Add support for the 15'' MacBook Pro Retina. The keyboard is
the same as recent models.
The patch needs to be synchronized with the bcm5974 patch for
the trackpad - as usual.
Patch originally written by clipcarl (forums.opensuse.org).
[rydberg@euromail.se: Amended mouse ignore lines]
Signed-off-by: Ryan Bourgeois <bluedragonx@gmail.com>
Signed-off-by: Henrik Rydberg <rydberg@euromail.se>
Acked-by: Jiri Kosina <jkosina@suse.cz>
Signed-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com>
Pull media updates from Mauro Carvalho Chehab:
- V4L2 API additions to better support JPEG compression control
- media API additions to properly support MPEG decoders
- V4L2 API additions for image crop/scaling
- a few other V4L2 API DocBook fixes/improvements
- two new DVB frontend drivers: m88rs2000 and rtl2830
- two new DVB drivers: az6007 and rtl28xxu
- a framework for ISA drivers, that removed lots of common code found
at the ISA radio drivers
- a new FM transmitter driver (radio-keene)
- a GPIO-based IR receiver driver
- a new sensor driver: mt9m032
- some new video drivers: adv7183, blackfin, mx2_emmaprp, sii9234_drv,
vs6624
- several new board additions, driver fixes, improvements and cleanups.
* 'v4l_for_linus' of git://git.kernel.org/pub/scm/linux/kernel/git/mchehab/linux-media: (295 commits)
[media] update CARDLIST.em28xx
[media] partially reverts changeset fa5527c
[media] stb0899: fix the limits for signal strength values
[media] em28xx: support for 2304:0242 PCTV QuatroStick (510e)
[media] em28xx: support for 2013:0251 PCTV QuatroStick nano (520e)
[media] -EINVAL -> -ENOTTY
[media] gspca - sn9c20x: Cleanup source
[media] gspca - sn9c20x: Simplify register write for capture start/stop
[media] gspca - sn9c20x: Add automatic JPEG compression mechanism
[media] gspca - sn9c20x: Greater delay in case of sensor no response
[media] gspca - sn9c20x: Optimize the code of write sequences
[media] gspca - sn9c20x: Add the JPEG compression quality control
[media] gspca - sn9c20x: Add a delay after Omnivision sensor reset
[media] gspca - sn9c20x: Propagate USB errors to higher level
[media] gspca - sn9c20x: Use the new video control mechanism
[media] gspca - sn9c20x: Fix loss of frame start
[media] gspca - zc3xx: Lack of register 08 value for sensor cs2102k
[media] gspca - ov534_9: Add brightness to OmniVision 5621 sensor
[media] gspca - zc3xx: Add V4L2_CID_JPEG_COMPRESSION_QUALITY control support
[media] pvrusb2: fix 7MHz & 8MHz DVB-T tuner support for HVR1900 rev D1F5
...
Pull input subsystem updates from Dmitry Torokhov:
"- we finally merged driver for USB version of Synaptics touchpads
(I guess most commonly found in IBM/Lenovo keyboard/touchpad combo);
- a bunch of new drivers for embedded platforms (Cypress
touchscreens, DA9052 OnKey, MAX8997-haptic, Ilitek ILI210x
touchscreens, TI touchscreen);
- input core allows clients to specify desired clock source for
timestamps on input events (EVIOCSCLOCKID ioctl);
- input core allows querying state of all MT slots for given event
code via EVIOCGMTSLOTS ioctl;
- various driver fixes and improvements."
* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/dtor/input: (45 commits)
Input: ili210x - add support for Ilitek ILI210x based touchscreens
Input: altera_ps2 - use of_match_ptr()
Input: synaptics_usb - switch to module_usb_driver()
Input: convert I2C drivers to use module_i2c_driver()
Input: convert SPI drivers to use module_spi_driver()
Input: omap4-keypad - move platform_data to <linux/platform_data>
Input: kxtj9 - who_am_i check value and initial data rate fixes
Input: add driver support for MAX8997-haptic
Input: tegra-kbc - revise device tree support
Input: of_keymap - add device tree bindings for simple key matrices
Input: wacom - fix physical size calculation for 3rd-gen Bamboo
Input: twl4030-vibra - really switch from #if to #ifdef
Input: hp680_ts_input - ensure arguments to request_irq and free_irq are compatible
Input: max8925_onkey - avoid accessing input device too early
Input: max8925_onkey - allow to be used as a wakeup source
Input: atmel-wm97xx - convert to dev_pm_ops
Input: atmel-wm97xx - set driver owner
Input: add cyttsp touchscreen maintainer entry
Input: cyttsp - remove useless checks in cyttsp_probe()
Input: usbtouchscreen - add support for Data Modul EasyTouch TP 72037
...
Adds multitouch support for the Gametel Android game controller.
The multitouch events are emulated by the Gametel device. Each physical button
is configured to generate a MT event on a specific coordinate. This seems to be
the only way for us to support Android games that doesn't support HID gamepads.
It is possible to inject MT events at Android level, but this requires root on
the phone.
