gred_dequeue() and gred_drop() do not seem to get called when the
queue is empty, meaning that we never start idling while in WRED
mode. And since qidlestart is not stored by gred_store_wred_set(),
we would never stop idling while in WRED mode if we ever started.
This messes up the average queue size calculation that influences
packet marking/dropping behavior.
Now, we start WRED mode idling as we are removing the last packet
from the queue. Also we now actually stop WRED mode idling when we
are enqueuing a packet.
Cc: Bruce Osler <brosler@cisco.com>
Signed-off-by: David Ward <david.ward@ll.mit.edu>
Acked-by: Jamal Hadi Salim <jhs@mojatatu.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
q->vars.qavg is a Wlog scaled value, but q->backlog is not. In order
to pass q->vars.qavg as the backlog value, we need to un-scale it.
Additionally, the qave value returned via netlink should not be Wlog
scaled, so we need to un-scale the result of red_calc_qavg().
This caused artificially high values for "Average Queue" to be shown
by 'tc -s -d qdisc', but did not affect the actual operation of GRED.
Signed-off-by: David Ward <david.ward@ll.mit.edu>
Acked-by: Jamal Hadi Salim <jhs@mojatatu.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Each pair of DPs only needs to be compared once when searching for
a non-unique prio value.
Signed-off-by: David Ward <david.ward@ll.mit.edu>
Acked-by: Jamal Hadi Salim <jhs@mojatatu.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Its possible to setup a bad cbq configuration leading to
an infinite loop in cbq_classify()
DEV_OUT=eth0
ICMP="match ip protocol 1 0xff"
U32="protocol ip u32"
DST="match ip dst"
tc qdisc add dev $DEV_OUT root handle 1: cbq avpkt 1000 \
bandwidth 100mbit
tc class add dev $DEV_OUT parent 1: classid 1:1 cbq \
rate 512kbit allot 1500 prio 5 bounded isolated
tc filter add dev $DEV_OUT parent 1: prio 3 $U32 \
$ICMP $DST 192.168.3.234 flowid 1:
Reported-by: Denys Fedoryschenko <denys@visp.net.lb>
Tested-by: Denys Fedoryschenko <denys@visp.net.lb>
Signed-off-by: Eric Dumazet <edumazet@google.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
When fq_codel builds a new flow, it should not reset codel state.
Codel algo needs to get previous values (lastcount, drop_next) to get
proper behavior.
Signed-off-by: Dave Taht <dave.taht@gmail.com>
Signed-off-by: Eric Dumazet <edumazet@google.com>
Acked-by: Dave Taht <dave.taht@bufferbloat.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
We drop packet unconditionally when we fail to mirror it. This is not intended
in some cases. Consdier for kvm guest, we may mirror the traffic of the bridge
to a tap device used by a VM. When kernel fails to mirror the packet in
conditions such as when qemu crashes or stop polling the tap, it's hard for the
management software to detect such condition and clean the the mirroring
before. This would lead all packets to the bridge to be dropped and break the
netowrk of other virtual machines.
To solve the issue, the patch does not drop packets when kernel fails to mirror
it, and only drop the redirected packets.
Signed-off-by: Jason Wang <jasowang@redhat.com>
Signed-off-by: Jamal Hadi Salim <jhs@mojatatu.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
[Resending again, as the text was corrupted by the email client]
To speed up operations, QFQ internally divides classes into
groups. Which group a class belongs to depends on the ratio between
the maximum packet length and the weight of the class. Unfortunately
the function qfq_change_class lacks the steps for changing the group
of a class when the ratio max_pkt_len/weight of the class changes.
For example, when the last of the following three commands is
executed, the group of class 1:1 is not correctly changed:
tc disc add dev XXX root handle 1: qfq
tc class add dev XXX parent 1: qfq classid 1:1 weight 1
tc class change dev XXX parent 1: classid 1:1 qfq weight 4
Not changing the group of a class does not affect the long-term
bandwidth guaranteed to the class, as the latter is independent of the
maximum packet length, and correctly changes (only) if the weight of
the class changes. In contrast, if the group of the class is not
updated, the class is still guaranteed the short-term bandwidth and
packet delay related to its old group, instead of the guarantees that
it should receive according to its new weight and/or maximum packet
length. This may also break service guarantees for other classes.
This patch adds the missing operations.
Signed-off-by: Paolo Valente <paolo.valente@unimore.it>
Signed-off-by: David S. Miller <davem@davemloft.net>
Some action modules free struct tcf_common in their error path
while estimator is still active. This results in est_timer()
dereference freed memory.
Add gen_kill_estimator() in ipt, pedit and simple action.
Signed-off-by: Hiroaki SHIMODA <shimoda.hiroaki@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
gact_rand array is accessed by gact->tcfg_ptype whose value
is assumed to less than MAX_RAND, but any range checks are
not performed.
So add a check in tcf_gact_init(). And in tcf_gact(), we can
reduce a branch.
Signed-off-by: Hiroaki SHIMODA <shimoda.hiroaki@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Use inet_iif() consistently, and for TCP record the input interface of
cached RX dst in inet sock.
rt->rt_iif is going to be encoded differently, so that we can
legitimately cache input routes in the FIB info more aggressively.
When the input interface is "use SKB device index" the rt->rt_iif will
be set to zero.
This forces us to move the TCP RX dst cache installation into the ipv4
specific code, and as well it should since doing the route caching for
ipv6 is pointless at the moment since it is not inspected in the ipv6
input paths yet.
Also, remove the unlikely on dst->obsolete, all ipv4 dsts have
obsolete set to a non-zero value to force invocation of the check
callback.
Signed-off-by: David S. Miller <davem@davemloft.net>
netem does an early orphaning of skbs. Doing so breaks TCP Small Queue
or any mechanism relying on socket sk_wmem_alloc feedback.
