I accidentally caused some compiler warnings, that were correct in
pointing out problems, so fix them up now.
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
dbg() was a very old USB-serial-specific macro.
This patch removes it from being used in the keyspan
driver and uses dev_dbg() instead.
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Pull networking fixes from David Miller:
1) Use after free and new device IDs in bluetooth from Andre Guedes,
Yevgeniy Melnichuk, Gustavo Padovan, and Henrik Rydberg.
2) Fix crashes with short packet lengths and VLAN in pktgen, from
Nishank Trivedi.
3) mISDN calls flush_work_sync() with locks held, fix from Karsten
Keil.
4) Packet scheduler gred parameters are reported to userspace
improperly scaled, and WRED idling is not performed correctly. All
from David Ward.
5) Fix TCP socket refcount problem in ipv6, from Julian Anastasov.
6) ibmveth device has RX queue alignment requirements which are not
being explicitly met resulting in sporadic failures, fix from
Santiago Leon.
7) Netfilter needs to take care when interpreting sockets attached to
socket buffers, they could be time-wait minisockets. Fix from Eric
Dumazet.
8) sock_edemux() has the same issue as netfilter did in #7 above, fix
from Eric Dumazet.
9) Avoid infinite loops in CBQ scheduler with some configurations, from
Eric Dumazet.
10) Deal with "Reflection scan: an Off-Path Attack on TCP", from Jozsef
Kadlecsik.
11) SCTP overcharges socket for TX packets, fix from Thomas Graf.
12) CODEL packet scheduler should not reset it's state every time it
builds a new flow, fix from Eric Dumazet.
13) Fix memory leak in nl80211, from Wei Yongjun.
14) NETROM doesn't check skb_copy_datagram_iovec() return values, from
Alan Cox.
15) l2tp ethernet was using sizeof(ETH_HLEN) instead of plain ETH_HLEN,
oops. From Eric Dumazet.
16) Fix selection of ath9k chips on which PA linearization and AM2PM
predistoration are used, from Felix Fietkau.
17) Flow steering settings in mlx4 driver need to be validated properly,
from Hadar Hen Zion.
18) bnx2x doesn't show the correct link duplex setting, from Yaniv
Rosner.
* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net: (75 commits)
pktgen: fix crash with vlan and packet size less than 46
bnx2x: Add missing afex code
bnx2x: fix registers dumped
bnx2x: correct advertisement of pause capabilities
bnx2x: display the correct duplex value
bnx2x: prevent timeouts when using PFC
bnx2x: fix stats copying logic
bnx2x: Avoid sending multiple statistics queries
net: qmi_wwan: call subdriver with control intf only
net_sched: gred: actually perform idling in WRED mode
net_sched: gred: fix qave reporting via netlink
net_sched: gred: eliminate redundant DP prio comparisons
net_sched: gred: correct comment about qavg calculation in RIO mode
mISDN: Fix wrong usage of flush_work_sync while holding locks
netfilter: log: Fix log-level processing
net-sched: sch_cbq: avoid infinite loop
net: qmi_wwan: fix Gobi device probing for un2430
net: fix net/core/sock.c build error
ixp4xx_hss: fix build failure due to missing linux/module.h inclusion
caif: move the dereference below the NULL test
...
Pull USB patches from Greg Kroah-Hartman:
"Here are a number of USB patches, a bit more than I normally like this
late in the -rc series, but given people's vacations (myself
included), and the kernel summit, it seems to have happened this way.
All are tiny, but they add up. A number of gadget and xhci fixes, and
a few new device ids. All have been tested in linux-next.
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>"
* tag 'usb-3.6-rc6' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/usb: (33 commits)
usb: chipidea: udc: don't stall endpoint if request list is empty in isr_tr_complete_low
usb: chipidea: cleanup dma_pool if udc_start() fails
usb: chipidea: udc: fix error path in udc_start()
usb: chipidea: udc: add pullup fuction, needed by the uvc gadget
usb: chipidea: udc: fix setup of endpoint maxpacket size
USB: option: replace ZTE K5006-Z entry with vendor class rule
EHCI: Update qTD next pointer in QH overlay region during unlink
USB: cdc-wdm: fix wdm_find_device* return value
USB: ftdi_sio: do not claim CDC ACM function
usb: dwc3: gadget: fix pending isoc handling
usb: renesas_usbhs: fixup DMA transport data alignment
usb: gadget: at91udc: Don't check for ep->ep.desc
usb: gadget: at91udc: don't overwrite driver data
usb: dwc3: core: fix incorrect usage of resource pointer
usb: musb: musbhsdma: fix IRQ check
usb: musb: tusb6010: fix error path in tusb_probe()
usb: musb: host: fix for musb_start_urb Oops
usb: gadget: dummy_hcd: add support for USB_DT_BOS on rh
usb: gadget: dummy_hcd: fixup error probe path
usb: gadget: s3c-hsotg.c: fix error return code
...
