Perform a pci_claim_resource() on all valid resources discovered
during the OF device tree scan.
Based almost entirely upon the PCI OF bus probing code which does
the same thing there.
Signed-off-by: David S. Miller <davem@davemloft.net>
It seems that when a PCI Express bridge is not in use and has no devices
behind it, the ranges property is bogus. Specifically the size property
is of the form [0xffffffff:...], and if you add this size to the resource
start address the 64-bit calculation will overflow.
Just check specifically for this size value signature and skip them.
Signed-off-by: David S. Miller <davem@davemloft.net>
Dump the various aspects of the PCI bridge probed at boot time, most
importantly the bridge number ranges, and the ranges property.
This helps diagnose PCI resource issues and other problems by giving
ofpci_debug=1 on the boot command line.
Signed-off-by: David S. Miller <davem@davemloft.net>
Christopher reports that perf_event_print_debug() can crash in uniprocessor
builds. The crash is due to pcr_ops being NULL.
This happens because pcr_arch_init() is only invoked by smp_cpus_done() which
only executes in SMP builds.
init_hw_perf_events() is closely intertwined with pcr_ops being setup properly,
therefore:
1) Call pcr_arch_init() early on from init_hw_perf_events(), instead of
from smp_cpus_done().
2) Do not hook up a PMU type if pcr_ops is NULL after pcr_arch_init().
3) Move init_hw_perf_events to a later initcall so that it we will be
sure to invoke pcr_arch_init() after all cpus are brought up.
Finally, guard the one naked sequence of pcr_ops dereferences in
__global_pmu_self() with an appropriate NULL check.
Reported-by: Christopher Alexander Tobias Schulze <cat.schulze@alice-dsl.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
nmi_cpu_busy() is a SMP function call that just makes sure that all of the
cpus are spinning using cpu cycles while the NMI test runs.
It does not need to disable IRQs because we just care about NMIs executing
which will even with 'normal' IRQs disabled.
It is not legal to enable hard IRQs in a SMP cross call, in fact this bug
triggers the BUG check in irq_work_run_list():
BUG_ON(!irqs_disabled());
Because now irq_work_run() is invoked from the tail of
generic_smp_call_function_single_interrupt().
Signed-off-by: David S. Miller <davem@davemloft.net>
The prefix suggests the number should be printed in hex, so use
the %x specifier to do that.
Found by using regex suggested by Joe Perches.
Signed-off-by: Hans Wennborg <hans@hanshq.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
The LDC handshake could have been asynchronously triggered
after ldc_bind() enables the ldc_rx() receive interrupt-handler
(and thus intercepts incoming control packets)
and before vio_port_up() calls ldc_connect(). If that is the case,
ldc_connect() should return 0 and let the state-machine
progress.
Signed-off-by: Sowmini Varadhan <sowmini.varadhan@oracle.com>
Acked-by: Karl Volz <karl.volz@oracle.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
/dev/mdesc on Linux does not support reading arbitrary number
of bytes and seeking while /dev/mdesc on Solaris does. This
causes tools that work on Solaris to break on Linux. This patch
adds these two capabilities to /dev/mdesc.
Signed-off-by: Khalid Aziz <khalid.aziz@oracle.com>
Acked-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
Since unaligned_panic() takes a literal string, make sure it can never
accidentally be used as a format string.
Signed-off-by: Kees Cook <keescook@chromium.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
Sometimes it is preferred not to use the trigger_all_cpu_backtrace()
routine when one wants to avoid capturing a back trace for current. For
instance if one was previously captured recently.
This patch provides a new routine namely
trigger_allbutself_cpu_backtrace() which offers the flexibility to issue
an NMI to every cpu but current and capture a back trace accordingly.
Patch x86 and sparc to support new routine.
[dzickus@redhat.com: add stub in #else clause]
[dzickus@redhat.com: don't print message in single processor case, wrap with get/put_cpu based on Oleg's suggestion]
[sfr@canb.auug.org.au: undo C99ism]
Signed-off-by: Aaron Tomlin <atomlin@redhat.com>
Signed-off-by: Don Zickus <dzickus@redhat.com>
Acked-by: David S. Miller <davem@davemloft.net>
Cc: Mateusz Guzik <mguzik@redhat.com>
Cc: Oleg Nesterov <oleg@redhat.com>
Signed-off-by: Stephen Rothwell <sfr@canb.auug.org.au>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
Use pci_is_bridge() to simplify code. No functional change.