Ideally, we should perform this orphaning after the rate module and
before the delay module, to mimic what happens on a real link :
skb orphaning is indeed normally done at TX completion, before the
transit on the link.
+-------+ +--------+ +---------------+ +-----------------+
+ Qdisc +---> Device +--> TX completion +--> links / hops +->
+ + + xmit + + skb orphaning + + propagation +
+-------+ +--------+ +---------------+ +-----------------+
< rate limiting > < delay, drops, reorders >
If netem is used without delay feature (drops, reorders, rate
limiting), then we should avoid early skb orphaning, to keep pressure
on sockets as long as packets are still in qdisc queue.
Ideally, netem should be refactored to implement delay module
as the last stage. Current algorithm merges the two phases
(rate limiting + delay) so its not correct.
Signed-off-by: Eric Dumazet <edumazet@google.com>
Cc: Hagen Paul Pfeifer <hagen@jauu.net>
Cc: Mark Gordon <msg@google.com>
Cc: Andreas Terzis <aterzis@google.com>
Cc: Yuchung Cheng <ycheng@google.com>
Acked-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Can be used to match packets against netfilter ip sets created via ipset(8).
skb->sk_iif is used as 'incoming interface', skb->dev is 'outgoing interface'.
Since ipset is usually called from netfilter, the ematch
initializes a fake xt_action_param, pulls the ip header into the
linear area and also sets skb->data to the IP header (otherwise
matching Layer 4 set types doesn't work).
Tested-by: Mr Dash Four <mr.dash.four@googlemail.com>
Signed-off-by: Florian Westphal <fw@strlen.de>
Signed-off-by: David S. Miller <davem@davemloft.net>
Conflicts:
net/batman-adv/bridge_loop_avoidance.c
net/batman-adv/bridge_loop_avoidance.h
net/batman-adv/soft-interface.c
net/mac80211/mlme.c
With merge help from Antonio Quartulli (batman-adv) and
Stephen Rothwell (drivers/net/usb/qmi_wwan.c).
The net/mac80211/mlme.c conflict seemed easy enough, accounting for a
conversion to some new tracing macros.
Signed-off-by: David S. Miller <davem@davemloft.net>
Fix two netem bugs :
1) When a frame was dropped by tfifo_enqueue(), drop counter
was incremented twice.
2) When reordering is triggered, we enqueue a packet without
checking queue limit. This can OOM pretty fast when this
is repeated enough, since skbs are orphaned, no socket limit
can help in this situation.
Signed-off-by: Eric Dumazet <edumazet@google.com>
Cc: Mark Gordon <msg@google.com>
Cc: Andreas Terzis <aterzis@google.com>
Cc: Yuchung Cheng <ycheng@google.com>
Cc: Hagen Paul Pfeifer <hagen@jauu.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
This ematch makes it possible to classify CAN frames (AF_CAN) according
to their identifiers. This functionality can not be easily achieved with
existing classifiers, such as u32, because CAN identifier is always stored
in native endianness, whereas u32 expects Network byte order.
Signed-off-by: Rostislav Lisovy <lisovy@gmail.com>
Signed-off-by: Oliver Hartkopp <socketcan@hartkopp.net>
Signed-off-by: Marc Kleine-Budde <mkl@pengutronix.de>
sockfd_lookup() is declared in linux/net.h, which is pulled by
linux/skbuff.h (and needed for a lot of other stuff in sch_atm.c
anyway).
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
Pull cgroup updates from Tejun Heo:
"cgroup file type addition / removal is updated so that file types are
added and removed instead of individual files so that dynamic file
type addition / removal can be implemented by cgroup and used by
controllers. blkio controller changes which will come through block
tree are dependent on this. Other changes include res_counter cleanup
and disallowing kthread / PF_THREAD_BOUND threads to be attached to
non-root cgroups.
There's a reported bug with the file type addition / removal handling
which can lead to oops on cgroup umount. The issue is being looked
into. It shouldn't cause problems for most setups and isn't a
security concern."
Fix up trivial conflict in Documentation/feature-removal-schedule.txt
* 'for-3.5' of git://git.kernel.org/pub/scm/linux/kernel/git/tj/cgroup: (21 commits)
res_counter: Account max_usage when calling res_counter_charge_nofail()
res_counter: Merge res_counter_charge and res_counter_charge_nofail
cgroups: disallow attaching kthreadd or PF_THREAD_BOUND threads
cgroup: remove cgroup_subsys->populate()
cgroup: get rid of populate for memcg
cgroup: pass struct mem_cgroup instead of struct cgroup to socket memcg
cgroup: make css->refcnt clearing on cgroup removal optional
cgroup: use negative bias on css->refcnt to block css_tryget()
cgroup: implement cgroup_rm_cftypes()
cgroup: introduce struct cfent
cgroup: relocate __d_cgrp() and __d_cft()
cgroup: remove cgroup_add_file[s]()
cgroup: convert memcg controller to the new cftype interface
memcg: always create memsw files if CONFIG_CGROUP_MEM_RES_CTLR_SWAP
cgroup: convert all non-memcg controllers to the new cftype interface
cgroup: relocate cftype and cgroup_subsys definitions in controllers
cgroup: merge cft_release_agent cftype array into the base files array
cgroup: implement cgroup_add_cftypes() and friends
cgroup: build list of all cgroups under a given cgroupfs_root
cgroup: move cgroup_clear_directory() call out of cgroup_populate_dir()
...
David Ward
Eric Dumazet
Eric Dumazet
Jason Wang
Paolo Valente
Hiroaki SHIMODA
David S. Miller
Alan Cox
Florian Westphal
Rostislav Lisovy
Al Viro
Linus Torvalds