This patch
* removes setting t_RTO in ccid3_hc_tx_init (per [RFC 3448, 4.2], t_RTO is
undefined until feedback has been received);
* makes some trivial changes (updates of comments);
* performs a small optimisation by exploiting that the feedback timeout
uses the value of t_ipi. The way it is done is safe, because the timeouts
appear after the changes to t_ipi, ensuring that up-to-date values are used;
* in ccid3_hc_tx_packet_recv, moves the t_rto statement closer to the calculation
of the next_tmout. This makes the code clearer to read and is also safe, since
t_rto is not updated until the next call of ccid3_hc_tx_packet_recv, and is not
read by the functions called via ccid_wait_for_ccid();
* removes a `max' statement in sk_reset_timer, this is not needed since the timeout
value is always greater than 1E6 microseconds.
* adds `XXX'es to highlight that currently the nofeedback timer is set
in a non-standard way
Signed-off-by: Gerrit Renker <gerrit@erg.abdn.ac.uk>
Acked-by: Ian McDonald <ian.mcdonald@jandi.co.nz>
Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>
This patch:
* consolidates updating of parameters (t_nom, t_ipi, t_delta) which
need to be updated at the same time, since they are inter-dependent
* removes two inline functions which are no longer needed as a result of
the above consolidation
* resolves a FIXME regarding the re-calculation of t_ipi within the nofeedback
timer, in the state where no feedback has previously been received
* ties updating these parameters to updating the sending rate X, exploiting
that all three parameters in turn depend on X; and using a small optimisation
which can reduce the number of required instructions: only update the three
parameters when X really changes
Signed-off-by: Gerrit Renker <gerrit@erg.abdn.ac.uk>
Acked-by: Ian McDonald <ian.mcdonald@jandi.co.nz>
Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>
This patch concerns updating the value of the nofeedback timer when no feedback
has been received so far.
Since in this case the value of R is still undefined according to [RFC 3448,
4.2], we can not perform step (3) of [RFC 3448, 4.3]. A clarification is
provided in [RFC 4342, sec. 5], which states that in these cases the nofeedback
timer (still) expires "after two seconds".
Many thanks to Ian McDonald for pointing this out and providing the
clarification.
The patch
* implements [RFC 4342, sec. 5] with regard to the above case
* consolidates handling timer restart by
- adding an appropriate jump label and
- initialising the timeout value
Acked-by: Ian McDonald <ian.mcdonald@jandi.co.nz>
Signed-off-by: Gerrit Renker <gerrit@erg.abdn.ac.uk>
Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>
Might as well make flush notifier prettier when subpolicy used
Signed-off-by: Jamal Hadi Salim <hadi@cyberus.ca>
Signed-off-by: David S. Miller <davem@davemloft.net>
This patch consolidates set/getsockopt code between UDP(-Lite) v4 and 6. The
justification is that UDP(-Lite) is a transport-layer protocol and therefore
the socket option code (at least in theory) should be AF-independent.
Furthermore, there is the following code reduplication:
* do_udp{,v6}_getsockopt is 100% identical between v4 and v6
* do_udp{,v6}_setsockopt is identical up to the following differerence
--v4 in contrast to v4 additionally allows the experimental encapsulation
types UDP_ENCAP_ESPINUDP and UDP_ENCAP_ESPINUDP_NON_IKE
--the remainder is identical between v4 and v6
I believe that this difference is of little relevance.
The advantages in not duplicating twice almost completely identical code.
The patch further simplifies the interface of udp{,v6}_push_pending_frames,
since for the second argument (struct udp_sock *up) it always holds that
up = udp_sk(sk); where sk is the first function argument.
Signed-off-by: Gerrit Renker <gerrit@erg.abdn.ac.uk>
Signed-off-by: David S. Miller <davem@davemloft.net>
IPv4, IPv6, and DECNet all use struct rta_cacheinfo in a similiar
way, therefore rtnl_put_cacheinfo() is added to reuse code.
Signed-off-by: Thomas Graf <tgraf@suug.ch>
Signed-off-by: David S. Miller <davem@davemloft.net>
The destination PID is passed directly to netlink_unicast()
respectively netlink_multicast().
Signed-off-by: Thomas Graf <tgraf@suug.ch>
Signed-off-by: David S. Miller <davem@davemloft.net>
This considers the case - ACK received while no packet has been sent
so far. Resolved by printing a (rate-limited) warning message.
Further removes an unnecessary BUG_ON in ccid3_hc_tx_packet_recv,
received feedback on a terminating connection is simply ignored.
