Merge master.kernel.org:/pub/scm/linux/kernel/git/gregkh/usb-2.6

include/linux/usb.h

@@ -5,6 +5,7 @@
 #include <linux/usb_ch9.h>
 
 #define USB_MAJOR			180
+#define USB_DEVICE_MAJOR		189
 
 
 #ifdef __KERNEL__
@@ -349,6 +350,7 @@ struct usb_device {
 	char *manufacturer;
 	char *serial;			/* static strings from the device */
 	struct list_head filelist;
+	struct class_device *class_dev;
 	struct dentry *usbfs_dentry;	/* usbfs dentry entry for the device */
 
 	/*
@@ -614,7 +616,6 @@ extern int usb_disabled(void);
 #define URB_ISO_ASAP		0x0002	/* iso-only, urb->start_frame ignored */
 #define URB_NO_TRANSFER_DMA_MAP	0x0004	/* urb->transfer_dma valid on submit */
 #define URB_NO_SETUP_DMA_MAP	0x0008	/* urb->setup_dma valid on submit */
-#define URB_ASYNC_UNLINK	0x0010	/* usb_unlink_urb() returns asap */
 #define URB_NO_FSBR		0x0020	/* UHCI-specific */
 #define URB_ZERO_PACKET		0x0040	/* Finish bulk OUTs with short packet */
 #define URB_NO_INTERRUPT	0x0080	/* HINT: no non-error interrupt needed */
@@ -722,13 +723,7 @@ typedef void (*usb_complete_t)(struct urb *, struct pt_regs *);
  * Initialization:
  *
  * All URBs submitted must initialize the dev, pipe, transfer_flags (may be
- * zero), and complete fields.
- * The URB_ASYNC_UNLINK transfer flag affects later invocations of
- * the usb_unlink_urb() routine.  Note: Failure to set URB_ASYNC_UNLINK
- * with usb_unlink_urb() is deprecated.  For synchronous unlinks use
- * usb_kill_urb() instead.
- *
- * All URBs must also initialize 
+ * zero), and complete fields.  All URBs must also initialize
  * transfer_buffer and transfer_buffer_length.  They may provide the
  * URB_SHORT_NOT_OK transfer flag, indicating that short reads are
  * to be treated as errors; that flag is invalid for write requests.

include/linux/usb_isp116x.h

@@ -7,36 +7,18 @@
 struct isp116x_platform_data {
 	/* Enable internal resistors on downstream ports */
 	unsigned sel15Kres:1;
-	/* Chip's internal clock won't be stopped in suspended state.
-	   Setting/unsetting this bit takes effect only if
-	   'remote_wakeup_enable' below is not set. */
-	unsigned clknotstop:1;
-	/* On-chip overcurrent protection */
+	/* On-chip overcurrent detection */
 	unsigned oc_enable:1;
 	/* INT output polarity */
 	unsigned int_act_high:1;
 	/* INT edge or level triggered */
 	unsigned int_edge_triggered:1;
-	/* WAKEUP pin connected - NOT SUPPORTED  */
-	/* unsigned remote_wakeup_connected:1; */
-	/* Wakeup by devices on usb bus enabled */
+	/* Enable wakeup by devices on usb bus (e.g. wakeup
+	   by attachment/detachment or by device activity
+	   such as moving a mouse). When chosen, this option
+	   prevents stopping internal clock, increasing
+	   thereby power consumption in suspended state. */
 	unsigned remote_wakeup_enable:1;
-	/* Switch or not to switch (keep always powered) */
-	unsigned no_power_switching:1;
-	/* Ganged port power switching (0) or individual port
-	   power switching (1) */
-	unsigned power_switching_mode:1;
-	/* Given port_power, msec/2 after power on till power good */
-	u8 potpg;
-	/* Hardware reset set/clear. If implemented, this function must:
-	   if set == 0,   deassert chip's HW reset pin
-	   otherwise,     assert chip's HW reset pin       */
-	void (*reset) (struct device * dev, int set);
-	/* Hardware clock start/stop. If implemented, this function must:
-	   if start == 0,    stop the external clock
-	   otherwise,        start the external clock
-	 */
-	void (*clock) (struct device * dev, int start);
 	/* Inter-io delay (ns). The chip is picky about access timings; it
 	   expects at least:
 	   150ns delay between consecutive accesses to DATA_REG,