Signed-off-by: Andreas Nielsen <eas@svep.se>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
* tag 'v3.3': (1646 commits)
Linux 3.3
Don't limit non-nested epoll paths
netfilter: ctnetlink: fix race between delete and timeout expiration
ipv6: Don't dev_hold(dev) in ip6_mc_find_dev_rcu.
nilfs2: fix NULL pointer dereference in nilfs_load_super_block()
nilfs2: clamp ns_r_segments_percentage to [1, 99]
afs: Remote abort can cause BUG in rxrpc code
afs: Read of file returns EBADMSG
C6X: remove dead code from entry.S
wimax/i2400m: fix erroneous NETDEV_TX_BUSY use
net/hyperv: fix erroneous NETDEV_TX_BUSY use
net/usbnet: reserve headroom on rx skbs
bnx2x: fix memory leak in bnx2x_init_firmware()
bnx2x: fix a crash on corrupt firmware file
sch_sfq: revert dont put new flow at the end of flows
ipv6: fix icmp6_dst_alloc()
MAINTAINERS: Add Serge as maintainer of capabilities
drivers/video/backlight/s6e63m0.c: fix corruption storing gamma mode
MAINTAINERS: add entry for exynos mipi display drivers
MAINTAINERS: fix link to Gustavo Padovans tree
...
Add support for BT-driven configuration of the TiVo remote.
Reported-by: Joshua Dillon <jvdillon@gmail.com>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
This is a list of devices that should be handled by hid-multitouch. They all
present the HID usage "Contact ID" and won't be handled by hid-input. Some of
them have _not_ been tested (though I have their report descriptors), but I've
been guaranted by eeti that they follow the same protocol. The tested ones are
also blacklisted in hid-core.c.
Signed-off-by: Benjamin Tissoires <benjamin.tissoires@enac.fr>
Acked-by: Henrik Rydberg <rydberg@euromail.se>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
Add support for unknown Waltop tablet with product ID 0x0038.
This tablet is sold as Genius G-Pen F509.
Signed-off-by: Nikolai Kondrashov <spbnick@gmail.com>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
This patch (as1531) adds a NOGET quirk for the Slim+ keyboard marketed
by AIREN. This keyboard seems to have a lot of bugs; NOGET works
around only one of them.
Signed-off-by: Alan Stern <stern@rowland.harvard.edu>
Reported-by: okias <d.okias@gmail.com>
CC: <stable@vger.kernel.org>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
The driver currently only supports the PS1000 controller.
It fixes the report descriptor by removing a non-existing axis and
clearing the constant bit on the d-pad and button input reports.
Signed-off-by: Andreas Hübner <andreas@k4n.de>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
Also correct the quirks for the Super Joy Box 3 Pro and Super Dual Box.
Signed-off-by: Sean Young <sean@mess.org>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
CH Fighterstick requires HID_QUIRK_NOGET as many other CH devices do. This
patch adds device id for Fighterstick and adds necessary line to HID quirk
list.
Signed-off-by: Ville Ranki <ville.ranki@iki.fi>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
The Keene FM transmitter USB device has the same USB ID as
the Logitech AudioHub Speaker, but it should ignore the hid.
Check if the name is that of the Keene device.
Signed-off-by: Hans Verkuil <hans.verkuil@cisco.com>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
Add support for Waltop Q Pad by fixing its report descriptor.
This tablet is also sold as Aiptek HyperPen Mini. Other possible names
include: NGS Flexi Style, VisTablet PenPad, iVistaTablet Q Flex Pad, Bravod
Q-PD65-S.
Signed-off-by: Nikolai Kondrashov <spbnick@gmail.com>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
This patch finishes off adding full support for the TiVo Slide remote,
which is a mostly pure HID device from the perspective of the kernel.
There are a few mappings that use a vendor-specific usage page, and a
few keys in the consumer usage page that I think make sense to remap
slightly, to better fit their key labels' intended use. Doing this in a
stand-alone hid-tivo.c makes the modifications only matter for this
specific device.
What's actually connected to the computer is a Broadcom-made usb dongle,
which has an embedded hub, bluetooth adapter, mouse and keyboard
devices. You pair with the dongle, then the remote sends data that its
converted into HID on the keyboard interface (the mouse interface
doesn't do anything interesting, so far as I can tell).
lsusb for this device:
Bus 004 Device 005: ID 0a5c:2190 Broadcom Corp.
Bus 004 Device 004: ID 0a5c:4503 Broadcom Corp.
Bus 004 Device 003: ID 150a:1201
Bus 004 Device 002: ID 0a5c:4500 Broadcom Corp. BCM2046B1 USB 2.0 Hub (part of BCM2046 Bluetooth)
Speaking of the keyboard interface, the remote actually does contain a
keyboard as well. The top slides away, revealing a reasonably functional
qwerty keyboard (not unlike many slide cell phones), thus the product
name.
CC: Jiri Kosina <jkosina@suse.cz>
Signed-off-by: Jarod Wilson <jarod@redhat.com>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
Yuri Khan
Ryan Bourgeois
Linus Torvalds
Jiri Kosina
Andreas Nielsen
Mauro Carvalho Chehab
Dmitry Torokhov
Benjamin Tissoires
Nikolai Kondrashov
Alan Stern
Andreas Hübner
Sean Young
Ville Ranki
Denis Kovalev
Hans Verkuil
Jarod Wilson