Alexei Starovoitov says:
====================
pull-request: bpf-next 2020-02-28
The following pull-request contains BPF updates for your *net-next* tree.
We've added 41 non-merge commits during the last 7 day(s) which contain
a total of 49 files changed, 1383 insertions(+), 499 deletions(-).
The main changes are:
1) BPF and Real-Time nicely co-exist.
2) bpftool feature improvements.
3) retrieve bpf_sk_storage via INET_DIAG.
====================
Signed-off-by: David S. Miller <davem@davemloft.net>
The mptcp conflict was overlapping additions.
The SMC conflict was an additional and removal happening at the same
time.
Signed-off-by: David S. Miller <davem@davemloft.net>
Pull networking fixes from David Miller:
1) Fix leak in nl80211 AP start where we leak the ACL memory, from
Johannes Berg.
2) Fix double mutex unlock in mac80211, from Andrei Otcheretianski.
3) Fix RCU stall in ipset, from Jozsef Kadlecsik.
4) Fix devlink locking in devlink_dpipe_table_register, from Madhuparna
Bhowmik.
5) Fix race causing TX hang in ll_temac, from Esben Haabendal.
6) Stale eth hdr pointer in br_dev_xmit(), from Nikolay Aleksandrov.
7) Fix TX hash calculation bounds checking wrt. tc rules, from Amritha
Nambiar.
8) Size netlink responses properly in schedule action code to take into
consideration TCA_ACT_FLAGS. From Jiri Pirko.
9) Fix firmware paths for mscc PHY driver, from Antoine Tenart.
10) Don't register stmmac notifier multiple times, from Aaro Koskinen.
11) Various rmnet bug fixes, from Taehee Yoo.
12) Fix vsock deadlock in vsock transport release, from Stefano
Garzarella.
* git://git.kernel.org/pub/scm/linux/kernel/git/netdev/net: (61 commits)
net: dsa: mv88e6xxx: Fix masking of egress port
mlxsw: pci: Wait longer before accessing the device after reset
sfc: fix timestamp reconstruction at 16-bit rollover points
vsock: fix potential deadlock in transport->release()
unix: It's CONFIG_PROC_FS not CONFIG_PROCFS
net: rmnet: fix packet forwarding in rmnet bridge mode
net: rmnet: fix bridge mode bugs
net: rmnet: use upper/lower device infrastructure
net: rmnet: do not allow to change mux id if mux id is duplicated
net: rmnet: remove rcu_read_lock in rmnet_force_unassociate_device()
net: rmnet: fix suspicious RCU usage
net: rmnet: fix NULL pointer dereference in rmnet_changelink()
net: rmnet: fix NULL pointer dereference in rmnet_newlink()
net: phy: marvell: don't interpret PHY status unless resolved
mlx5: register lag notifier for init network namespace only
unix: define and set show_fdinfo only if procfs is enabled
hinic: fix a bug of rss configuration
hinic: fix a bug of setting hw_ioctxt
hinic: fix a irq affinity bug
net/smc: check for valid ib_client_data
...
The scale test for Spectrum-2 should be invoked for Spectrum-2 and
Spectrum-3. Add the appropriate device ID.
Signed-off-by: Amit Cohen <amitc@mellanox.com>
Signed-off-by: Ido Schimmel <idosch@mellanox.com>
Signed-off-by: Jiri Pirko <jiri@mellanox.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Currently, the test inserts X /32 routes and for each route it is
testing that a packet sent from the first host is received by the second
host, which is very time-consuming.
Instead only validate the offload flag of each route and get the same result.
Wait between the creation of the routes and the offload validation in
order to make sure that all the routes were successfully offloaded.
Signed-off-by: Danielle Ratson <danieller@mellanox.com>
Signed-off-by: Ido Schimmel <idosch@mellanox.com>
Signed-off-by: Jiri Pirko <jiri@mellanox.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
After adding a given number of flower rules for different IPv6
addresses, the test generates traffic and ensures that each packet is
received, which is time-consuming.
Instead, test the offload indication of the tc flower rules and reduce
the running time by half.
Signed-off-by: Danielle Ratson <danieller@mellanox.com>
Signed-off-by: Ido Schimmel <idosch@mellanox.com>
Signed-off-by: Jiri Pirko <jiri@mellanox.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Test the max shared buffer occupancy for port's pool and port's TC's (using
different types of packets).
Signed-off-by: Shalom Toledo <shalomt@mellanox.com>
Signed-off-by: Ido Schimmel <idosch@mellanox.com>
Signed-off-by: Jiri Pirko <jiri@mellanox.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Test physical ports' shared buffer configuration options using random
values related to a specific configuration option. There are 3
configuration options: pool, TC bind and portpool.
Each sub-test, test a different configuration option and random the related
values as the follow:
* For pools, pool's size will be randomized.
* For TC bind, pool number and threshold will be randomized.
* For portpools, threshold will be randomized.
Signed-off-by: Shalom Toledo <shalomt@mellanox.com>
Signed-off-by: Ido Schimmel <idosch@mellanox.com>
Signed-off-by: Jiri Pirko <jiri@mellanox.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Rtnetlink test uses offload indication checks.
Use a busywait helper and wait until the offload indication is set or
fail if it reaches timeout.
Signed-off-by: Danielle Ratson <danieller@mellanox.com>
Reviewed-by: Petr Machata <petrm@mellanox.com>
Signed-off-by: Ido Schimmel <idosch@mellanox.com>
Signed-off-by: Jiri Pirko <jiri@mellanox.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Vxlan test uses offload indication checks.
