This ought to be an omission in e619492323 ("esp: Fix memleaks on error
paths."). The memleak on error path in esp6_input is similar to esp_input
of esp4.
Fixes: e619492323 ("esp: Fix memleaks on error paths.")
Fixes: 3f29770723 ("ipsec: check return value of skb_to_sgvec always")
Signed-off-by: Zhen Lei <thunder.leizhen@huawei.com>
Signed-off-by: Steffen Klassert <steffen.klassert@secunet.com>
Currently esp will happily create an xfrm state with an unknown
encap type for IPv4, without setting the necessary state parameters.
This patch fixes it by returning -EINVAL.
There is a similar problem in IPv6 where if the mode is unknown
we will skip initialisation while returning zero. However, this
is harmless as the mode has already been checked further up the
stack. This patch removes this anomaly by aligning the IPv6
behaviour with IPv4 and treating unknown modes (which cannot
actually happen) as transport mode.
Fixes: 38320c70d2 ("[IPSEC]: Use crypto_aead and authenc in ESP")
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Signed-off-by: Steffen Klassert <steffen.klassert@secunet.com>
We support asynchronous crypto on layer 2 ESP now.
So no need to force synchronous crypto fallback on
offloading anymore.
Signed-off-by: Steffen Klassert <steffen.klassert@secunet.com>
This patch implements asynchronous crypto callbacks
and a backlog handler that can be used when IPsec
is done at layer 2 in the TX path. It also extends
the skb validate functions so that we can update
the driver transmit return codes based on async
crypto operation or to indicate that we queued the
packet in a backlog queue.
Joint work with: Aviv Heller <avivh@mellanox.com>
Signed-off-by: Steffen Klassert <steffen.klassert@secunet.com>
Pull networking updates from David Miller:
"Highlights:
1) Maintain the TCP retransmit queue using an rbtree, with 1GB
windows at 100Gb this really has become necessary. From Eric
Dumazet.
2) Multi-program support for cgroup+bpf, from Alexei Starovoitov.
3) Perform broadcast flooding in hardware in mv88e6xxx, from Andrew
Lunn.
4) Add meter action support to openvswitch, from Andy Zhou.
5) Add a data meta pointer for BPF accessible packets, from Daniel
Borkmann.
6) Namespace-ify almost all TCP sysctl knobs, from Eric Dumazet.
7) Turn on Broadcom Tags in b53 driver, from Florian Fainelli.
8) More work to move the RTNL mutex down, from Florian Westphal.
9) Add 'bpftool' utility, to help with bpf program introspection.
From Jakub Kicinski.
10) Add new 'cpumap' type for XDP_REDIRECT action, from Jesper
Dangaard Brouer.
11) Support 'blocks' of transformations in the packet scheduler which
can span multiple network devices, from Jiri Pirko.
12) TC flower offload support in cxgb4, from Kumar Sanghvi.
13) Priority based stream scheduler for SCTP, from Marcelo Ricardo
Leitner.
14) Thunderbolt networking driver, from Amir Levy and Mika Westerberg.
15) Add RED qdisc offloadability, and use it in mlxsw driver. From
Nogah Frankel.
16) eBPF based device controller for cgroup v2, from Roman Gushchin.
17) Add some fundamental tracepoints for TCP, from Song Liu.
18) Remove garbage collection from ipv6 route layer, this is a
significant accomplishment. From Wei Wang.
19) Add multicast route offload support to mlxsw, from Yotam Gigi"
* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-next: (2177 commits)
tcp: highest_sack fix
geneve: fix fill_info when link down
bpf: fix lockdep splat
net: cdc_ncm: GetNtbFormat endian fix
openvswitch: meter: fix NULL pointer dereference in ovs_meter_cmd_reply_start
netem: remove unnecessary 64 bit modulus
netem: use 64 bit divide by rate
tcp: Namespace-ify sysctl_tcp_default_congestion_control
net: Protect iterations over net::fib_notifier_ops in fib_seq_sum()
ipv6: set all.accept_dad to 0 by default
uapi: fix linux/tls.h userspace compilation error
usbnet: ipheth: prevent TX queue timeouts when device not ready
vhost_net: conditionally enable tx polling
uapi: fix linux/rxrpc.h userspace compilation errors
net: stmmac: fix LPI transitioning for dwmac4
atm: horizon: Fix irq release error
net-sysfs: trigger netlink notification on ifalias change via sysfs
openvswitch: Using kfree_rcu() to simplify the code
openvswitch: Make local function ovs_nsh_key_attr_size() static
openvswitch: Fix return value check in ovs_meter_cmd_features()
...
