subj is calling kvm_add_routing_entry() which simply extends
KVMState::irq_routes::entries[]
but doesn't check if number of routes goes beyond limit the kernel
is willing to accept. Which later leads toi the assert
qemu-kvm: ../accel/kvm/kvm-all.c:1833: kvm_irqchip_commit_routes: Assertion `ret == 0' failed
typically it happens during guest boot for large enough guest
Reproduced with:
./qemu --enable-kvm -m 8G -smp 64 -machine pc \
`for b in {1..2}; do echo -n "-device pci-bridge,id=pci$b,chassis_nr=$b ";
for i in {0..31}; do touch /tmp/vblk$b$i;
echo -n "-drive file=/tmp/vblk$b$i,if=none,id=drive$b$i,format=raw
-device virtio-blk-pci,drive=drive$b$i,bus=pci$b ";
done; done`
While crash at boot time is bad, the same might happen at hotplug time
which is unacceptable.
So instead calling kvm_add_routing_entry() unconditionally, check first
that number of routes won't exceed KVM_CAP_IRQ_ROUTING. This way virtio
device insteads killin qemu, will gracefully fail to initialize device
as expected with following warnings on console:
virtio-blk failed to set guest notifier (-28), ensure -accel kvm is set.
virtio_bus_start_ioeventfd: failed. Fallback to userspace (slower).
Signed-off-by: Igor Mammedov <imammedo@redhat.com>
Message-ID: <20240408110956.451558-1-imammedo@redhat.com>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
Using log_pc produces the pc at the beginning of TB,
not the actual pc installed by cpu_restore_state_from_tb,
which could be any of the guest instructions within TB.
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Avoid CPUArchState local variable when cpu_env() is used once.
Mechanical patch using the following Coccinelle spatch script:
@@
type CPUArchState;
identifier env;
expression cs;
@@
{
- CPUArchState *env = cpu_env(cs);
... when != env
- env
+ cpu_env(cs)
... when != env
}
Signed-off-by: Philippe Mathieu-Daudé <philmd@linaro.org>
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Message-ID: <20240129164514.73104-5-philmd@linaro.org>
Signed-off-by: Thomas Huth <thuth@redhat.com>
"hw/xen/xen_pt.h" requires "hw/xen/xen_native.h" which is target
specific. It also declares IGD methods, which are not target
specific.
Target-agnostic code can use IGD methods. To allow that, extract
these methos into a new "hw/xen/xen_igd.h" header.
Signed-off-by: Philippe Mathieu-Daudé <philmd@linaro.org>
Reviewed-by: David Woodhouse <dwmw@amazon.co.uk>
Message-Id: <20231114143816.71079-18-philmd@linaro.org>
On i386, after fixing the page walking code to work with pages in
MMIO memory (specifically CXL emulated interleaved memory),
a crash was seen in an interrupt handling path.
Useful part of backtrace
7 0x0000555555ab1929 in bql_lock_impl (file=0x555556049122 "../../accel/tcg/cputlb.c", line=2033) at ../../system/cpus.c:524
8 bql_lock_impl (file=file@entry=0x555556049122 "../../accel/tcg/cputlb.c", line=line@entry=2033) at ../../system/cpus.c:520
9 0x0000555555c9f7d6 in do_ld_mmio_beN (cpu=0x5555578e0cb0, full=0x7ffe88012950, ret_be=ret_be@entry=0, addr=19595792376, size=size@entry=8, mmu_idx=4, type=MMU_DATA_LOAD, ra=0) at ../../accel/tcg/cputlb.c:2033
10 0x0000555555ca0fbd in do_ld_8 (cpu=cpu@entry=0x5555578e0cb0, p=p@entry=0x7ffff4efd1d0, mmu_idx=<optimized out>, type=type@entry=MMU_DATA_LOAD, memop=<optimized out>, ra=ra@entry=0) at ../../accel/tcg/cputlb.c:2356
11 0x0000555555ca341f in do_ld8_mmu (cpu=cpu@entry=0x5555578e0cb0, addr=addr@entry=19595792376, oi=oi@entry=52, ra=0, ra@entry=52, access_type=access_type@entry=MMU_DATA_LOAD) at ../../accel/tcg/cputlb.c:2439
12 0x0000555555ca5f59 in cpu_ldq_mmu (ra=52, oi=52, addr=19595792376, env=0x5555578e3470) at ../../accel/tcg/ldst_common.c.inc:169
13 cpu_ldq_le_mmuidx_ra (env=0x5555578e3470, addr=19595792376, mmu_idx=<optimized out>, ra=ra@entry=0) at ../../accel/tcg/ldst_common.c.inc:301
14 0x0000555555b4b5fc in ptw_ldq (ra=0, in=0x7ffff4efd320) at ../../target/i386/tcg/sysemu/excp_helper.c:98
15 ptw_ldq (ra=0, in=0x7ffff4efd320) at ../../target/i386/tcg/sysemu/excp_helper.c:93
16 mmu_translate (env=env@entry=0x5555578e3470, in=0x7ffff4efd3e0, out=0x7ffff4efd3b0, err=err@entry=0x7ffff4efd3c0, ra=ra@entry=0) at ../../target/i386/tcg/sysemu/excp_helper.c:174