Signed-off-by: Gerrit Renker <gerrit@erg.abdn.ac.uk>
Signed-off-by: Ian McDonald <ian.mcdonald@jandi.co.nz>
Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>
This patch removes a switch statement which is redundant since,
* nothing is done in states TFRC_SSTATE_NO_SENT/TFRC_SSTATE_NO_FBACK
* it is impossible that the function is called in the state TFRC_SSTATE_TERM, since
--the function is called, in dccp_write_xmit, after ccid3_hc_tx_send_packet
--if ccid3_hc_tx_send_packet is called in state TFRC_SSTATE_TERM, it returns
-EINVAL, which means that ccid3_hc_tx_packet_sent will not be called
(compare dccp_write_xmit)
--> therefore, this case is logically impossible
* the remaining state is TFRC_SSTATE_FBACK which conditionally updates t_ipi, t_nom,
and t_delta. This is a no-op, since
--t_ipi only changes when feedback is received
--however, when feedback arrives via ccid3_hc_tx_packet_recv, there is an identical
code block which performs the same set of operations
--performing the same set of operations again in ccid3_hc_tx_packet_sent therefore
does not change anything, since between the time of receiving the last feedback
(and therefore update of t_ipi, t_nom, and t_delta), the value of t_ipi has not
changed
--since t_ipi has not changed, the values of t_delta and t_nom also do not change,
they depend fully on t_ipi
Signed-off-by: Gerrit Renker <gerrit@erg.abdn.ac.uk>
Acked-by: Ian McDonald <ian.mcdonald@jandi.co.nz>
Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>
This resolves an `XXX' in ccid3_hc_tx_send_packet().
The function is only called on Data and DataAck packets and returns a negative
result on zero-sized messages. This is a reasonable policy since CCID 3 is a
congestion-control module and congestion control on zero-sized Data(Ack)
packets is in a way pathological.
The patch uses a more suitable error code for this case, it returns the Posix.1
code `EBADMSG' ("Not a data message") instead of `ENOTCONN'.
As a result of ignoring zero-sized packets, a the condition for a warning
"First packet is data" in ccid3_hc_tx_packet_sent is always satisfied; this
message has been removed since it will always be printed.
Signed-off-by: Gerrit Renker <gerrit@erg.abdn.ac.uk>
Signed-off-by: Ian McDonald <ian.mcdonald@jandi.co.nz>
Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>
This makes some logically equivalent simplifications, by replacing
rc - values plus goto's with direct return statements.
Signed-off-by: Gerrit Renker <gerrit@erg.abdn.ac.uk>
Signed-off-by: Ian McDonald <ian.mcdonald@jandi.co.nz>
Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>
This patch performs a simplifying (performance) optimisation:
In each call of the inline function ccid3_calc_new_t_ipi(), the state is
tested against TFRC_SSTATE_NO_FBACK. This is expensive when the function
is called very often. A simpler solution, implemented by this patch, is
to adapt the control flow.
Background:
Now that we can stuff bigger ack vectors into options.
Signed-off-by: Andrea Bittau <a.bittau@cs.ucl.ac.uk>
Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>
Ack vectors grow proportional to the window size. If an ack vector does not fit
into a single option, it must be spread across multiple options. This patch
will allow for windows to grow larger.
Committer note: Simplified the patch a bit, original algorithm kept.
Signed-off-by: Andrea Bittau <a.bittau@cs.ucl.ac.uk>
Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>
Commiter note:
This was split from Andrea's original patch, in the process I changed the type
of the ackvec index fields to u16 instead of to int and haven't folded
dccp_ackvec_parse with dccp_ackvec_check_rcv_ackno.
Next patch will actually do the insertion of more than one ackvec per packet,
using, initially, up to a max of 2 ackvecs as per Andrea's original patch, then
I'll work on support for larger ackvecs, be it using a sysctl or using
setsockopt.
Signed-off-by: Andrea Bittau <a.bittau@cs.ucl.ac.uk>
Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>
Commiter note: original patch was splitted.
Signed-off-by: Andrea Bittau <a.bittau@cs.ucl.ac.uk>
Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>
Extends the netlink interface to support the __le16 type and
converts address addition, deletion and, dumping to use the
new netlink interface.
Fixes multiple occasions of possible illegal memory references
due to not validated netlink attributes.
Signed-off-by: Thomas Graf <tgraf@suug.ch>
Signed-off-by: David S. Miller <davem@davemloft.net>
Log an error if the remote tunnel endpoint is unable to handle
tunneled packets.
Signed-off-by: Ville Nuorvala <vnuorval@tcs.hut.fi>
Signed-off-by: David S. Miller <davem@davemloft.net>
Allow link-local tunnel endpoints if the underlying link is defined.
Signed-off-by: Ville Nuorvala <vnuorval@tcs.hut.fi>
Signed-off-by: David S. Miller <davem@davemloft.net>