Replace -EBUSY with -ENOSPC when handling transient busy
indication in the absence of backlog.
Signed-off-by: Gilad Ben-Yossef <gilad@benyossef.com>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
The pointer esph is being initialized with a value that is never
read and then being updated. Remove the redundant initialization
and move the declaration and initializtion of esph to the local
code block.
Cleans up clang warning:
net/ipv6/esp6.c:562:21: warning: Value stored to 'esph' during its
initialization is never read
Signed-off-by: Colin Ian King <colin.king@canonical.com>
Signed-off-by: Steffen Klassert <steffen.klassert@secunet.com>
In conjunction with crypto offload [1], removing the ESP trailer by
hardware can potentially improve the performance by avoiding (1) a
cache miss incurred by reading the nexthdr field and (2) the necessity
to calculate the csum value of the trailer in order to keep skb->csum
valid.
This patch introduces the changes to the xfrm stack and merely serves
as an infrastructure. Subsequent patch to mlx5 driver will put this to
a good use.
[1] https://www.mail-archive.com/netdev@vger.kernel.org/msg175733.html
Signed-off-by: Yossi Kuperman <yossiku@mellanox.com>
Signed-off-by: Steffen Klassert <steffen.klassert@secunet.com>
We use skb_availroom to calculate the skb tailroom for the
ESP trailer. skb_availroom calculates the tailroom and
subtracts this value by reserved_tailroom. However
reserved_tailroom is a union with the skb mark. This means
that we subtract the tailroom by the skb mark if set.
Fix this by using skb_tailroom instead.
Fixes: cac2661c53 ("esp4: Avoid skb_cow_data whenever possible")
Fixes: 03e2a30f6a ("esp6: Avoid skb_cow_data whenever possible")
Signed-off-by: Steffen Klassert <steffen.klassert@secunet.com>
We allocate the page fragment for the ESP trailer inside
a spinlock, but consume it outside of the lock. This
is racy as some other cou could get the same page fragment
then. Fix this by consuming the page fragment inside the
lock too.
Fixes: cac2661c53 ("esp4: Avoid skb_cow_data whenever possible")
Fixes: 03e2a30f6a ("esp6: Avoid skb_cow_data whenever possible")
Signed-off-by: Steffen Klassert <steffen.klassert@secunet.com>
Both ip6_input_finish (non-GRO) and esp6_gro_receive (GRO) strip
the IPv6 header without adjusting skb->csum accordingly. As a
result CHECKSUM_COMPLETE breaks and "hw csum failure" is written
to the kernel log by netdev_rx_csum_fault (dev.c).
Fix skb->csum by substracting the checksum value of the pulled IPv6
header using a call to skb_postpull_rcsum.
This affects both transport and tunnel modes.
Note that the fix occurs far from the place that the header was
pulled. This is based on existing code, see:
ipv6_srh_rcv() in exthdrs.c and rawv6_rcv() in raw.c
Signed-off-by: Yossi Kuperman <yossiku@mellanox.com>
Signed-off-by: Ilan Tayari <ilant@mellanox.com>
Signed-off-by: Steffen Klassert <steffen.klassert@secunet.com>
Keep the device's reported ip_summed indication in case crypto
was offloaded by the device. Subtract the csum values of the
stripped parts (esp header+iv, esp trailer+auth_data) to keep
value correct.
Note: CHECKSUM_COMPLETE should be indicated only if skb->csum
has the post-decryption offload csum value.
Signed-off-by: Ariel Levkovich <lariel@mellanox.com>
Signed-off-by: Ilan Tayari <ilant@mellanox.com>
Signed-off-by: Steffen Klassert <steffen.klassert@secunet.com>
refcount_t type and corresponding API should be
used instead of atomic_t when the variable is used as
a reference counter. This allows to avoid accidental
refcounter overflows that might lead to use-after-free
situations.
