mfd: Add support for Diolan DLN-2 devices

This patch implements the USB part of the Diolan USB-I2C/SPI/GPIO
Master Adapter DLN-2. Details about the device can be found here:

https://www.diolan.com/i2c/i2c_interface.html.

Information about the USB protocol can be found in the Programmer's
Reference Manual [1], see section 1.7.

Because the hardware has a single transmit endpoint and a single
receive endpoint the communication between the various DLN2 drivers
and the hardware will be muxed/demuxed by this driver.

Each DLN2 module will be identified by the handle field within the DLN2
message header. If a DLN2 module issues multiple commands in parallel
they will be identified by the echo counter field in the message header.

The DLN2 modules can use the dln2_transfer() function to issue a
command and wait for its response. They can also register a callback
that is going to be called when a specific event id is generated by
the device (e.g. GPIO interrupts). The device uses handle 0 for
sending events.

[1] https://www.diolan.com/downloads/dln-api-manual.pdf

Signed-off-by: Octavian Purdila <octavian.purdila@intel.com>
Reviewed-by: Johan Hovold <johan@kernel.org>
Signed-off-by: Lee Jones <lee.jones@linaro.org>

drivers/mfd/Kconfig

@@ -183,6 +183,16 @@ config MFD_DA9063
 	  Additional drivers must be enabled in order to use the functionality
 	  of the device.
 
+config MFD_DLN2
+	tristate "Diolan DLN2 support"
+	select MFD_CORE
+	depends on USB
+	help
+	  This adds support for Diolan USB-I2C/SPI/GPIO Master Adapter
+	  DLN-2. Additional drivers such as I2C_DLN2, GPIO_DLN2,
+	  etc. must be enabled in order to use the functionality of
+	  the device.
+
 config MFD_MC13XXX
 	tristate
 	depends on (SPI_MASTER || I2C)