For GRU and EPT, we need gup-fast to set referenced bit too (this is why
it's correct to return 0 when shadow_access_mask is zero, it requires
gup-fast to set the referenced bit). qemu-kvm access already sets the
young bit in the pte if it isn't zero-copy, if it's zero copy or a shadow
paging EPT minor fault we relay on gup-fast to signal the page is in
use...
We also need to check the young bits on the secondary pagetables for NPT
and not nested shadow mmu as the data may never get accessed again by the
primary pte.
Without this closer accuracy, we'd have to remove the heuristic that
avoids collapsing hugepages in hugepage virtual regions that have not even
a single subpage in use.
->test_young is full backwards compatible with GRU and other usages that
don't have young bits in pagetables set by the hardware and that should
nuke the secondary mmu mappings when ->clear_flush_young runs just like
EPT does.
Removing the heuristic that checks the young bit in
khugepaged/collapse_huge_page completely isn't so bad either probably but
I thought it was worth it and this makes it reliable.
Signed-off-by: Andrea Arcangeli <aarcange@redhat.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
This should work for both hugetlbfs and transparent hugepages.
[akpm@linux-foundation.org: bring forward PageTransCompound() addition for bisectability]
Signed-off-by: Andrea Arcangeli <aarcange@redhat.com>
Cc: Avi Kivity <avi@redhat.com>
Cc: Marcelo Tosatti <mtosatti@redhat.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
Since vmx blocks INIT signals, we disable virtualization extensions during
reboot. This leads to virtualization instructions faulting; we trap these
faults and spin while the reboot continues.
Unfortunately spinning on a non-preemptible kernel may block a task that
reboot depends on; this causes the reboot to hang.
Fix by skipping over the instruction and hoping for the best.
Signed-off-by: Avi Kivity <avi@redhat.com>
Quote from Avi:
| I don't think we need to flush immediately; set a "tlb dirty" bit somewhere
| that is cleareded when we flush the tlb. kvm_mmu_notifier_invalidate_page()
| can consult the bit and force a flush if set.
Signed-off-by: Xiao Guangrong <xiaoguangrong@cn.fujitsu.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
Store irq routing table pointer in the irqfd object,
and use that to inject MSI directly without bouncing out to
a kernel thread.
While we touch this structure, rearrange irqfd fields to make fastpath
better packed for better cache utilization.
This also adds some comments about locking rules and rcu usage in code.
Some notes on the design:
- Use pointer into the rt instead of copying an entry,
to make it possible to use rcu, thus side-stepping
locking complexities. We also save some memory this way.
- Old workqueue code is still used for level irqs.
I don't think we DTRT with level anyway, however,
it seems easier to keep the code around as
it has been thought through and debugged, and fix level later than
rip out and re-instate it later.
Signed-off-by: Michael S. Tsirkin <mst@redhat.com>
Acked-by: Marcelo Tosatti <mtosatti@redhat.com>
Acked-by: Gregory Haskins <ghaskins@novell.com>
Signed-off-by: Avi Kivity <avi@redhat.com>
The naming convension of hardware_[dis|en]able family is little bit confusing
because only hardware_[dis|en]able_all are using _nolock suffix.
Renaming current hardware_[dis|en]able() to *_nolock() and using
hardware_[dis|en]able() as wrapper functions which take kvm_lock for them
reduces extra confusion.
Signed-off-by: Takuya Yoshikawa <yoshikawa.takuya@oss.ntt.co.jp>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
In kvm_cpu_hotplug(), only CPU_STARTING case is protected by kvm_lock.
This patch adds missing protection for CPU_DYING case.
Signed-off-by: Takuya Yoshikawa <yoshikawa.takuya@oss.ntt.co.jp>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
Any arch not supporting device assigment will also not build
assigned-dev.c. So testing for KVM_CAP_DEVICE_DEASSIGNMENT is pointless.
KVM_CAP_ASSIGN_DEV_IRQ is unconditinally set. Moreover, add a default
case for dispatching the ioctl.
Acked-by: Alex Williamson <alex.williamson@redhat.com>
Acked-by: Michael S. Tsirkin <mst@redhat.com>
Signed-off-by: Jan Kiszka <jan.kiszka@siemens.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
The guest may change states that pci_reset_function does not touch. So
we better save/restore the assigned device across guest usage.