17 0x0000555555b4c4b3 in get_physical_address (ra=0, err=0x7ffff4efd3c0, out=0x7ffff4efd3b0, mmu_idx=0, access_type=MMU_DATA_LOAD, addr=18446741874686299840, env=0x5555578e3470) at ../../target/i386/tcg/sysemu/excp_helper.c:580
18 x86_cpu_tlb_fill (cs=0x5555578e0cb0, addr=18446741874686299840, size=<optimized out>, access_type=MMU_DATA_LOAD, mmu_idx=0, probe=<optimized out>, retaddr=0) at ../../target/i386/tcg/sysemu/excp_helper.c:606
19 0x0000555555ca0ee9 in tlb_fill (retaddr=0, mmu_idx=0, access_type=MMU_DATA_LOAD, size=<optimized out>, addr=18446741874686299840, cpu=0x7ffff4efd540) at ../../accel/tcg/cputlb.c:1315
20 mmu_lookup1 (cpu=cpu@entry=0x5555578e0cb0, data=data@entry=0x7ffff4efd540, mmu_idx=0, access_type=access_type@entry=MMU_DATA_LOAD, ra=ra@entry=0) at ../../accel/tcg/cputlb.c:1713
21 0x0000555555ca2c61 in mmu_lookup (cpu=cpu@entry=0x5555578e0cb0, addr=addr@entry=18446741874686299840, oi=oi@entry=32, ra=ra@entry=0, type=type@entry=MMU_DATA_LOAD, l=l@entry=0x7ffff4efd540) at ../../accel/tcg/cputlb.c:1803
22 0x0000555555ca3165 in do_ld4_mmu (cpu=cpu@entry=0x5555578e0cb0, addr=addr@entry=18446741874686299840, oi=oi@entry=32, ra=ra@entry=0, access_type=access_type@entry=MMU_DATA_LOAD) at ../../accel/tcg/cputlb.c:2416
23 0x0000555555ca5ef9 in cpu_ldl_mmu (ra=0, oi=32, addr=18446741874686299840, env=0x5555578e3470) at ../../accel/tcg/ldst_common.c.inc:158
24 cpu_ldl_le_mmuidx_ra (env=env@entry=0x5555578e3470, addr=addr@entry=18446741874686299840, mmu_idx=<optimized out>, ra=ra@entry=0) at ../../accel/tcg/ldst_common.c.inc:294
25 0x0000555555bb6cdd in do_interrupt64 (is_hw=1, next_eip=18446744072399775809, error_code=0, is_int=0, intno=236, env=0x5555578e3470) at ../../target/i386/tcg/seg_helper.c:889
26 do_interrupt_all (cpu=cpu@entry=0x5555578e0cb0, intno=236, is_int=is_int@entry=0, error_code=error_code@entry=0, next_eip=next_eip@entry=0, is_hw=is_hw@entry=1) at ../../target/i386/tcg/seg_helper.c:1130
27 0x0000555555bb87da in do_interrupt_x86_hardirq (env=env@entry=0x5555578e3470, intno=<optimized out>, is_hw=is_hw@entry=1) at ../../target/i386/tcg/seg_helper.c:1162
28 0x0000555555b5039c in x86_cpu_exec_interrupt (cs=0x5555578e0cb0, interrupt_request=<optimized out>) at ../../target/i386/tcg/sysemu/seg_helper.c:197
29 0x0000555555c94480 in cpu_handle_interrupt (last_tb=<synthetic pointer>, cpu=0x5555578e0cb0) at ../../accel/tcg/cpu-exec.c:844
Peter identified this as being due to the BQL already being
held when the page table walker encounters MMIO memory and attempts
to take the lock again. There are other examples of similar paths
TCG, so this follows the approach taken in those of simply checking
if the lock is already held and if it is, don't take it again.
Reviewed-by: Peter Maydell <peter.maydell@linaro.org>
Suggested-by: Peter Maydell <peter.maydell@linaro.org>
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
Message-Id: <20240219173153.12114-4-Jonathan.Cameron@huawei.com>
[rth: Use BQL_LOCK_GUARD]
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
A memory page poisoned from the hypervisor level is no longer readable.
The migration of a VM will crash Qemu when it tries to read the
memory address space and stumbles on the poisoned page with a similar
stack trace:
Program terminated with signal SIGBUS, Bus error.
#0 _mm256_loadu_si256
#1 buffer_zero_avx2
#2 select_accel_fn
#3 buffer_is_zero
#4 save_zero_page
#5 ram_save_target_page_legacy
#6 ram_save_host_page
#7 ram_find_and_save_block
#8 ram_save_iterate
#9 qemu_savevm_state_iterate
#10 migration_iteration_run
#11 migration_thread
#12 qemu_thread_start
To avoid this VM crash during the migration, prevent the migration
when a known hardware poison exists on the VM.
Signed-off-by: William Roche <william.roche@oracle.com>
Link: https://lore.kernel.org/r/20240130190640.139364-2-william.roche@oracle.com
Signed-off-by: Peter Xu <peterx@redhat.com>
The function is now trivial, and with inlining we can
re-use the calling function's tcg_ops variable.
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
