Add c2 port support

C2port implements a two wire serial communication protocol (bit
banging) designed to enable in-system programming, debugging, and
boundary-scan testing on low pin-count Silicon Labs devices.

Currently this code supports only flash programming through sysfs
interface but extensions shoud be easy to add.

Signed-off-by: Rodolfo Giometti <giometti@linux.it>
Cc: Greg KH <greg@kroah.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

drivers/misc/c2port/Kconfig

@@ -0,0 +1,24 @@
+#
+# C2 port devices
+#
+
+menuconfig C2PORT
+	tristate "Silicon Labs C2 port support (EXPERIMENTAL)"
+	depends on EXPERIMENTAL
+	default no
+	help
+	  This option enables support for Silicon Labs C2 port used to
+	  program Silicon micro controller chips (and other 8051 compatible).
+
+	  If your board have no such micro controllers you don't need this
+	  interface at all.
+
+	  To compile this driver as a module, choose M here: the module will
+	  be called c2port_core. Note that you also need a client module
+	  usually called c2port-*.
+
+	  If you are not sure, say N here.
+
+if C2PORT
+
+endif # C2PORT

drivers/misc/c2port/Makefile

@@ -0,0 +1 @@
+obj-$(CONFIG_C2PORT)		+= core.o