Acked-by: Alex Williamson <alex.williamson@redhat.com>
Acked-by: Michael S. Tsirkin <mst@redhat.com>
Signed-off-by: Jan Kiszka <jan.kiszka@siemens.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
This improves the IRQ forwarding for assigned devices: By using the
kernel's threaded IRQ scheme, we can get rid of the latency-prone work
queue and simplify the code in the same run.
Moreover, we no longer have to hold assigned_dev_lock while raising the
guest IRQ, which can be a lenghty operation as we may have to iterate
over all VCPUs. The lock is now only used for synchronizing masking vs.
unmasking of INTx-type IRQs, thus is renames to intx_lock.
Acked-by: Alex Williamson <alex.williamson@redhat.com>
Acked-by: Michael S. Tsirkin <mst@redhat.com>
Signed-off-by: Jan Kiszka <jan.kiszka@siemens.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
When we deassign a guest IRQ, clear the potentially asserted guest line.
There might be no chance for the guest to do this, specifically if we
switch from INTx to MSI mode.
Acked-by: Alex Williamson <alex.williamson@redhat.com>
Acked-by: Michael S. Tsirkin <mst@redhat.com>
Signed-off-by: Jan Kiszka <jan.kiszka@siemens.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
IA64 support forces us to abstract the allocation of the kvm structure.
But instead of mixing this up with arch-specific initialization and
doing the same on destruction, split both steps. This allows to move
generic destruction calls into generic code.
It also fixes error clean-up on failures of kvm_create_vm for IA64.
Signed-off-by: Jan Kiszka <jan.kiszka@siemens.com>
Signed-off-by: Avi Kivity <avi@redhat.com>
In kvm_async_pf_wakeup_all(), we add a dummy apf to vcpu->async_pf.done
without holding vcpu->async_pf.lock, it will break if we are handling apfs
at this time.
Also use 'list_empty_careful()' instead of 'list_empty()'
Signed-off-by: Xiao Guangrong <xiaoguangrong@cn.fujitsu.com>
Acked-by: Gleb Natapov <gleb@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
If it's no need to inject async #PF to PV guest we can handle
more completed apfs at one time, so we can retry guest #PF
as early as possible
Signed-off-by: Xiao Guangrong <xiaoguangrong@cn.fujitsu.com>
Acked-by: Gleb Natapov <gleb@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
Fixes this:
CC arch/s390/kvm/../../../virt/kvm/kvm_main.o
arch/s390/kvm/../../../virt/kvm/kvm_main.c: In function 'kvm_clear_guest_page':
arch/s390/kvm/../../../virt/kvm/kvm_main.c:1224:2: warning: passing argument 3 of 'kvm_write_guest_page' makes pointer from integer without a cast
arch/s390/kvm/../../../virt/kvm/kvm_main.c:1185:5: note: expected 'const void *' but argument is of type 'long unsigned int'
Signed-off-by: Heiko Carstens <heiko.carstens@de.ibm.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
Currently we are using vmalloc() for all dirty bitmaps even if
they are small enough, say less than K bytes.
We use kmalloc() if dirty bitmap size is less than or equal to
PAGE_SIZE so that we can avoid vmalloc area usage for VGA.
This will also make the logging start/stop faster.
Signed-off-by: Takuya Yoshikawa <yoshikawa.takuya@oss.ntt.co.jp>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
Currently x86's kvm_vm_ioctl_get_dirty_log() needs to allocate a bitmap by
vmalloc() which will be used in the next logging and this has been causing
bad effect to VGA and live-migration: vmalloc() consumes extra systime,
triggers tlb flush, etc.
This patch resolves this issue by pre-allocating one more bitmap and switching
between two bitmaps during dirty logging.
Performance improvement:
I measured performance for the case of VGA update by trace-cmd.
The result was 1.5 times faster than the original one.
In the case of live migration, the improvement ratio depends on the workload
and the guest memory size. In general, the larger the memory size is the more
benefits we get.
Note:
This does not change other architectures's logic but the allocation size
becomes twice. This will increase the actual memory consumption only when
the new size changes the number of pages allocated by vmalloc().
Signed-off-by: Takuya Yoshikawa <yoshikawa.takuya@oss.ntt.co.jp>
Signed-off-by: Fernando Luis Vazquez Cao <fernando@oss.ntt.co.jp>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
As suggested by Andrea, pass r/w error code to gup(), upgrading read fault
to writable if host pte allows it.
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
Signed-off-by: Avi Kivity <avi@redhat.com>
