Sequentially stopping the CPUs slows down expedited grace periods by
at least a factor of two, based on rcutorture's grace-period-per-second
rate. This is a conservative measure because rcutorture uses unusually
long RCU read-side critical sections and because rcutorture periodically
quiesces the system in order to test RCU's ability to ramp down to and
up from the idle state. This commit therefore replaces the stop_one_cpu()
with stop_one_cpu_nowait(), using an atomic-counter scheme to determine
when all CPUs have passed through the stopped state.
Signed-off-by: Peter Zijlstra <peterz@infradead.org>
Signed-off-by: Paul E. McKenney <paulmck@linux.vnet.ibm.com>
This commit gets rid of synchronize_sched_expedited()'s mutex_trylock()
polling loop in favor of a funnel-locking scheme based on the rcu_node
tree. The work-done check is done at each level of the tree, allowing
high-contention situations to be resolved quickly with reasonable levels
of mutex contention.
Signed-off-by: Paul E. McKenney <paulmck@linux.vnet.ibm.com>
Now that synchronize_sched_expedited() have a mutex, it can use simpler
work-already-done detection scheme. This commit simplifies this scheme
by using something similar to the sequence-locking counter scheme.
A counter is incremented before and after each grace period, so that
the counter is odd in the midst of the grace period and even otherwise.
So if the counter has advanced to the second even number that is
greater than or equal to the snapshot, the required grace period has
already happened.
Signed-off-by: Paul E. McKenney <paulmck@linux.vnet.ibm.com>
The synchronize_sched_expedited() currently invokes try_stop_cpus(),
which schedules the stopper kthreads on each online non-idle CPU,
and waits until all those kthreads are running before letting any
of them stop. This is disastrous for real-time workloads, which
get hit with a preemption that is as long as the longest scheduling
latency on any CPU, including any non-realtime housekeeping CPUs.
This commit therefore switches to using stop_one_cpu() on each CPU
in turn. This avoids inflicting the worst-case scheduling latency
on the worst-case CPU onto all other CPUs, and also simplifies the
code a little bit.
Follow-up commits will simplify the counter-snapshotting algorithm
and convert a number of the counters that are now protected by the
new ->expedited_mutex to non-atomic.
Signed-off-by: Peter Zijlstra <peterz@infradead.org>
[ paulmck: Kept stop_one_cpu(), dropped disabling of "guardrails". ]
Signed-off-by: Paul E. McKenney <paulmck@linux.vnet.ibm.com>
The CONFIG_RCU_CPU_STALL_INFO has been default-y for a couple of
releases with no complaints, so it is time to eliminate this Kconfig
option entirely, so that the long-form RCU CPU stall warnings cannot
be disabled. This commit does just that.
Signed-off-by: Paul E. McKenney <paulmck@linux.vnet.ibm.com>
The fact that tasks could be migrated from leaf to root rcu_node
structures meant that synchronize_rcu_expedited() had to disable
CPU hotplug. However, tasks now stay put, so this commit removes the
CPU-hotplug disabling from synchronize_rcu_expedited().
Signed-off-by: Paul E. McKenney <paulmck@linux.vnet.ibm.com>
Currently if the rcu_fanout_leaf boot parameter is out of bounds (that
is, less than RCU_FANOUT_LEAF or greater than the number of bits in an
unsigned long), a warning is issued and execution continues with the
out-of-bounds value. This can result in all manner of failures, so this
patch resets rcu_fanout_leaf to RCU_FANOUT_LEAF when an out-of-bounds
condition is detected.
Signed-off-by: Paul E. McKenney <paulmck@linux.vnet.ibm.com>
Because gcc does not realize a loop would not be entered ever
(i.e. in case of rcu_num_lvls == 1):
for (i = 1; i < rcu_num_lvls; i++)
rsp->level[i] = rsp->level[i - 1] + levelcnt[i - 1];
some compiler (pre- 5.x?) versions give a bogus warning:
kernel/rcu/tree.c: In function ‘rcu_init_one.isra.55’:
kernel/rcu/tree.c:4108:13: warning: array subscript is above array bounds [-Warray-bounds]
rsp->level[i] = rsp->level[i - 1] + rsp->levelcnt[i - 1];
^
Fix that warning by adding an extra item to rcu_state::level[]
array. Once the bogus warning is fixed in gcc and kernel drops
support of older versions, the dummy item may be removed from
the array.
