x86 idle: remove mwait_idle() and "idle=mwait" cmdline param

mwait_idle() is a C1-only idle loop intended to be more efficient
than HLT, starting on Pentium-4 HT-enabled processors.

But mwait_idle() has been replaced by the more general
mwait_idle_with_hints(), which handles both C1 and deeper C-states.
ACPI processor_idle and intel_idle use only mwait_idle_with_hints(),
and no longer use mwait_idle().

Here we simplify the x86 native idle code by removing mwait_idle(),
and the "idle=mwait" bootparam used to invoke it.

Since Linux 3.0 there has been a boot-time warning when "idle=mwait"
was invoked saying it would be removed in 2012.  This removal
was also noted in the (now removed:-) feature-removal-schedule.txt.

After this change, kernels configured with
(CONFIG_ACPI=n && CONFIG_INTEL_IDLE=n) when run on hardware
that supports MWAIT will simply use HLT.  If MWAIT is desired
on those systems, cpuidle and the cpuidle drivers above
can be enabled.

Signed-off-by: Len Brown <len.brown@intel.com>
Cc: x86@kernel.org

Documentation/kernel-parameters.txt

@@ -1039,16 +1039,11 @@ bytes respectively. Such letter suffixes can also be entirely omitted.
 			Claim all unknown PCI IDE storage controllers.
 
 	idle=		[X86]
-			Format: idle=poll, idle=mwait, idle=halt, idle=nomwait
+			Format: idle=poll, idle=halt, idle=nomwait
 			Poll forces a polling idle loop that can slightly
 			improve the performance of waking up a idle CPU, but
 			will use a lot of power and make the system run hot.
 			Not recommended.
-			idle=mwait: On systems which support MONITOR/MWAIT but
-			the kernel chose to not use it because it doesn't save
-			as much power as a normal idle loop, use the
-			MONITOR/MWAIT idle loop anyways. Performance should be
-			the same as idle=poll.
 			idle=halt: Halt is forced to be used for CPU idle.
 			In such case C2/C3 won't be used again.
 			idle=nomwait: Disable mwait for CPU C-states