This patch seems to have originally been from
https://patchwork.coreboot.org/patch/4126/ . The most recent version
seems to be in OpenEmbedded (commit 503a572) which added support for
16Mbit and 32Mbit variants.
The OpenEmbedded patch also makes changes to linux_spi.c to add some
debug prints which are omitted in this version.
From the original commit message:
Differences between SST26 and SST25:
1. The WREN instruction must be executed prior to WRSR [Section 5.31].
There is no EWSR.
2. Block protection bits are no longer in the status register. There
is a dedicated 144-bit register [Table 5-6]. The device is
write-protected by default. A Global Block-Protection Unlock
command unlocks the entire memory [Section 4.1].
Change-Id: Ib019bed8ce955049703eb3376c32a83ef607c219
Signed-off-by: Wei Hu <wei@aristanetworks.com>
Signed-off-by: David Hendricks <david.hendricks@gmail.com>
Signed-off-by: Stefan Tauner <stefan.tauner@student.tuwien.ac.at>
Reviewed-on: https://review.coreboot.org/25962
Tested-by: build bot (Jenkins) <no-reply@coreboot.org>
The W25Q80BW appears to have been succeeded by the W25Q80EW which has a
different manufacturer ID but is otherwise similar. Consequently, W25Q80.W
no longer matches all chips in this family.
This patch makes the original entry specific to W25Q80BW.
Change-Id: I2980272c2691eb62a68056a7a4c308e9b4810347
Signed-off-by: David Hendricks <dhendricks@fb.com>
Reviewed-on: https://review.coreboot.org/25100
Tested-by: build bot (Jenkins) <no-reply@coreboot.org>
Reviewed-by: Nico Huber <nico.h@gmx.de>
This adds support for W25P80/16/32 chips. Most notably these chips only
have two erase commands - one for 64KiB "sectors" and one for chip
erase.
Change-Id: Ie09ba8e28fee35c42e17ca05219dc673413de93b
Signed-off-by: David Hendricks <david.hendricks@gmail.com>
Reviewed-on: https://review.coreboot.org/23700
Tested-by: build bot (Jenkins) <no-reply@coreboot.org>
The ENE Embedded Debug Interface (EDI) is a SPI-based interface for
accessing the memory of ENE embedded controllers.
The ENE KB9012 EC is an embedded controller found on various laptops
such as the Lenovo G505s. It features a 8051 microcontroller and
has 128 KiB of internal storage for program data.
EDI can be accessed on the KB9012 through pins 59-62 (CS-CLK-MOSI-MISO)
when flash direct access is not in use. Some firmwares disable EDI at runtime
so it might be necessary to ground pin 42 to reset the 8051 microcontroller
before accessing the KB9012 via EDI.
The example of flashing KB9012 at Lenovo G505S laptop could be found here:
http://dangerousprototypes.com/docs/Flashing_KB9012_with_Bus_Pirate
Change-Id: Ib8b2eb2feeef5c337d725d15ebf994a299897854
Signed-off-by: Mike Banon <mikebdp2@gmail.com>
Signed-off-by: Paul Kocialkowski <contact@paulk.fr>
Reviewed-on: https://review.coreboot.org/23259
Tested-by: build bot (Jenkins) <no-reply@coreboot.org>
Reviewed-by: Nico Huber <nico.h@gmx.de>
Advertise all 4BA features that are currently supported by flashrom,
plus add a new feature flag for the 4BA fast-read instruction. Also,
list all supported 3BA and 4BA erase-block functions.
As this adds a lot of new code paths that could be taken for these
chips, mark them all as untested again.
Change-Id: I0598496ee7058e3b170684d366f58e4014e0e871
Signed-off-by: Nico Huber <nico.h@gmx.de>
Reviewed-on: https://review.coreboot.org/22423
Reviewed-by: Stefan Reinauer <stefan.reinauer@coreboot.org>
Tested-by: build bot (Jenkins) <no-reply@coreboot.org>
Reviewed-by: David Hendricks <david.hendricks@gmail.com>
Instead of arbitrarily deciding whether to enter 4BA mode in the flash
chip's declaration, advertise that entering 4BA mode is supported and
only enter it if the SPI master supports 4-byte addresses. If not, exit
4BA mode (the chip might be in 4BA mode after reset). If we can't assure
the state of 4BA mode, we bail out to simplify the code (we'd have to
ensure that we don't run any instructions that can usually be switched
to 4BA mode otherwise).
Two new feature flags are introduced:
* FEATURE_4BA_ENTER:
Can enter/exit 4BA mode with instructions 0xb7/0xe9 w/o WREN.
* FEATURE_4BA_ENTER_WREN
Can enter/exit 4BA mode with instructions 0xb7/0xe9 after WREN.
FEATURE_4BA_SUPPORT is dropped, it's completely implicit now.
Also, draw the with/without WREN distinction into the enter/exit
functions to reduce code redundancy.
Change-Id: I877fe817f801fc54bd0ee2ce4e3ead324cbb3673
Signed-off-by: Nico Huber <nico.h@gmx.de>
Reviewed-on: https://review.coreboot.org/22422
Reviewed-by: Stefan Reinauer <stefan.reinauer@coreboot.org>
Tested-by: build bot (Jenkins) <no-reply@coreboot.org>
Reviewed-by: David Hendricks <david.hendricks@gmail.com>
Prefer the native 4BA instruction when they are supported. In this
case, override our logic to decide to use a 4BA address.
Change-Id: I2f6817ca198bf923671a7aa67e956e5477d71848
Signed-off-by: Nico Huber <nico.h@gmx.de>
Reviewed-on: https://review.coreboot.org/22385
Reviewed-by: Stefan Reinauer <stefan.reinauer@coreboot.org>
Tested-by: build bot (Jenkins) <no-reply@coreboot.org>
IS25LP128 is the 3.3V variant, IS25WP128 is the 1.8V variant.
Tested read, erase, and write using Dediprog SF600 on each.
Change-Id: Ia1c7a9a950043c30b7525196e03ee394689e89a5
Signed-off-by: David Hendricks <dhendricks@fb.com>
Reviewed-on: https://review.coreboot.org/22784
Reviewed-by: Nico Huber <nico.h@gmx.de>
Tested-by: build bot (Jenkins) <no-reply@coreboot.org>
This allows us to support flash chips in any of the following
configurations, regardless of whether the chip powers up in 3-byte or
4-byte address mode.
- standard commands with extended address register (*_4ba_ereg) or
direct commands (*_4ba_direct) in 3-byte address mode (.set_4ba =
spi_exit_4ba_*)
- standard commands (*_4ba) or direct commands (*_4ba_direct) in
4-byte address mode (.set_4ba = spi_enter_4ba_*)
- direct commands (*_4ba_direct) in either address mode (.set_4ba =
NULL)
Change-Id: I0b25309d731426940fc50956b744b681ab599e87
Signed-off-by: Ed Swierk <eswierk@skyportsystems.com>
Reviewed-on: https://review.coreboot.org/20510
Reviewed-by: David Hendricks <david.hendricks@gmail.com>
Tested-by: build bot (Jenkins) <no-reply@coreboot.org>
Steffen Mauch
Evan Jensen
Nico Huber
Wei Hu
Elyes HAOUAS
David Hendricks
Stanislav Sedov
jvm
David Hendricks
nybash
Paul Kocialkowski
Timothy Pearson
Ed Swierk