Signed-off-by: Elena Reshetova <elena.reshetova@intel.com>
Signed-off-by: Hans Liljestrand <ishkamiel@gmail.com>
Signed-off-by: Kees Cook <keescook@chromium.org>
Signed-off-by: David Windsor <dwindsor@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Steffen Klassert says:
====================
pull request (net-next): ipsec-next 2017-06-23
1) Use memdup_user to spmlify xfrm_user_policy.
From Geliang Tang.
2) Make xfrm_dev_register static to silence a sparse warning.
From Wei Yongjun.
3) Use crypto_memneq to check the ICV in the AH protocol.
From Sabrina Dubroca.
4) Remove some unused variables in esp6.
From Stephen Hemminger.
5) Extend XFRM MIGRATE to allow to change the UDP encapsulation port.
From Antony Antony.
6) Include the UDP encapsulation port to km_migrate announcements.
From Antony Antony.
Please pull or let me know if there are problems.
====================
Signed-off-by: David S. Miller <davem@davemloft.net>
It seems like a historic accident that these return unsigned char *,
and in many places that means casts are required, more often than not.
Make these functions return void * and remove all the casts across
the tree, adding a (u8 *) cast only where the unsigned char pointer
was used directly, all done with the following spatch:
@@
expression SKB, LEN;
typedef u8;
identifier fn = { skb_push, __skb_push, skb_push_rcsum };
@@
- *(fn(SKB, LEN))
+ *(u8 *)fn(SKB, LEN)
@@
expression E, SKB, LEN;
identifier fn = { skb_push, __skb_push, skb_push_rcsum };
type T;
@@
- E = ((T *)(fn(SKB, LEN)))
+ E = fn(SKB, LEN)
@@
expression SKB, LEN;
identifier fn = { skb_push, __skb_push, skb_push_rcsum };
@@
- fn(SKB, LEN)[0]
+ *(u8 *)fn(SKB, LEN)
Note that the last part there converts from push(...)[0] to the
more idiomatic *(u8 *)push(...).
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Resolves warnings:
net/ipv6/esp6.c: In function ‘esp_ssg_unref’:
net/ipv6/esp6.c:121:10: warning: variable ‘seqhi’ set but not used [-Wunused-but-set-variable]
net/ipv6/esp6.c: In function ‘esp6_output_head’:
net/ipv6/esp6.c:227:21: warning: variable ‘esph’ set but not used [-Wunused-but-set-variable]
Signed-off-by: Stephen Hemminger <sthemmin@microsoft.com>
Signed-off-by: Steffen Klassert <steffen.klassert@secunet.com>
A recent commit moved esp_alloc_tmp() out of a lock
protected region, but forgot to remove the unlock from
the error path. This patch removes the forgotten unlock.
While at it, remove some unneeded error assignments too.
Fixes: fca11ebde3 ("esp4: Reorganize esp_output")
Fixes: 383d0350f2 ("esp6: Reorganize esp_output")
Reported-by: Dan Carpenter <dan.carpenter@oracle.com>
Signed-off-by: Steffen Klassert <steffen.klassert@secunet.com>
We need a fallback algorithm for crypto offloading to a NIC.
This is because packets can be rerouted to other NICs that
don't support crypto offloading. The fallback is going to be
implemented at layer2 where we know the final output device
but can't handle asynchronous returns fron the crypto layer.
Signed-off-by: Steffen Klassert <steffen.klassert@secunet.com>
This patch extends the xfrm_type by an encap function pointer
and implements esp4_gso_encap and esp6_gso_encap. These functions
doing the basic esp encapsulation for a GSO packet. In case the
GSO packet needs to be segmented in software, we add gso_segment
functions. This codepath is going to be used on esp hardware
offloads.
Signed-off-by: Steffen Klassert <steffen.klassert@secunet.com>
Haishuang Yan
Zhen Lei
David S. Miller
Herbert Xu
Steffen Klassert
Linus Torvalds
Gilad Ben-Yossef
Gustavo A. R. Silva
Colin Ian King
Yossi Kuperman
Ilan Tayari
Reshetova, Elena
Johannes Berg
Jason A. Donenfeld
Stephen Hemminger