Use a busywait helper and wait until the offload indication is set or
fail if it reaches timeout.
Signed-off-by: Danielle Ratson <danieller@mellanox.com>
Reviewed-by: Petr Machata <petrm@mellanox.com>
Signed-off-by: Ido Schimmel <idosch@mellanox.com>
Signed-off-by: Jiri Pirko <jiri@mellanox.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Blackhole routes test uses offload indication checks.
Use busywait helper and wait until the routes offload indication is set or
fail if it reaches timeout.
Signed-off-by: Danielle Ratson <danieller@mellanox.com>
Reviewed-by: Petr Machata <petrm@mellanox.com>
Signed-off-by: Ido Schimmel <idosch@mellanox.com>
Signed-off-by: Jiri Pirko <jiri@mellanox.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
The test checks that packets are trapped when they should egress a
router interface (RIF) that has become disabled. This is a temporary
state in a RIF's deletion sequence.
Currently, the test deletes the RIF by flushing all the IP addresses
configured on the associated netdev (br0). However, this is racy, as
this also flushes all the routes pointing to the netdev and if the
routes are deleted from the device before the RIF is disabled, then no
packets will try to egress the disabled RIF and the trap will not be
triggered.
Instead, trigger the deletion of the RIF by unlinking the mlxsw port
from the bridge that is backing the RIF. Unlike before, this will not
cause the kernel to delete the routes pointing to the bridge.
Note that due to current mlxsw locking scheme the RIF is always deleted
first, but this is going to change.
Signed-off-by: Ido Schimmel <idosch@mellanox.com>
Signed-off-by: Jiri Pirko <jiri@mellanox.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Include test of forbidding to have redirect rule on egress-bound block.
Signed-off-by: Jiri Pirko <jiri@mellanox.com>
Signed-off-by: Ido Schimmel <idosch@mellanox.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
This tests that below the queue minimum length, there is no dropping /
marking, and above max, everything is dropped / marked.
The test is structured as a core file with topology and test code, and
three wrappers: one for RED used as a root Qdisc, and two for
testing (W)RED under PRIO and ETS.
Signed-off-by: Petr Machata <petrm@mellanox.com>
Signed-off-by: Ido Schimmel <idosch@mellanox.com>
Signed-off-by: Jiri Pirko <jiri@mellanox.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Extract a helper __start_traffic() configurable by protocol type. Allow
passing through extra mausezahn arguments. Add a wrapper,
start_tcp_traffic().
Signed-off-by: Petr Machata <petrm@mellanox.com>
Signed-off-by: Ido Schimmel <idosch@mellanox.com>
Signed-off-by: Jiri Pirko <jiri@mellanox.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Pull tracing and bootconfig updates:
"Fixes and changes to bootconfig before it goes live in a release.
Change in API of bootconfig (before it comes live in a release):
- Have a magic value "BOOTCONFIG" in initrd to know a bootconfig
exists
- Set CONFIG_BOOT_CONFIG to 'n' by default
- Show error if "bootconfig" on cmdline but not compiled in
- Prevent redefining the same value
- Have a way to append values
- Added a SELECT BLK_DEV_INITRD to fix a build failure
Synthetic event fixes:
- Switch to raw_smp_processor_id() for recording CPU value in preempt
section. (No care for what the value actually is)
- Fix samples always recording u64 values
- Fix endianess
- Check number of values matches number of fields
- Fix a printing bug
Fix of trace_printk() breaking postponed start up tests
Make a function static that is only used in a single file"
* tag 'trace-v5.6-rc2' of git://git.kernel.org/pub/scm/linux/kernel/git/rostedt/linux-trace:
bootconfig: Fix CONFIG_BOOTTIME_TRACING dependency issue
bootconfig: Add append value operator support
bootconfig: Prohibit re-defining value on same key
bootconfig: Print array as multiple commands for legacy command line
bootconfig: Reject subkey and value on same parent key
tools/bootconfig: Remove unneeded error message silencer
bootconfig: Add bootconfig magic word for indicating bootconfig explicitly
bootconfig: Set CONFIG_BOOT_CONFIG=n by default
tracing: Clear trace_state when starting trace
bootconfig: Mark boot_config_checksum() static
tracing: Disable trace_printk() on post poned tests
tracing: Have synthetic event test use raw_smp_processor_id()
tracing: Fix number printing bug in print_synth_event()
tracing: Check that number of vals matches number of synth event fields
tracing: Make synth_event trace functions endian-correct
tracing: Make sure synth_event_trace() example always uses u64
Pull Kunit fixes from Shuah Khan:
"This Kselftest kunit update consists of fixes to documentation and
the run-time tool from Brendan Higgins and Heidi Fahim"
* tag 'linux-kselftest-kunit-5.6-rc4' of git://git.kernel.org/pub/scm/linux/kernel/git/shuah/linux-kselftest:
kunit: run kunit_tool from any directory
kunit: test: Improve error messages for kunit_tool when kunitconfig is invalid
Documentation: kunit: fixed sphinx error in code block
Pull Kselftest fixes from Shuah Khan:
- fixes to TIMEOUT failures and out-of-tree compilation compilation
errors from Michael Ellerman.
- declutter git status fix from Christophe Leroy
* tag 'linux-kselftest-5.6-rc4' of git://git.kernel.org/pub/scm/linux/kernel/git/shuah/linux-kselftest:
selftests/rseq: Fix out-of-tree compilation
selftests: Install settings files to fix TIMEOUT failures
selftest/lkdtm: Don't pollute 'git status'
