blk-mq: unify hctx delay_work and run_work

The only difference between ->run_work and ->delay_work, is that
the latter is used to defer running a queue. This is done by
marking the queue stopped, and scheduling ->delay_work to run
sometime in the future. While the queue is stopped, direct runs
or runs through ->run_work will not run the queue.

If we combine the handlers, then we need to handle two things:

1) If a delayed/stopped run is scheduled, then we should not run
   the queue before that has been completed.
2) If a queue is delayed/stopped, the handler needs to restart
   the queue. Normally a run of a queue with the stopped bit set
   would be a no-op.

Case 1 is handled by modifying a currently pending queue run
to the deadline set by the caller of blk_mq_delay_queue().
Subsequent attempts to queue a queue run will find the work
item already pending, and direct runs will see a stopped queue
as before.

Case 2 is handled by adding a new bit, BLK_MQ_S_START_ON_RUN,
that tells the work handler that it should clear a stopped
queue and run the handler.

Reviewed-by: Bart Van Assche <Bart.VanAssche@sandisk.com>
Signed-off-by: Jens Axboe <axboe@fb.com>

block/blk-core.c

@@ -268,10 +268,8 @@ void blk_sync_queue(struct request_queue *q)
 		struct blk_mq_hw_ctx *hctx;
 		int i;
 
-		queue_for_each_hw_ctx(q, hctx, i) {
+		queue_for_each_hw_ctx(q, hctx, i)
 			cancel_delayed_work_sync(&hctx->run_work);
-			cancel_delayed_work_sync(&hctx->delay_work);
-		}
 	} else {
 		cancel_delayed_work_sync(&q->delay_work);
 	}