Both call sites for __flush_dcache_page() end up calling
__flush_icache_all() themselves, so having __flush_dcache_page() do
this as well is wasteful. Remove the duplicated icache flushing.
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
The naming of the defines suggests that there are three IISv4 ports
with one data line each when in fact there is a single IISv4 port
with three data lines.
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
Signed-off-by: Ben Dooks <ben-linux@fluff.org>
If running in non-secure mode accessing
some registers of l2x0 will fault. So
check if l2x0 is already enabled, if so
do not access those secure registers.
Signed-off-by: srinidhi kasagar <srinidhi.kasagar@stericsson.com>
Acked-by: Catalin Marinas <catalin.marinas@arm.com>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
removed old macro definition for io access, using
the generic macros defined in asm/io.h
Signed-off-by: Leo Hao Chen <leochen@broadcom.com>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
The x86 lapic nmi watchdog does not recognize AMD Family 11h,
resulting in:
NMI watchdog: CPU not supported
As far as I can see from available documentation (the BKDM),
family 11h looks identical to family 10h as far as the PMU
is concerned.
Extending the check to accept family 11h results in:
Testing NMI watchdog ... OK.
I've been running with this change on a Turion X2 Ultra ZM-82
laptop for a couple of weeks now without problems.
Signed-off-by: Mikael Pettersson <mikpe@it.uu.se>
Cc: Andreas Herrmann <andreas.herrmann3@amd.com>
Cc: Joerg Roedel <joerg.roedel@amd.com>
Cc: <stable@kernel.org>
LKML-Reference: <19223.53436.931768.278021@pilspetsen.it.uu.se>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
On a multi-node x3950M2 system, there's a slight oddity in the
PCI device tree for all secondary nodes:
30:1e.0 PCI bridge: Intel Corporation 82801 PCI Bridge (rev e1)
\-33:00.0 PCI bridge: IBM CalIOC2 PCI-E Root Port (rev 01)
\-34:00.0 RAID bus controller: LSI Logic / Symbios Logic MegaRAID SAS 1078 (rev 04)
...as compared to the primary node:
00:1e.0 PCI bridge: Intel Corporation 82801 PCI Bridge (rev e1)
\-01:00.0 VGA compatible controller: ATI Technologies Inc ES1000 (rev 02)
03:00.0 PCI bridge: IBM CalIOC2 PCI-E Root Port (rev 01)
\-04:00.0 RAID bus controller: LSI Logic / Symbios Logic MegaRAID SAS 1078 (rev 04)
In both nodes, the LSI RAID controller hangs off a CalIOC2
device, but on the secondary nodes, the BIOS hides the VGA
device and substitutes the device tree ending with the disk
controller.
It would seem that Calgary devices don't necessarily appear at
the top of the PCI tree, which means that the current code to
find the Calgary IOMMU that goes with a particular device is
buggy.
Rather than walk all the way to the top of the PCI
device tree and try to match bus number with Calgary descriptor,
the code needs to examine each parent of the particular device;
if it encounters a Calgary with a matching bus number, simply
use that.
Otherwise, we BUG() when the bus number of the Calgary doesn't
match the bus number of whatever's at the top of the device tree.
Extra note: This patch appears to work correctly for the x3950
that came before the x3950 M2.
Signed-off-by: Darrick J. Wong <djwong@us.ibm.com>
Acked-by: Muli Ben-Yehuda <muli@il.ibm.com>
Cc: FUJITA Tomonori <fujita.tomonori@lab.ntt.co.jp>
Cc: Joerg Roedel <joerg.roedel@amd.com>
Cc: Yinghai Lu <yhlu.kernel@gmail.com>
Cc: Jon D. Mason <jdmason@kudzu.us>
Cc: Corinna Schultz <coschult@us.ibm.com>
Cc: <stable@kernel.org>
LKML-Reference: <20091202230556.GG10295@tux1.beaverton.ibm.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
update_transition_efer() masks out some efer bits when deciding whether
to switch the msr during guest entry; for example, NX is emulated using the
mmu so we don't need to disable it, and LMA/LME are handled by the hardware.
However, with shared msrs, the comparison is made against a stale value;
at the time of the guest switch we may be running with another guest's efer.
Fix by deferring the mask/compare to the actual point of guest entry.
Noted by Marcelo.
Signed-off-by: Avi Kivity <avi@redhat.com>
This patch corrects the checking of the new address for the prefix register.
On s390, the prefix register is used to address the cpu's lowcore (address
0...8k). This check is supposed to verify that the memory is readable and
present.
copy_from_guest is a helper function, that can be used to read from guest
memory. It applies prefixing, adds the start address of the guest memory in
user, and then calls copy_from_user. Previous code was obviously broken for
two reasons:
- prefixing should not be applied here. The current prefix register is
going to be updated soon, and the address we're looking for will be
0..8k after we've updated the register
- we're adding the guest origin (gmsor) twice: once in subject code
and once in copy_from_guest
With kuli, we did not hit this problem because (a) we were lucky with
previous prefix register content, and (b) our guest memory was mmaped
very low into user address space.
Cc: stable@kernel.org
Signed-off-by: Carsten Otte <cotte@de.ibm.com>
Reported-by: Alexander Graf <agraf@suse.de>
Signed-off-by: Avi Kivity <avi@redhat.com>
This way, we don't leave a dangling notifier on cpu hotunplug or module
unload. In particular, module unload leaves the notifier pointing into
freed memory.
Signed-off-by: Avi Kivity <avi@redhat.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
Otherwise would cause VMEntry failure when using ept=0 on unrestricted guest
supported processors.
Signed-off-by: Sheng Yang <sheng@linux.intel.com>
Signed-off-by: Marcelo Tosatti <mtosatti@redhat.com>
While we are never normally passed an instruction that exceeds 15 bytes,
smp games can cause us to attempt to interpret one, which will cause
large latencies in non-preempt hosts.
Cc: stable@kernel.org
Signed-off-by: Avi Kivity <avi@redhat.com>
This patch moves s390 processor status word into the base kvm_run
struct and keeps it up-to date on all userspace exits.
The userspace ABI is broken by this, however there are no applications
in the wild using this. A capability check is provided so users can
verify the updated API exists.
Cc: stable@kernel.org
Signed-off-by: Carsten Otte <cotte@de.ibm.com>
Signed-off-by: Avi Kivity <avi@redhat.com>
This new IOCTL exports all yet user-invisible states related to
exceptions, interrupts, and NMIs. Together with appropriate user space
changes, this fixes sporadic problems of vmsave/restore, live migration
and system reset.
[avi: future-proof abi by adding a flags field]
Signed-off-by: Jan Kiszka <jan.kiszka@siemens.com>
Signed-off-by: Avi Kivity <avi@redhat.com>
These happen when we trap an exception when another exception is being
delivered; we only expect these with MCEs and page faults. If something
unexpected happens, things probably went south and we're better off reporting
an internal error and freezing.
Signed-off-by: Avi Kivity <avi@redhat.com>
Usually userspace will freeze the guest so we can inspect it, but some
internal state is not available. Add extra data to internal error
reporting so we can expose it to the debugger. Extra data is specific
to the suberror.
Signed-off-by: Avi Kivity <avi@redhat.com>
Russell King
Robert Schwebel
Mark Brown
Ben Dooks
Srinidhi Kasagar
Leo Chen
Ingo Molnar
Mikael Pettersson
Jens Axboe
Darrick J. Wong
Avi Kivity
Carsten Otte
Sheng Yang
Jan Kiszka