Cc: "Paul E. McKenney" <paulmck@linux.vnet.ibm.com>
Suggested-by: "Paul E. McKenney" <paulmck@linux.vnet.ibm.com>
Signed-off-by: Alexander Gordeev <agordeev@redhat.com>
Signed-off-by: Paul E. McKenney <paulmck@linux.vnet.ibm.com>
Although a number of RCU levels may be less than the current
maximum of four, some static data associated with each level
are allocated for all four levels. As result, the extra data
never get accessed and just wast memory. This update limits
count of allocated items to the number of used RCU levels.
Cc: "Paul E. McKenney" <paulmck@linux.vnet.ibm.com>
Cc: Steven Rostedt <rostedt@goodmis.org>
Signed-off-by: Alexander Gordeev <agordeev@redhat.com>
Signed-off-by: Paul E. McKenney <paulmck@linux.vnet.ibm.com>
Number of items in rcu_capacity[] array is defined by macro
MAX_RCU_LVLS. However, that array is never accessed beyond
RCU_NUM_LVLS index. Therefore, we can limit the array to
RCU_NUM_LVLS items and eliminate MAX_RCU_LVLS. As result,
in most cases the memory is conserved.
Cc: "Paul E. McKenney" <paulmck@linux.vnet.ibm.com>
Cc: Steven Rostedt <rostedt@goodmis.org>
Signed-off-by: Alexander Gordeev <agordeev@redhat.com>
Signed-off-by: Paul E. McKenney <paulmck@linux.vnet.ibm.com>
Variable rcu_num_lvls is limited by RCU_NUM_LVLS macro.
In turn, rcu_state::levelcnt[] array is never accessed
beyond rcu_num_lvls. Thus, rcu_state::levelcnt[] is safe
to limit to RCU_NUM_LVLS items.
Since rcu_num_lvls could be changed during boot (as result
of rcutree.rcu_fanout_leaf kernel parameter update) one might
assume a new value could overflow the value of RCU_NUM_LVLS.
However, that is not the case, since leaf-level fanout is only
permitted to increase, resulting in rcu_num_lvls possibly to
decrease.
Cc: "Paul E. McKenney" <paulmck@linux.vnet.ibm.com>
Cc: Steven Rostedt <rostedt@goodmis.org>
Signed-off-by: Alexander Gordeev <agordeev@redhat.com>
Signed-off-by: Paul E. McKenney <paulmck@linux.vnet.ibm.com>
Current code suggests that introducing the extra level to
rcu_capacity[] array makes some of the arithmetic easier.
Well, in fact it appears rather confusing and unnecessary.
Cc: "Paul E. McKenney" <paulmck@linux.vnet.ibm.com>
Cc: Steven Rostedt <rostedt@goodmis.org>
Signed-off-by: Alexander Gordeev <agordeev@redhat.com>
Signed-off-by: Paul E. McKenney <paulmck@linux.vnet.ibm.com>
This update simplifies rcu_init_geometry() code flow
and makes calculation of the total number of rcu_node
structures more easy to read.
The update relies on the fact num_rcu_lvl[] is never
accessed beyond rcu_num_lvls index by the rest of the
code. Therefore, there is no need initialize the whole
num_rcu_lvl[].
Cc: "Paul E. McKenney" <paulmck@linux.vnet.ibm.com>
Cc: Steven Rostedt <rostedt@goodmis.org>
Signed-off-by: Alexander Gordeev <agordeev@redhat.com>
Signed-off-by: Paul E. McKenney <paulmck@linux.vnet.ibm.com>
Currently a condition when RCU tree is unable to accommodate
the configured number of CPUs is not permitted and causes
a fall back to compile-time values. However, the code has no
means to exceed the RCU tree capacity neither at compile-time
nor in run-time. Therefore, if the condition is met in run-
time then it indicates a serios problem elsewhere and should
be handled with a panic.
