Set integration_platforms on these samples to just native_posix. This
should be sufficient to make sure these tests build and run.
Signed-off-by: Kumar Gala <kumar.gala@linaro.org>
All dma drivers are devicetree based now so we can remove the last
bits of Kconfig associated with the old driver style.
Signed-off-by: Kumar Gala <kumar.gala@linaro.org>
Replace device_get_binding with DEVICE_DT_GET for getting access
to the io-channels/adc controller device.
Signed-off-by: Kumar Gala <kumar.gala@linaro.org>
Set integration_platforms on these samples to just frdm_k64f.
This should be sufficient to make sure these tests build.
Signed-off-by: Kumar Gala <kumar.gala@linaro.org>
I only see one sample with an overlay using the now legacy sda-pin and
scl-pin properties. Move it to the new style.
Signed-off-by: Martí Bolívar <marti.bolivar@nordicsemi.no>
Modify an example by adding command that is using shell_getopt funtion.
Extent sample.yaml with getopt configuration.
Signed-off-by: Jakub Rzeszutko <jakub.rzeszutko@nordicsemi.no>
Convert ism330dhcx INT_PIN attribute from Kconfigs to Device
Tree binding properties. Here int-pin has been defined as
enum with two possible values: 1 and 2.
Signed-off-by: Armando Visconti <armando.visconti@st.com>
Add an example callback implementation that prints out the new maximum
payload given the updated datarate.
Signed-off-by: Jordan Yates <jordan.yates@data61.csiro.au>
The default shell configuration has heavy flash and memory requirements,
requiring project maintainers to set many configuration options to "n"
to keep flash and memory requirements within reason.
This adds a new configuration option, CONFIG_SHELL_MINIMAL, which will
disable flash and memory heavy options by default, and allow project
maintainers to select/imply only the options they want.
On a quick test from an ARM board I'm working on, enabling this option
cut flash space requirements by ~8 KB, and memory requirements by ~1 KB.
Signed-off-by: Jack Rosenthal <jrosenth@chromium.org>
Set integration_platforms on these samples to just native_posix.
This should be sufficient to make sure these tests build and run.
Signed-off-by: Kumar Gala <kumar.gala@linaro.org>
Set integration_platforms on these samples to just native_posix. This
should be sufficient to make sure these tests build and run.
Signed-off-by: Kumar Gala <kumar.gala@linaro.org>
Add an application that uses Direction Finding API for
transmission of CTE in connectionless mode (periodic adverising PDUs).
Signed-off-by: Piotr Pryga <piotr.pryga@nordicsemi.no>
We need to set a proper IPv4 netmask to each VLAN interface
so that IPv4 source address selection will work properly.
If we do not do this, then the network interface could be
selected incorrectly for the VLAN interfaces which could then
mean that the packet might get dropped by the target device.
Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
