I'm testing glibc on MIPS64, little-endian, N32, O32 and N64 multilibs.
Among the NPTL test failures seen are some arising from sigsuspend problems
for N32: it blocks the wrong signals, so SIGCANCEL (SIGRTMIN) is blocked
despite glibc's carefully excluding it from sets of signals to block.
Specifically, testing suggests it blocks signal N^32 instead of signal N,
so (in the example tested) blocking SIGUSR1 (17) blocks signal 49 instead.
glibc's sigset_t uses an array of unsigned long, as does the kernel.
In both cases, signal N+1 is represented as
(1UL << (N % (8 * sizeof (unsigned long)))) in word number
(N / (8 * sizeof (unsigned long))).
Thus the N32 glibc uses an array of 32-bit words and the N64 kernel uses an
array of 64-bit words. For little-endian, the layout is the same, with
signals 1-32 in the first 4 bytes, signals 33-64 in the second, etc.; for
big-endian, userspace has that layout while in the kernel each 8 bytes have
the two halves swapped from the userspace layout.
The N32 sigsuspend syscall uses sigset_from_compat to convert the userspace
sigset to kernel format. If __COMPAT_ENDIAN_SWAP__ is *not* set, this uses
logic of the form
set->sig[0] = compat->sig[0] | (((long)compat->sig[1]) << 32 )
to convert the userspace sigset to a kernel one. This looks correct to me
for both big and little endian, given that in userspace compat->sig[1] will
represent signals 33-64, and so will the high 32 bits of set->sig[0] in the
kernel. If however __COMPAT_ENDIAN_SWAP__ *is* set, as it is for
__MIPSEL__, it uses
set->sig[0] = compat->sig[1] | (((long)compat->sig[0]) << 32 );
which seems incorrect for both big and little endian, and would
explain the observed symptoms.
This code is the only use of __COMPAT_ENDIAN_SWAP__, so if incorrect
then that macro serves no purpose, in which case something like the
following patch would seem appropriate to remove it.
Signed-off-by: Joseph Myers <joseph@codesourcery.com>
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
Cc: Arnd Bergmann <arnd@arndb.de>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Currently, enabling/disabling printk timestamps is only possible through
reboot (bootparam) or recompile. I normally do not run with timestamps
(since syslog handles that in a good manner), but for measuring small
kernel delays (e.g. irq probing - see parport thread) I needed subsecond
precision, but then again, just for some minutes rather than all kernel
messages to come. The following patch adds a module_param() with which the
timestamps can be en-/disabled in a live system through
/sys/modules/printk/parameters/printk_time.
Signed-off-by: Jan Engelhardt <jengelh@gmx.de>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
copy_process() appears to be the only caller of acct_clear_integrals() and
does not pass in NULL task pointers. Remove the unecessary check.
Signed-off-by: Matt Helsley <matthltc@us.ibm.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
schedule_on_each_cpu() presently does a large kmalloc - 96 kbytes on 1024 CPU
64-bit.
Rework it so that we do one 8192-byte allocation and then a pile of tiny ones,
via alloc_percpu(). This has a much higher chance of success (100% in the
current VM).
This also has the effect of reducing the memory requirements from NR_CPUS*n to
num_possible_cpus()*n.
Cc: Christoph Lameter <clameter@engr.sgi.com>
Cc: Andi Kleen <ak@muc.de>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
- proper prototypes for the following functions:
- ctrl_alt_del() (in include/linux/reboot.h)
- getrusage() (in include/linux/resource.h)
- make the following needlessly global functions static:
- kernel_restart_prepare()
- kernel_kexec()
[akpm@osdl.org: compile fix]
Signed-off-by: Adrian Bunk <bunk@stusta.de>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Currently printk is no use for early debugging because it refuses to
actually print anything to the console unless
cpu_online(smp_processor_id()) is true.
The stated explanation is that console drivers may require per-cpu
resources, or otherwise barf, because the system is not yet setup
correctly. Fair enough.
However some console drivers might be quite happy running early during
boot, in fact we have one, and so it'd be nice if printk understood that.
So I added a flag (which I would have called CON_BOOT, but that's taken)
called CON_ANYTIME, which indicates that a console is happy to be called
anytime, even if the cpu is not yet online.
Tested on a Power 5 machine, with both a CON_ANYTIME driver and a bogus
console driver that BUG()s if called while offline. No problems AFAICT.
Built for i386 UP & SMP.
Signed-off-by: Michael Ellerman <michael@ellerman.id.au>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Since raw_notifier chains don't benefit from any centralized locking
protections, they shouldn't suffer from the associated limitations. Under
some circumstances it might make sense for a raw_notifier callout routine
to unregister itself from the notifier chain. This patch (as678) changes
the notifier core to allow for such things.
Signed-off-by: Alan Stern <stern@rowland.harvard.edu>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
There are several instances of per_cpu(foo, raw_smp_processor_id()), which
is semantically equivalent to __get_cpu_var(foo) but without the warning
that smp_processor_id() can give if CONFIG_DEBUG_PREEMPT is enabled. For
those architectures with optimized per-cpu implementations, namely ia64,
powerpc, s390, sparc64 and x86_64, per_cpu() turns into more and slower
code than __get_cpu_var(), so it would be preferable to use __get_cpu_var
on those platforms.
This defines a __raw_get_cpu_var(x) macro which turns into per_cpu(x,
raw_smp_processor_id()) on architectures that use the generic per-cpu
implementation, and turns into __get_cpu_var(x) on the architectures that
have an optimized per-cpu implementation.
Signed-off-by: Paul Mackerras <paulus@samba.org>
Acked-by: David S. Miller <davem@davemloft.net>
Acked-by: Ingo Molnar <mingo@elte.hu>
Acked-by: Martin Schwidefsky <schwidefsky@de.ibm.com>
Cc: Rusty Russell <rusty@rustcorp.com.au>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
If CONFIG_KALLSYMS is defined and if it should happen that is_exported() is
given a NULL 'mod' and lookup_symbol(name, __start___ksymtab,
__stop___ksymtab) returns 0, then we'll end up dereferencing a NULL
pointer.
Signed-off-by: Jesper Juhl <jesper.juhl@gmail.com>
Cc: Rusty Russell <rusty@rustcorp.com.au>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Considering that there isn't a lot of hw we can depend on during resume,
this is about as good as it gets.
This is x86-only for now, although the basic concept (and most of the
code) will certainly work on almost any platform.
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
list_splice_init(list, head) does unneeded job if it is known that
list_empty(head) == 1. We can use list_replace_init() instead.
Signed-off-by: Oleg Nesterov <oleg@tv-sign.ru>
Acked-by: David S. Miller <davem@davemloft.net>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
kernel/sys.c doesn't have anything in it relying on linux/init.h -
remove the include.
Signed-off-by: Jes Sorensen <jes@sgi.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
If you get to that point in the code it means that desc->move_irq is set,
pending_irq_cpumask[irq] and cpu_online_map should have a value. Still
pretty good chance anding those two you'll still have a value. So these
two branch predictors should be inverted.
Signed-off-by: Daniel Walker <dwalker@mvista.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
add the __might_sleep() check back to cond_resched().
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Set errorp in dup_fd, it will be used in sys_unshare also.
Signed-off-by: Prasanna Meda <mlp@google.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
exit_aio() and exit_mmap() can sleep. But it's easy to accidentally call
mmput() from inside locks.
Cc: Dave Peterson <dsp@llnl.gov>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