Requires: 326c1cdae7 PCI: Rename pci_is_bridge() to pci_has_subordinate()
Requires: 1c86438c94 PCI: Add new pci_is_bridge() interface
Signed-off-by: Yijing Wang <wangyijing@huawei.com>
Signed-off-by: Bjorn Helgaas <bhelgaas@google.com>
Acked-by: David S. Miller <davem@davemloft.net>
Fix following warnings:
kgdb_64.c:114:18: warning: symbol 'smp_kgdb_capture_client' was not declared. Should it be static?
kgdb_64.c:161:17: warning: symbol 'kgdb_trap' was not declared. Should it be static?
Add proper prototypes
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
Fix following warnings:
compat_audit.c:4:10: warning: symbol 'sparc32_dir_class' was not declared. Should it be static?
compat_audit.c:9:10: warning: symbol 'sparc32_chattr_class' was not declared. Should it be static?
compat_audit.c:14:10: warning: symbol 'sparc32_write_class' was not declared. Should it be static?
compat_audit.c:19:10: warning: symbol 'sparc32_read_class' was not declared. Should it be static?
compat_audit.c:24:10: warning: symbol 'sparc32_signal_class' was not declared. Should it be static?
compat_audit.c:29:5: warning: symbol 'sparc32_classify_syscall' was not declared. Should it be static?
Add declarations to kernel.h
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
Fix following warnings:
init_64.c:191:10: warning: symbol 'dcpage_flushes' was not declared. Should it be static?
init_64.c:193:10: warning: symbol 'dcpage_flushes_xcall' was not declared. Should it be static?
Add extern declaration to asm/setup.h and drop local declaration in smp_64.h
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
Fix following warnings:
smp_32.c:177:5: warning: symbol 'setup_profiling_timer' was not declared. Should it be static?
smp_64.c:1202:5: warning: symbol 'setup_profiling_timer' was not declared. Should it be static?
smp_64.c:989:6: warning: symbol 'kgdb_roundup_cpus' was not declared. Should it be static?
Add prototype to include/linux/profile.h of setup_profiling_timer
Add missing include to smp_64.c
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
Fix following sparse warnings:
kernel/perf_event.c:113:1: warning: symbol 'cpu_hw_events' was not declared. Should it be static?
kernel/perf_event.c:1156:6: warning: symbol 'perf_event_grab_pmc' was not declared. Should it be static?
kernel/perf_event.c:1172:6: warning: symbol 'perf_event_release_pmc' was not declared. Should it be static?
kernel/perf_event.c:1672:12: warning: symbol 'init_hw_perf_events' was not declared. Should it be static?
kernel/perf_event.c:1749:52: warning: incorrect type in argument 2 (different address spaces)
kernel/perf_event.c:1772:60: warning: incorrect type in argument 2 (different address spaces)
kernel/perf_event.c:1779:60: warning: incorrect type in argument 2 (different address spaces)
Define the functions static as they are not used outside this file.
Fix it so copy_from_user are supplied with pointers annotated _user
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
Fix following warnings:
kprobes.c:515:15: warning: symbol 'trampoline_probe_handler' was not declared. Should it be static?
kprobes.c:579:6: warning: symbol 'kretprobe_trampoline_holder' was not declared. Should it be static?
Declare the functions static.
kretprobe_trampoline_holder is magically used without any real
reference so mark is __used, like other arch's do too.
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
Use compat_sigset_t rather than opencode the array
Drop "switch (_NSIG_WORDS)" as we know this is always 1
Introduce BUILD_BUG_ON() to catch if this changes
As a side-effect of this fix following sparse warnings:
signal32.c:220:60: warning: invalid access past the end of 'seta' (12 8)
signal32.c:220:42: warning: invalid access past the end of 'seta' (8 8)
signal32.c:219:60: warning: invalid access past the end of 'seta' (20 8)
signal32.c:219:42: warning: invalid access past the end of 'seta' (16 8)
signal32.c:218:60: warning: invalid access past the end of 'seta' (28 8)
signal32.c:218:42: warning: invalid access past the end of 'seta' (24 8)
signal32.c:309:68: warning: invalid access past the end of 'seta' (12 8)
signal32.c:309:46: warning: invalid access past the end of 'seta' (8 8)
signal32.c:308:68: warning: invalid access past the end of 'seta' (20 8)
signal32.c:308:46: warning: invalid access past the end of 'seta' (16 8)
signal32.c:307:68: warning: invalid access past the end of 'seta' (28 8)
signal32.c:307:46: warning: invalid access past the end of 'seta' (24 8)
They all pointed to code that was never executed - so no bugs fixed.
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
