted
for this BCM resource through the clk-rpmh driver. Since both votes come
from Linux, RPMh was unable to distinguish between these two and ends up
disabling the QPIC resource during sync state.
Cc: stable@vger.kernel.org
Fixes: 3642b4e5cb ("interconnect: qcom: Add SDX75 interconnect provider driver")
Signed-off-by: Raviteja Laggyshetty <quic_rlaggysh@quicinc.com>
[mani: dropped the reference to bcm_qp0, reworded description]
Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@oss.qualcomm.com>
Reviewed-by: Konrad Dybcio <konrad.dybcio@oss.qualcomm.com>
Tested-by: Lakshmi Sowjanya D <quic_laksd@quicinc.com> # on SDX75
Link: https://lore.kernel.org/r/20250926-sdx75-icc-v2-1-20d6820e455c@oss.qualcomm.com
Signed-off-by: Georgi Djakov <djakov@kernel.org>
Add interconnect dt-bindings and driver support for
Qualcomm's next gen compute SoC - Glymur.
* icc-glymur
dt-bindings: interconnect: document the RPMh Network-On-Chip interconnect in Glymur SoC
interconnect: qcom: icc-rpmh: increase MAX_PORTS to support four QoS ports
interconnect: qcom: add glymur interconnect provider driver
Link: https://lore.kernel.org/r/20250814-glymur-icc-v2-0-596cca6b6015@oss.qualcomm.com
Signed-off-by: Georgi Djakov <djakov@kernel.org>
Pull char / misc / IIO / other driver updates from Greg KH:
"Here is the big set of char/misc/iio and other smaller driver
subsystems for 6.17-rc1. It's a big set this time around, with the
huge majority being in the iio subsystem with new drivers and dts
files being added there.
Highlights include:
- IIO driver updates, additions, and changes making more code const
and cleaning up some init logic
- bus_type constant conversion changes
- misc device test functions added
- rust miscdevice minor fixup
- unused function removals for some drivers
- mei driver updates
- mhi driver updates
- interconnect driver updates
- Android binder updates and test infrastructure added
- small cdx driver updates
- small comedi fixes
- small nvmem driver updates
- small pps driver updates
- some acrn virt driver fixes for printk messages
- other small driver updates
All of these have been in linux-next with no reported issues"
* tag 'char-misc-6.17-rc1' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/char-misc: (292 commits)
binder: Use seq_buf in binder_alloc kunit tests
binder: Add copyright notice to new kunit files
misc: ti_fpc202: Switch to of_fwnode_handle()
bus: moxtet: Use dev_fwnode()
pc104: move PC104 option to drivers/Kconfig
drivers: virt: acrn: Don't use %pK through printk
comedi: fix race between polling and detaching
interconnect: qcom: Add Milos interconnect provider driver
dt-bindings: interconnect: document the RPMh Network-On-Chip Interconnect in Qualcomm Milos SoC
mei: more prints with client prefix
mei: bus: use cldev in prints
bus: mhi: host: pci_generic: Add Telit FN990B40 modem support
bus: mhi: host: Detect events pointing to unexpected TREs
bus: mhi: host: pci_generic: Add Foxconn T99W696 modem
bus: mhi: host: Use str_true_false() helper
bus: mhi: host: pci_generic: Add support for EM929x and set MRU to 32768 for better performance.
bus: mhi: host: Fix endianness of BHI vector table
bus: mhi: host: pci_generic: Disable runtime PM for QDU100
bus: mhi: host: pci_generic: Fix the modem name of Foxconn T99W640
dt-bindings: interconnect: qcom,msm8998-bwmon: Allow 'nonposted-mmio'
...