Pull TTY fixes from Greg Kroah-Hartman:
"Here are 2 tiny patches for a serial driver to resolve issues that
people have reported with the 3.6-rc tree.
Both of these have been in the linux-next tree for a while now.
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>"
* tag 'tty-3.6-rc6' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/tty:
tty: serial: imx: don't reinit clock in imx_setup_ufcr()
tty: serial: imx: console write routing is unsafe on SMP
Pull staging tree fixes from Greg Kroah-Hartman:
"Here are a few staging tree fixes for problems that have been
reported.
Nothing major, just a number of tiny driver fixes. All of these have
been in the linux-next tree for a while.
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>"
* tag 'staging-3.6-rc6' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/staging:
drm/omap: add more new timings fields
drm/omap: update for interlaced
staging: r8712u: fix bug in r8712_recv_indicatepkt()
staging: zcache: fix cleancache race condition with shrinker
Staging: Android alarm: IOCTL command encoding fix
staging: vt6656: [BUG] - Failed connection, incorrect endian.
staging: ozwpan: fix memcmp() test in oz_set_active_pd()
staging: wlan-ng: Fix problem with wrong arguments
staging: comedi: das08: Correct AO output for das08jr-16-ao
staging: comedi: das08: Correct AI encoding for das08jr-16-ao
staging: comedi: das08: Fix PCI ref count
staging: comedi: amplc_pci230: Fix PCI ref count
staging: comedi: amplc_pc263: Fix PCI ref count
staging: comedi: amplc_pc236: Fix PCI ref count
staging: comedi: amplc_dio200: Fix PCI ref count
staging: comedi: amplc_pci224: Fix PCI ref count
drivers/iio/adc/at91_adc.c: adjust inconsistent IS_ERR and PTR_ERR
staging iio: fix potential memory leak in lis3l02dq_ring.c
staging:iio: prevent divide by zero bugs
Pull driver core fix from Greg Kroah-Hartman:
"Here is one fix for 3.6-rc6 for the kobject.h file.
It fixes a reported oops if CONFIG_HOTPLUG is disabled. It's been in
the linux-next tree for a while now.
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>"
* tag 'driver-core-3.6-rc6' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/driver-core:
kobject: fix oops with "input0: bad kobj_uevent_env content in show_uevent()"
We already use them for openat() and friends, but fstat() also wants to
be able to use O_PATH file descriptors. This should make it more
directly comparable to the O_SEARCH of Solaris.
Note that you could already do the same thing with "fstatat()" and an
empty path, but just doing "fstat()" directly is simpler and faster, so
there is no reason not to just allow it directly.
See also commit 332a2e1244, which did the same thing for fchdir, for
the same reasons.
Reported-by: ольга крыжановская <olga.kryzhanovska@gmail.com>
Cc: Al Viro <viro@zeniv.linux.org.uk>
Cc: stable@kernel.org # O_PATH introduced in 3.0+
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
Now that the dbg() macro is no longer being used in the driver,
the debug module parameter doesn't do anything at all. So remove
it so as to not confuse people.
CC: Bill Pemberton <wfp5p@virginia.edu>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Now that the dbg() macro is no longer being used in the driver,
the debug module parameter doesn't do anything at all. So remove
it so as to not confuse people.
CC: Matthias Urlichs <smurf@smurf.noris.de>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Now that the dbg() macro is no longer being used in the driver,
the debug module parameter doesn't do anything at all. So remove
it so as to not confuse people.
CC: Aleksey Babahin <tamerlan311@gmail.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Now that the dbg() macro is no longer being used in the driver,
the debug module parameter doesn't do anything at all. So remove
it so as to not confuse people.
CC: Oliver Neukum <oliver@neukum.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Now that the dbg() macro is no longer being used in the driver,
the debug module parameter doesn't do anything at all. So remove
it so as to not confuse people.
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Greg Kroah-Hartman
Linus Torvalds