Cc: "Paul E. McKenney" <paulmck@linux.vnet.ibm.com>
Cc: Steven Rostedt <rostedt@goodmis.org>
Signed-off-by: Alexander Gordeev <agordeev@redhat.com>
Signed-off-by: Paul E. McKenney <paulmck@linux.vnet.ibm.com>
Pull more vfs updates from Al Viro:
"Assorted VFS fixes and related cleanups (IMO the most interesting in
that part are f_path-related things and Eric's descriptor-related
stuff). UFS regression fixes (it got broken last cycle). 9P fixes.
fs-cache series, DAX patches, Jan's file_remove_suid() work"
[ I'd say this is much more than "fixes and related cleanups". The
file_table locking rule change by Eric Dumazet is a rather big and
fundamental update even if the patch isn't huge. - Linus ]
* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/viro/vfs: (49 commits)
9p: cope with bogus responses from server in p9_client_{read,write}
p9_client_write(): avoid double p9_free_req()
9p: forgetting to cancel request on interrupted zero-copy RPC
dax: bdev_direct_access() may sleep
block: Add support for DAX reads/writes to block devices
dax: Use copy_from_iter_nocache
dax: Add block size note to documentation
fs/file.c: __fget() and dup2() atomicity rules
fs/file.c: don't acquire files->file_lock in fd_install()
fs:super:get_anon_bdev: fix race condition could cause dev exceed its upper limitation
vfs: avoid creation of inode number 0 in get_next_ino
namei: make set_root_rcu() return void
make simple_positive() public
ufs: use dir_pages instead of ufs_dir_pages()
pagemap.h: move dir_pages() over there
remove the pointless include of lglock.h
fs: cleanup slight list_entry abuse
xfs: Correctly lock inode when removing suid and file capabilities
fs: Call security_ops->inode_killpriv on truncate
fs: Provide function telling whether file_remove_privs() will do anything
...
Pull kvm fixes from Paolo Bonzini:
"Except for the preempt notifiers fix, these are all small bugfixes
that could have been waited for -rc2. Sending them now since I was
taking care of Peter's patch anyway"
* tag 'for-linus' of git://git.kernel.org/pub/scm/virt/kvm/kvm:
kvm: add hyper-v crash msrs values
KVM: x86: remove data variable from kvm_get_msr_common
KVM: s390: virtio-ccw: don't overwrite config space values
KVM: x86: keep track of LVT0 changes under APICv
KVM: x86: properly restore LVT0
KVM: x86: make vapics_in_nmi_mode atomic
sched, preempt_notifier: separate notifier registration from static_key inc/dec
Pull scheduler fixes from Ingo Molnar:
"Debug info and other statistics fixes and related enhancements"
* 'sched-urgent-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/tip:
sched/numa: Fix numa balancing stats in /proc/pid/sched
sched/numa: Show numa_group ID in /proc/sched_debug task listings
sched/debug: Move print_cfs_rq() declaration to kernel/sched/sched.h
sched/stat: Expose /proc/pid/schedstat if CONFIG_SCHED_INFO=y
sched/stat: Simplify the sched_info accounting dependency
Commit 44dba3d5d6 ("sched: Refactor task_struct to use
numa_faults instead of numa_* pointers") modified the way
tsk->numa_faults stats are accounted.
However that commit never touched show_numa_stats() that is displayed
in /proc/pid/sched and thus the numbers displayed in /proc/pid/sched
don't match the actual numbers.
Fix it by making sure that /proc/pid/sched reflects the task
fault numbers. Also add group fault stats too.
Also couple of more modifications are added here:
1. Format changes:
- Previously we would list two entries per node, one for private
and one for shared. Also the home node info was listed in each entry.
- Now preferred node, total_faults and current node are
displayed separately.
- Now there is one entry per node, that lists private,shared task and
group faults.
2. Unit changes:
- p->numa_pages_migrated was getting reset after every read of
/proc/pid/sched. It's more useful to have absolute numbers since
differential migrations between two accesses can be more easily
calculated.
Signed-off-by: Srikar Dronamraju <srikar@linux.vnet.ibm.com>
Acked-by: Rik van Riel <riel@redhat.com>
Cc: Iulia Manda <iulia.manda21@gmail.com>
Cc: Linus Torvalds <torvalds@linux-foundation.org>
Cc: Mel Gorman <mgorman@suse.de>
Cc: Peter Zijlstra <peterz@infradead.org>
Cc: Thomas Gleixner <tglx@linutronix.de>
Link: http://lkml.kernel.org/r/1435252903-1081-4-git-send-email-srikar@linux.vnet.ibm.com
Signed-off-by: Ingo Molnar <mingo@kernel.org>
Peter Zijlstra
Paul E. McKenney
Alexander Gordeev
Linus Torvalds
Srikar Dronamraju
Naveen N. Rao